- 您現在的位置：買賣IC網 > PDF目錄385001 > TMS427400P (Texas Instruments, Inc.) 4194304-WORD BY 4-BIT HIGH-SPEED DRAMS PDF資料下載
參數資料
| 型號： | TMS427400P |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | 4194304-WORD BY 4-BIT HIGH-SPEED DRAMS |
| 中文描述： | 4194304 - Word的4位高速DRAM等 |
| 文件頁數： | 2/30頁 |
| 文件大?。?/td> | 441K |
| 代理商： | TMS427400P |
第1頁當前第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁
TMS416400, TMS416400P, TMS417400, TMS417400P
TMS426400, TMS426400P, TMS427400, TMS427400P
4194304-WORD BY 4-BIT HIGH-SPEED DRAMS
SMKS881B – MAY 1995 – REVISED AUGUST 1995
2
POST OFFICE BOX 1443
HOUSTON, TEXAS 77251–1443
description (continued)
The TMS4xx400 and TMS4xx400P are each offered in a 24/26-lead plastic surface-mount TSOP (DGA suffix)
package and a 24/26-lead plastic surface-mount SOJ (DJ suffix) package. These packages are characterized
for operation from 0
°
C to 70
°
C.
operation
enhanced page mode
Enhanced page-mode operation allows faster memory access by keeping the same row address while selecting
random column addresses. The time for row-address setup and hold and address multiplex is eliminated. The
maximum number of columns that can be accessed is determined by t
RASP
, the maximum RAS low time.
Unlike conventional page-mode DRAMs, the column-address buffers in these devices are activated on the
falling edge of RAS. The buffers act as transparent or flow-through latches while CAS is high. The falling edge
of CAS latches the column addresses and enables the output. This feature allows the devices to operate at a
higher data bandwidth than conventional page-mode parts because data retrieval begins as soon as the column
address is valid rather than when CAS transitions low. This performance improvement is referred to as
enhanced page mode. A valid column address can be presented immediately after row-address hold time has
been satisfied, usually well in advance of the falling edge of CAS. In this case, data is obtained after t
CAC
max
(access time from CAS low) if t
AA
max (access time from column address) and t
RAC
have been satisfied. In the
event that column address for the next cycle is valid at the time CAS goes high, access time for the next cycle
is determined by the later occurrence of t
CPA
or t
CAC
.
address: A0–A11 (TMS4x6400/P) and A0–A10 (TMS4x7400/P)
Twenty-two address bits are required to decode 1 of 4194304 storage cell locations. For the TMS4x6400 and
TMS4x6400P, 12 row-address bits are set up on A0 through A11 and latched onto the chip by the row-address
strobe (RAS). Ten column-address bits are set up on A0 through A9. For TMS4x7400 and TMS4x7400P, 11
row-address bits are set up on inputs A0 through A10 and latched onto the chip by RAS. Eleven column-address
bits are set up on A0 through A10. All addresses must be stable on or before the falling edge of RAS and CAS.
RAS is similar to a chip enable because it activates the sense amplifiers as well as the row decoder. CAS is used
as a chip select, activating the output buffers and latching the address bits into the column-address buffers.
write enable (W)
The read or write mode is selected through W. A logic high on W selects the read mode, and a logic low selects
the write mode. The data inputs are disabled when the read mode is selected. When W goes low prior to CAS
(early write), data out remains in the high-impedance state for the entire cycle, permitting a write operation with
OE grounded.
data in (DQ1–DQ4)
Data is written during a write or read-modify-write cycle. Depending on the mode of operation, the falling edge
of CAS or W strobes data into the on-chip data latch. In an early-write cycle, W is brought low prior to CAS, and
the data is strobed in by CAS with setup and hold times referenced to this signal. In a delayed-write or
read-modify-write cycle, CAS is already low, and the data is strobed in by W with setup and hold time referenced
to this signal. In a delayed-write or read-modify-write cycle, OE must be high to bring the output buffers to the
high-impedance state prior to impressing data on the I/O lines.
data out (DQ1–DQ4)
Data out is the same polarity as data in. The output is in the high-impedance (floating) state until CAS and OE
are brought low. In a read cycle, the output becomes valid after the access time interval t
CAC
(which begins with
the negative transition of CAS) as long as t
RAC
and t
AA
are satisfied.
相關PDF資料 |
PDF描述 |
|---|---|
| TMS416409A | 4194304 BY 4-BIT EXTENDED DATA OUT DYNAMIC RANDOM-ACCESS MEMORIES |
| TMS417409ADJ-60 | 4194304 BY 4-BIT EXTENDED DATA OUT DYNAMIC RANDOM-ACCESS MEMORIES |
| TMS417409A | 4194304 BY 4-BIT EXTENDED DATA OUT DYNAMIC RANDOM-ACCESS MEMORIES |
| TMS426409A | 4194304 BY 4-BIT EXTENDED DATA OUT DYNAMIC RANDOM-ACCESS MEMORIES |
| TMS427409A | 4194304 BY 4-BIT EXTENDED DATA OUT DYNAMIC RANDOM-ACCESS MEMORIES |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TMS427409A | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:4194304 BY 4-BIT EXTENDED DATA OUT DYNAMIC RANDOM-ACCESS MEMORIES |
| TMS427409ADGA-60 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:4194304 BY 4-BIT EXTENDED DATA OUT DYNAMIC RANDOM-ACCESS MEMORIES |
| TMS428160 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:1048576-WORD BY 16-BIT HIGH-SPEED DRAMS |
| TMS428160P | 制造商:TI 制造商全稱:Texas Instruments 功能描述:1048576-WORD BY 16-BIT HIGH-SPEED DRAMS |
| TMS428169A | 制造商:TI 制造商全稱:Texas Instruments 功能描述:1048576 BY 16-BIT EXTENDED DATA OUT DYNAMIC RANDOM-ACCESS MEMORIES |
發布緊急采購，3分鐘左右您將得到回復。