- 您現在的位置：買賣IC網 > PDF目錄385009 > TP5089N (NATIONAL SEMICONDUCTOR CORP) CONNECTOR ACCESSORY PDF資料下載
參數資料
| 型號： | TP5089N |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 無繩電話/電話 |
| 英文描述： | CONNECTOR ACCESSORY |
| 中文描述： | TELEPHONE DIALER CKT, PDIP16 |
| 封裝： | 0.300 INCH, PLASTIC, DIP-16 |
| 文件頁數： | 3/6頁 |
| 文件大?。?/td> | 119K |
| 代理商： | TP5089N |
Connection Diagram
Dual-In-Line Package
TL/H/5057–2
Top View
Order Number TP5089N
See NS Package N16A
Pin Descriptions
Symbol
Description
V
DD
This is the positive voltage
supply to the device, referenced
to V
SS
. The collector of the
TONE OUT transistor is
connected to this pin.
This is the negative voltage
supply. All voltages are
referenced to this pin.
V
SS
OSC IN, OSC OUT
All tone generation timing is
derived from the on-chip
oscillator circuit. A low cost
3.579545 MHz A-cut crystal
(NTSC TV color-burst) is
needed between pins 7 and 8.
Load capacitors and a feedback
resistor are included on-chip for
good start-up and stability. The
oscillator stops when column
inputs are sensed with no valid
input having been detected. The
oscillator is also stopped when
the TONE DISABLE input is
pulled to logic low.
Row and Column Inputs
When no key is pushed, pull-up
resistors are active on row and
column inputs. A key closure is
recognized when a single row
and a single column are
connected to V
SS
, which starts
the oscillator and initiates tone
generation. Negative-true logic
signals simulating key closures
can also be used.
TONE DISABLE
Input
The TONE DISABLE input has
an internal pull-up resistor.
When this input is open or at
logic high, the normal tone
output mode will occur. When
TONE DISABLE input is at logic
low, the device will be in the
inactive mode, TONE OUT will
be at an open circuit state.
Symbol
Description
MUTE Output
The MUTE output is an open-
drain N-channel device that
sinks current to V
SS
with any
key input and is open when no
key input is sensed. The MUTE
output will switch regardless of
the state of the SINGLE TONE
INHIBIT input.
SINGLE TONE INHIBIT
Input
The SINGLE TONE INHIBIT
input is used to inhibit the
generation of other than valid
tone pairs due to multiple row-
column closures. It has a pull-
down resistor to V
SS
, and when
left open or tied to V
SS
any
input condition that would
normally result in a single tone
will now result in no tone, with
all other functions operating
normally. When tied to V
DD
,
single or dual tones may be
generated, see Table II.
TONE OUT
This output is the open emitter
of an NPN transistor, the
collector of which is connected
to V
DD
. When an external load
resistor is connected from
TONE OUT to V
SS
, the output
voltage on this pin is the sum of
the high and low group sine-
waves superimposed on a DC
offset. When not generating
tones, this output transistor is
turned OFF to minimize the
device idle current.
Adjustment of the emitter load
resistor results in variation of
the mean DC current during
tone generation, the sinewave
signal current through the
output transistor, and the output
distortion. Increasing values of
load resistance decrease both
the signal current and distortion.
Functional Description
With no key inputs to the device the oscillator is inhibited,
the output transistor is pulled OFF and device current con-
sumption is reduced to a minimum. Key closures are sensed
statically. Any key closure activates the MUTE output, starts
the oscillator and sets the high group and low group pro-
grammable counters to the appropriate divide ratio. These
counters sequence two ratioed-capacitor D/A converters
through a series of 28 equal duration steps per sine-wave
cycle. The two tones are summed by a mixer amplifier, with
pre-emphasis applied to the high group tone. The output is
an NPN emitter-follower requiring the addition of an external
load resistor to V
SS
. This resistor facilitates adjustment of
the signal current flowing from V
DD
through the output tran-
sistor.
The amplitude of the output tones is directly proportional to
the device supply voltage.
3
相關PDF資料 |
PDF描述 |
|---|---|
| TP5228 | CLASS AB STEREO HEADPHONE DRIVER WITH MUTE |
| TP5299 | ECHO PROCESSOR IC |
| TP5510 | Full Duplex Analog Front End for Consumer Applications |
| TP5510N | Full Duplex Analog Front End for Consumer Applications |
| TP5510WM | Full Duplex Analog Front End for Consumer Applications |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TP5089N/A+ | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Tone Telephone Dialer |
| TP5089N/B+ | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Tone Telephone Dialer |
| TP5089WM | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Tone Telephone Dialer |
| TP509 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:10 to 12 WATT SINGLE and DUAL OUTPUT DC-DC CONVERTERS |
| TP5092N/A+ | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Tone Telephone Dialer |
發布緊急采購，3分鐘左右您將得到回復。