- 您現在的位置：買賣IC網 > PDF目錄98281 > TPS40007DGQRG4 (TEXAS INSTRUMENTS INC) SWITCHING CONTROLLER, 350 kHz SWITCHING FREQ-MAX, PDSO10 PDF資料下載
參數資料
| 型號： | TPS40007DGQRG4 |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING CONTROLLER, 350 kHz SWITCHING FREQ-MAX, PDSO10 |
| 封裝： | 3.05 X 4.98 MM, GREEN, PLASTIC, MSOP-10 |
| 文件頁數： | 24/28頁 |
| 文件大?。?/td> | 677K |
| 代理商： | TPS40007DGQRG4 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁當前第24頁第25頁第26頁第27頁第28頁
TPS40007
TPS40009
SLUS589B NOVEMBER 2003 REVISED FEBRUARY 2005
5
www.ti.com
Terminal Functions
TERMINAL
I/O
DESCRIPTION
NAME
NO.
I/O
DESCRIPTION
BOOT
10
O
Provides a bootstrapped supply for the topside MOSFET driver, enabling the gate of the topside
MOSFET to be driven above the input supply rail
COMP
3
O
Output of the error amplifier
FB
2
I
Inverting input of the error amplifier. In normal operation the voltage at this pin is the internal reference level of 700 mV.
GND
5
Power supply return for the device. The power stage ground return on the board requires a separate path from other
sensitive signal ground returns.
HDRV
9
O
This is the gate drive output for the topside N-channel MOSFET. HDRV is bootstrapped to near 2
× VDD for good en-
hancement of the topside MOSFET.
ILIM
1
I
A resistor is connected between this pin and VDD to set up the over current threshold voltage. A 15-
A current sink at
the pin establishes a voltage drop across the external resistor that represents the drain-to-source voltage across the
top side N-channel MOSFET during an over current condition. The ILIM over current comparator is blanked for the
first 100 ns to allow full enhancement of the top MOSFET. Set the ILIM voltage level such that it is within 800 mV of
VDD; that is, (VDD 0.8) ≤ IILIM ≤ VDD.
LDRV
6
O
Gate drive output for the low-side synchronous rectifier N-channel MOSFET
SS/SD
4
I
Soft-start and overcurrent fault shutdown times are set by charging and discharging a capacitor connected to this pin.
A closed loop soft-start occurs when the internal 3-
A current source charges the external capacitor. There is a 0.65-V
offset between external SS pin and internal soft-start voltage at the error amplifier input. This allows the device to be
enabled before starting VOUT, thus ensuring that VOUT soft starts smoothly. When the SS/SD voltage is less than 0.25
V, the device is shutdown and the HDRV and LDRV are driven low. In normal operation, the capacitor is charged to
VDD. When a fault condition is asserted, the soft-start capacitor goes through six charge/discharge cycles, restarting
the converter on the seventh cycle.
SW
8
O
Connect to the switched node on the converter. This pin is used for overcurrent sensing in the topside N-channel
MOSFET, and level sensing for predictive delay circuit. Overcurrent is determined, when the topside N-channel MOS-
FET is on, by comparing the voltage on SW with respect to VDD and the voltage on the ILIM with respect to VDD.
This pin is also used for the return of the topside N-channel MOSFET driver.
VDD
7
I
Power input for the chip, 5.5-V maximum. Decouple close to the pin with a low-ESR capacitor, 1-
F or larger.
FUNCTIONAL BLOCK DIAGRAM
UDG03162
15
A
3.7
A
7
BOOT
10
VDD
2
ILIM
1
FB
3
SW
8
COMP
4
HDRV
9
SS/SD
5
LDRV
6
GND
UVLO
VDD
+
REF
2 V
ERROR AMPLIFIER
0.7 V
SOFT
START
0.26 V
SHUT DOWN
OSC
UVLO
DISCHARGE
SS ACTIVE
FAULT
COUNTER
PWM COMP
PWM
LOGIC
OC
THERMAL
SHUTDOWN
CLK
UVLO
PREDICTIVE
GATE
DRIVE
(VDD1.2 V)
CURRENT
LIMIT COMP
VDD
PWM
LO
VDD
HI
FAULT
LDRV
100 ns DELAY
EN
0.65 V
+
相關PDF資料 |
PDF描述 |
|---|---|
| TPS40009DGQG4 | SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS40009DGQRG4 | SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS40022PWP | 0.01 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| TPS40022PWPR | 0.01 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| TPS40042DRCTG4 | SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO10 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS40007EVM-001 | 功能描述:電源管理IC開發工具 TPS40007-001 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| TPS40009 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:LOW-INPUT HIGH-EFFICIEDCY SYNCHRONOUS BUCK CONTROLLER |
| TPS40009DGQ | 功能描述:DC/DC 開關控制器 Low Input Sync Buck src/sink w/prebias RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| TPS40009DGQG4 | 功能描述:DC/DC 開關控制器 Low Input Sync Buck src/sink w/prebias RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| TPS40009DGQR | 功能描述:DC/DC 開關控制器 Low Input Sync Buck src/sink w/prebias RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
發布緊急采購，3分鐘左右您將得到回復。