- 您現在的位置：買賣IC網 > PDF目錄382630 > TMX320C2812GHHS (Texas Instruments, Inc.) TMS320R2811, TMS320R2812 Digital Signal Processors PDF資料下載
參數資料
| 型號： | TMX320C2812GHHS |
| 廠商： | Texas Instruments, Inc. |
| 元件分類： | 數字信號處理 |
| 英文描述： | TMS320R2811, TMS320R2812 Digital Signal Processors |
| 中文描述： | TMS320R2811，TMS320R2812數字信號處理器 |
| 文件頁數： | 34/147頁 |
| 文件大?。?/td> | 2021K |
| 代理商： | TMX320C2812GHHS |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁當前第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁
Functional Overview
34
June 2004
SPRS257
3.2.15
Low-Power Modes
R281x devices are full static CMOS devices. Three low-power modes are provided:
IDLE:
Place CPU into low-power mode. Peripheral clocks may be turned off selectively and only
those peripherals that need to function during IDLE are left operating. An enabled interrupt
from an active peripheral will wake the processor from IDLE mode.
Turn off clock to CPU and peripherals. This mode leaves the oscillator and PLL functional.
An external interrupt event will wake the processor and the peripherals. Execution begins
on the next valid cycle after detection of the interrupt event.
Turn off oscillator. This mode basically shuts down the device and places it in the lowest
possible power consumption mode. Only a reset or XNMI will wake the device from this
mode.
STANDBY:
HALT:
3.2.16
Peripheral Frames 0, 1, 2 (PFn)
R281x segregates peripherals into three sections. The mapping of peripherals is as follows:
PF0:
XINTF:
PIE:
Timers:
eCAN:
SYS:
GPIO:
EV:
McBSP:
SCI:
SPI:
ADC:
External Interface Configuration Registers (2812 only)
PIE Interrupt Enable and Control Registers Plus PIE Vector Table
CPU-Timers 0, 1, 2 Registers
eCAN Mailbox and Control Registers
System Control Registers
GPIO Mux Configuration and Control Registers
Event Manager (EVA/EVB) Control Registers
McBSP Control and TX/RX Registers
Serial Communications Interface (SCI) Control and RX/TX Registers
Serial Peripheral Interface (SPI) Control and RX/TX Registers
12-Bit ADC Registers
PF1:
PF2:
3.2.17
General-Purpose Input/Output (GPIO) Multiplexer
Most of the peripheral signals are multiplexed with general-purpose I/O (GPIO) signals. This enables the user
to use a pin as GPIO if the peripheral signal or function is not used. On reset, all GPIO pins are configured
as inputs. The user can then individually program each pin for GPIO mode or Peripheral Signal mode. For
specific inputs, the user can also select the number of input qualification cycles. This is to filter unwanted noise
glitches.
3.2.18
32-Bit CPU-Timers (0, 1, 2)
CPU-Timers 0, 1, and 2 are identical 32-bit timers with presettable periods and with 16-bit clock prescaling.
The timers have a 32-bit count down register, which generates an interrupt when the counter reaches zero.
The counter is decremented at the CPU clock speed divided by the prescale value setting. When the counter
reaches zero, it is automatically reloaded with a 32-bit period value. CPU-Timer 2 is reserved for Real-Time
OS (RTOS)/BIOS applications. CPU-Timer 2 is reserved for the DSP/BIOS real-time operating system
(DSP/BIOS RTOS), and is connected to INT14 of the CPU. CPU-Timer 1 is for general use, and is connected
to INT13 of the CPU. CPU-Timer 0 is also for general use, and is connected to the PIE block.
A
相關PDF資料 |
PDF描述 |
|---|---|
| TMX320C2812PBKA | TMS320R2811, TMS320R2812 Digital Signal Processors |
| TMX320C2812PBKQ | TMS320R2811, TMS320R2812 Digital Signal Processors |
| TMX320C2812PBKS | TMS320R2811, TMS320R2812 Digital Signal Processors |
| TMX320C2812PGFA | TMS320R2811, TMS320R2812 Digital Signal Processors |
| TMX320C2812PGFQ | TMS320R2811, TMS320R2812 Digital Signal Processors |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TMX320C2812PBKA | 制造商:TI 制造商全稱:Texas Instruments 功能描述:TMS320R2811, TMS320R2812 Digital Signal Processors |
| TMX320C2812PBKQ | 制造商:TI 制造商全稱:Texas Instruments 功能描述:TMS320R2811, TMS320R2812 Digital Signal Processors |
| TMX320C2812PBKS | 制造商:TI 制造商全稱:Texas Instruments 功能描述:TMS320R2811, TMS320R2812 Digital Signal Processors |
| TMX320C2812PGFA | 制造商:TI 制造商全稱:Texas Instruments 功能描述:TMS320R2811, TMS320R2812 Digital Signal Processors |
| TMX320C2812PGFQ | 制造商:TI 制造商全稱:Texas Instruments 功能描述:TMS320R2811, TMS320R2812 Digital Signal Processors |
發布緊急采購，3分鐘左右您將得到回復。