- 您現在的位置：買賣IC網 > PDF目錄382678 > TPS5103IDBR SMPS Controller PDF資料下載
參數資料
| 型號： | TPS5103IDBR |
| 英文描述： | SMPS Controller |
| 中文描述： | 開關電源控制器 |
| 文件頁數： | 5/31頁 |
| 文件大?。?/td> | 1083K |
| 代理商： | TPS5103IDBR |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁
TPS5102
DUAL, HIGH-EFFICIENCY CONTROLLER FOR NOTEBOOK PC POWER
SLVS239 - SEPTEMBER 1999
5
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
detailed description (continued)
current protection
Current protection is achieved by sensing the high-side power MOSFET drain-to-source voltage drop during
on-time at VCC_CNTP and LL. An external resistor between Vin and TRIP pin in serial with the internal current
source adjusts the current limit. When the voltage drop during the on-time is high enough, the current
comparator triggers the current protection and the circuit is reset. The reset repeats until the over-current
condition is removed.
COMP
COMP is an internal comparator used for any voltage protection such as the output under-voltage protection
for notebook power applications. If the core voltage is lower than the setpoint, the comparator turns off both
channels to prevent the notebook from damage.
SOFT1, SOFT2
Separate softstart terminals make it possible to set the start-up time of each output for any possibility.
STBY1, STBY2
Both channels can be switched into standby mode separately by grounding the STBY pin. The standby current
is as low as 1
μ
A.
ULVO
When the input voltage goes up to about 4 V, the IC is turned on, ready to function. When the input voltage is
lower than the turn-on value, the IC is turned off. The typical hysteresis is 40 mV.
Powered by ICminer.com Electronic-Library Service CopyRight 2003
相關PDF資料 |
PDF描述 |
|---|---|
| TPS5210DWR | Voltage-Mode SMPS Controller |
| TPS5210PWPR | Voltage-Mode SMPS Controller |
| TPS5211PWPR | Analog IC |
| TPS524 | PHOTOVOLTAIC CELL FOR THERMOPILE DETECTION |
| TPS5300DAP | Analog IC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS5103IDBRG4 | 功能描述:DC/DC 開關控制器 Synch Buck Cntrlr RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| TPS5110 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:3-A SINK/ SOURCE DDR TERMINATION REGULATOR |
| TPS51100 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:3-A SINK/SOURCE DDR TERMINATION REGULATOR |
| TPS51100_07 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:3-A SINK/SOURCE DDR TERMINATION REGULATOR |
| TPS51100DGQ | 功能描述:低壓差穩壓器 - LDO 3A Source/Sink DDR Terminator Regulator RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
發布緊急采購，3分鐘左右您將得到回復。