- 您現在的位置：買賣IC網 > PDF目錄382638 > TMX320LC2403APGS (Texas Instruments, Inc.) DSP CONTROLLERS PDF資料下載
參數資料
| 型號： | TMX320LC2403APGS |
| 廠商： | Texas Instruments, Inc. |
| 元件分類： | 數字信號處理 |
| 英文描述： | DSP CONTROLLERS |
| 中文描述： | DSP控制器 |
| 文件頁數： | 57/134頁 |
| 文件大?。?/td> | 1759K |
| 代理商： | TMX320LC2403APGS |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁當前第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁
TMS320LF2407A,TMS320LF2406A,TMS320LF2403A,TMS320LF2402A
TMS320LC2406A,TMS320LC2404A,TMS320LC2403A,TMS320LC2402A
DSP CONTROLLERS
SPRS145K
JULY 2000
REVISED AUGUST 2005
57
POST OFFICE BOX 1443
HOUSTON, TEXAS 77251
1443
SPI slave mode operation in LF2403A
The LF2403A device does not have the SPISTE/IOPC5 pin. (This function is available as an internal signal only.)
The following must be done to put the LF2403A SPI in slave mode:
1.
Configure SPISTE/IOPC5 signal for GPIO mode by clearing the MCRB.5 bit.
2.
Configure SPISTE/IOPC5 signal as an output (by writing a 1 to bit 13 of PCDATDIR) and drive it low (by
writing a 0 to bit 5 of PCDATDIR). Note that SPISTE/IOPC5 should not be driven low until after the SPI is
configured and taken out of reset.
NOTE: The slave SPISTE/IOPC5 signal must not be driven low until after the master
and
slave SPI modules
are configured and taken out of reset. The initialization sequence is as follows:
a.
The master SPI is configured first and taken out of reset. This ensures that the master SPICLK is
initialized to its appropriate level (high or low, depending on the polarity bit) first, before the slave SPI
starts accepting clock pulses.
b.
The slave SPI is configured and taken out of reset.
c.
The GPIO/SPI pins of the slave is then configured for SPI operation and the SPISTE/IOPC5 signal is
driven low. This is done
after
ensuring the correct level of the master SPICLK signal. One method of
doing this would be to read the level of the SPICLK pin through the PCDATDIR register and then
deciding on the appropriate course of action.
d.
SPI transmission may commence now. Transmission of data should not be attempted until both master
and slave are configured and the slave SPISTE/IOPC5 signal is driven low.
PLL-based clock module
The 240xA has an on-chip, PLL-based clock module. This module provides all the necessary clocking signals
for the device, as well as control for low-power mode entry. The PLL has a 3-bit ratio control to select different
CPU clock rates. See Figure 16 for the PLL Clock Module Block Diagram, Table 9 for clock rates, and Table 10
for the loop filter component values.
The PLL-based clock module provides two modes of operation:
Crystal-operation
This mode allows the use of an external crystal/resonator to provide the time base to the device.
External clock source operation
This mode allows the internal oscillator to be bypassed. The device clocks are generated from an external
clock source input on the XTAL1/CLKIN pin. In this case, an external oscillator clock is connected to the
XTAL1/CLKIN pin.
相關PDF資料 |
PDF描述 |
|---|---|
| TMX320LC2403APZA | DSP CONTROLLERS |
| TMX320LC2403APZS | DSP CONTROLLERS |
| TMX320LC2403AVFA | DSP CONTROLLERS |
| TMX320LC2403AVFS | DSP CONTROLLERS |
| TMX320LC2404APAGA | DSP CONTROLLERS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TMX320LC2403APZA | 制造商:TI 制造商全稱:Texas Instruments 功能描述:DSP CONTROLLERS |
| TMX320LC2403APZS | 制造商:TI 制造商全稱:Texas Instruments 功能描述:DSP CONTROLLERS |
| TMX320LC2403AVFA | 制造商:TI 制造商全稱:Texas Instruments 功能描述:DSP CONTROLLERS |
| TMX320LC2403AVFS | 制造商:TI 制造商全稱:Texas Instruments 功能描述:DSP CONTROLLERS |
| TMX320LC2404APAGA | 制造商:TI 制造商全稱:Texas Instruments 功能描述:DSP CONTROLLERS |
發布緊急采購，3分鐘左右您將得到回復。