參數資料
型號： TPL0102-100PWR
廠商： TEXAS INSTRUMENTS INC
元件分類： 數字電位計
英文描述： DIGITAL POTENTIOMETER, PDSO14
封裝： PLASTIC, TSSOP-14
文件頁數： 4/24頁
文件大?。?/td> 586K
代理商： TPL0102-100PWR
SLIS134A
– MARCH 2011 – REVISED MARCH 2011
PRINCIPLES OF OPERATION
The TPL0102 is a two channel, linear-taper digital potentiometer with 256 wiper positions. Each potentiometer
can be used as a three-terminal potentiometer or as a two-terminal rheostat. The TPL0102-100 has an
end-to-end resistance of 100k
.
The TPL0102 has non-volatile memory (EEPROM) which can be used to store the wiper position. When the
device is powered down, the last value stored in the IVR register will be maintained in the non-volatile memory.
When power is restored, the contents of the IVR register are recalled and loaded into the corresponding WR
register to set the wipers to the initial position. The internal registers of the TPL0102 can be accessed using the
I2C interface.
The position of the wiper terminal is controlled by the value in the WR 8-bit register. When the WR contains all
zeroes, the wiper terminal W is closest to its L (Low) terminal. As the value of the WR increases from all zeroes
to all ones (255 decimal), the wiper moves monotonically from the position closest to L to the position closest to
H. At the same time, the resistance between W and L increases monotonically, whereas the resistance between
W and H decreases monotonically.
Potentiometer Pin Description
HA,HB,LA,LB
The high (HA, HB) and low (LA, LB) terminals of the TPL0102 are equivalent to the fixed terminals of a
mechanical potentiometer. The H and L terminals do not have any polarity restrictions, i.e. H can be at a higher
voltage than L, or L can be at a higher voltage than H. The WA and WB terminals are the wipers and equivalent
to the movable terminal of a mechanical potentiometer. The position of the wiper is set using the WR register.
With the WR register set to 255 decimal, the wiper is closest to the H terminal, and with the WR register set to 0,
the wiper is closest to the L terminal.
SDA, SCL
SDA is a bi-directional serial data input/output pin for I2C communication. SDA is an open drain output and
requires an external pull-up resistor.
SCL is the serial clock input for I2C communication. SCL requires an external pull-up resistor.
A0, A1, A2
These inputs are used to set the last three bits of the I2C address of the device. By using different values for A0,
A1, A2, up to eight TPL0102 devices can be used on the same I2C bus.
12
Copyright
2011, Texas Instruments Incorporated
Product Folder Link(s): TPL0102
相關PDF資料
PDF描述
TPL0102-100RUCR DIGITAL POTENTIOMETER, PQCC14
TPL0202-10MRTER DIGITAL POTENTIOMETER, PQCC16
TPL0202-10RUCR DIGITAL POTENTIOMETER, PQCC14
TPL8002-25PWR DIGITAL POTENTIOMETER, PDSO16
TPL9202PWPG4 8-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO20
相關代理商/技術參數
參數描述
TPL0102-100QPWREP 功能描述:Digital Potentiometer 100k Ohm 2 Circuit 256 Taps I2C Interface 14-TSSOP 制造商:texas instruments 系列:- 包裝:剪切帶（CT） 零件狀態:有效 圓錐:線性 配置:電位計 電路數:2 抽頭數:256 電阻（歐姆）:100k 接口:I2C 存儲器類型:非易失 電壓 - 電源:2.7 V ~ 5.5 V，±2.25 V ~ 2.75 V 特性:可選地址 容差:±20% 溫度系數（典型值）:92 ppm/°C 電阻 -?游標（歐姆）（典型值）:25 工作溫度:-40°C ~ 125°C 封裝/外殼:14-TSSOP（0.173"，4.40mm 寬） 供應商器件封裝:14-TSSOP 標準包裝:1
TPL0102-100RUCR 功能描述:數字電位計 IC 256 Taps Dual Ch Digital Pot RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
TPL0102EVM 功能描述:數據轉換 IC 開發工具 TPL0102 Eval Mod RoHS:否 制造商:Texas Instruments 產品:Demonstration Kits 類型:ADC 工具用于評估:ADS130E08 接口類型:SPI 工作電源電壓:- 6 V to + 6 V
TPL0202-10 制造商:TI 制造商全稱:Texas Instruments 功能描述:256-TAPS DUAL CHANNEL DIGITAL POTENTIOMETER WITH SPI INTERFACE AND NONVOLATILE MEMORY
TPL0202-10MRTER 功能描述:數字電位計 IC 256 Taps,Dual Ch Dig Potentiometer RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*