參數資料
型號: TPS40075RHLR
廠商: TEXAS INSTRUMENTS INC
元件分類: 穩壓器
英文描述: 2 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PQCC20
封裝: PLASTIC, QFN-20
文件頁數: 22/44頁
文件大?。?/td> 806K
代理商: TPS40075RHLR
www.ti.com
R
KFF +
V
UVLO(on) * 0.5
0.018 )
5
R
T
(34)
t
START w 2p
L
C
O
(35)
C
SS w
12
10*6
0.7
t
START
(36)
I
SCP w
C
O
V
OUT
t
START
) ILOAD
DI
2
(37)
R
ILIM w
I
SCP
R
DS(on)MAX ) VILIM(min)
I
SINK(max)
(38)
I
SCP(min) +
I
SINK(min)
R
ILIM(min) * VILIM(max)
R
DS(on)MIN
(39)
I
SCP(max) +
I
SINK(max)
R
ILIM(max) * VILIM(min)
R
DS(on)MAX
(40)
C
ILIM(max) +
V
O
0.2
V
IN
R
ILIM
f
SW
(41)
SLUS676A – MAY 2006 – REVISED SEPTEMBER 2007
This equation gives a RKFF value of 136 k. The closest lower standard value should be selected. For this design
and using E24 resistor range 133 k
was chosen. This yields a typical start voltage of 8.52 V.
3.2.3 Soft Start Capacitor
It is good practice to limit the rise time of the output voltage. This helps prevent output overshoot and possible
damage to the load. The selection of the soft start time is arbitrary, but it must meet one condition; it should be
greater than the time constant of the output filter, L and CO. This time is given by Equation 35
The soft-start time must be greater than 0.281 ms. A time of 1 ms was chosen, this time also helps keep the
initial input current during start up low. The value of CSS can be calculated using Equation 36.
CSS should be greater than 17 nF, a 22 nF MLCC was chosen. The calculated start time using this capacitor is
1.28 ms.
3.2.4 Short Circuit Protection, RILIM and CILIM
Short circuit protection is programmed using the RILIM resistor. Selection of this resistor depends on the RDS(on) of
the switching MOSFET selected and the required short circuit current trip point, ISCP. The minimum ISCP is limited
by the inductor peak current, the output voltage, the output capacitor and the soft start time. Their relationship is
given by Equation 37. A short circuit current trip point greater than that calculated by this equation should be
used.
The minimum short circuit current trip point for this design is 16.35 A. This value is used in Equation 38 to
calculate the minimum RILIM value.
RILIM is calculated to be 1.14 k . The closest standard value greater than 1.14 k is chose, this is 1.15 k. To
verify that the short circuit current requirements are met the minimum and maximum short circuit current can be
calculated using Equation 39 and Equation 40.
The minimum ISCP is 17.09 A and the maximum is 29.45 A.
It is recommended to add a small capacitor, CILIM, across RILIM. The value of this capacitor should be less than
that calculated in Equation 41.
This equation yields a maximum CILIM of 44 pF. A value half this is chosen, 22 pF.
Copyright 2006–2007, Texas Instruments Incorporated
29
Product Folder Link(s) :TPS40075
相關PDF資料
PDF描述
TPS40075RHLTG4 2 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PQCC20
TPS40077PWPR 2 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
TPS40077PWPRG4 2 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
TPS40077PWPG4 2 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
TPS40090QPWRQ1 SWITCHING CONTROLLER, 1200 kHz SWITCHING FREQ-MAX, PDSO24
相關代理商/技術參數
參數描述
TPS40075RHLRG4 功能描述:DC/DC 開關控制器 Wide Input Synch Buck Controller RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
TPS40075RHLT 功能描述:DC/DC 開關控制器 Wide Input Synch Buck Controller RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
TPS40075RHLTG4 功能描述:DC/DC 開關控制器 Wide Input Synch Buck Controller RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
TPS40077 制造商:TI 制造商全稱:Texas Instruments 功能描述:HIGH-EFFICIENCY, MIDRANGE-INPUT, SYNCHRONOUS BUCK CONTROLLER WITH VOLTAGE FEED-FORWARD
TPS40077_07 制造商:TI 制造商全稱:Texas Instruments 功能描述:HIGH-EFFICIENCY, MIDRANGE-INPUT, SYNCHRONOUS BUCK CONTROLLER WITH VOLTAGE FEED-FORWARD