- 您現在的位置：買賣IC網 > PDF目錄384010 > TLV5510INS (Texas Instruments, Inc.) 2.7-V TO 3.6-V 8-BIT HIGH-SPEED ANALOG-TO-DIGITAL CONVERTER PDF資料下載
參數資料
| 型號： | TLV5510INS |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | 2.7-V TO 3.6-V 8-BIT HIGH-SPEED ANALOG-TO-DIGITAL CONVERTER |
| 中文描述： | 2.7 - V到3.6V的8位高速模擬數字轉換器 |
| 文件頁數： | 14/19頁 |
| 文件大?。?/td> | 307K |
| 代理商： | TLV5510INS |
TLV5510
2.7-V TO 3.6-V 8-BIT HIGH-SPEED ANALOG-TO-DIGITAL CONVERTER
SLAS124C– DECEMBER 1997 – REVISED DECEMBER 1999
14
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
PRINCIPLES OF OPERATION
functional description (continued)
The MSB comparator block converts on the falling edge of each applied clock cycle. The LSB comparator blocks
CB-A and CB-B convert on the falling edges of the first and second following clock cycles, respectively. The
timing diagram of the conversion algorithm is shown in Figure 19.
analog input operation
The analog input stage to the TLV5510 is a chopper-stabilized comparator and is equivalently shown below:
VDDA
ANALOG IN
S1
Vref(N)
φ
1
φ
2
φ
2
S3
φ
1
Cs
To Encoder Logic
φ
2
S2
φ
1
Cs
To Encoder Logic
φ
2
S(N)
φ
1
Cs
To Encoder Logic
Figure 20. External Connections for Using the Internal Reference Resistor Divider
Figure 20 depicts the analog input for the TLV5510. The switches shown are controlled by two internal clocks,
φ
1 and
φ
2. These are nonoverlapping clocks that are generated from the CLK input. During the sampling period,
φ
1, S1 is closed and the input signal is applied to one side of the sampling capacitor, C
s
. Also during the sampling
period, S2 through S(N) are closed. This sets the comparator input to approximately 2.5 V. The delta voltage
is developed across C
s
. During the comparison phase,
φ
2, S1 is switched to the appropriate reference voltage
for the bit value N, i.e., V
ref(N)
. S2 is opened and V
ref(N)
– VC
s
toggles the comparator output to the appropriate
digital 1 or 0. The small resistance values for the switch, S1, and small value of the sampling capacitor combine
to produce the wide analog input bandwidth of the TLV5510. The source impedance driving the analog input
of the TLV5510 should be less than 100
across the range of input frequency spectrum.
reference inputs
–
REFB,
REFT, REFBS, REFTS
The range of analog inputs that can be converted are determined by REFB and REFT, REFT being the
maximum reference voltage and REFB being the minimum reference voltage. The TLV5510 is tested with
REFT = 2.5 V or 2 V and REFB = 0.5 V or 0 V producing a 2-V full-scale range. The TLV5510 can operate with
REFT –
REFB = 2.4 V, but the power dissipation in the reference resistor increases significantly (49 mW at 3.3 V
nominally). It is recommended that a 0.1
μ
F capacitor be attached to REFB and REFT whether using externally
or internally generated voltages.
相關PDF資料 |
PDF描述 |
|---|---|
| TLV5535PW | 8-BIT, 35 MSPS, LOW-POWER ANALOG-TO-DIGITAL CONVERTER |
| TLV5580DW | 8-BIT, 80 MSPS LOW-POWER A/D CONVERTER |
| TLV5580PW | 8-BIT, 80 MSPS LOW-POWER A/D CONVERTER |
| TLV5592 | 2-BIT ANALOG-TO-DIGITAL CONVERTER FOR FLEX PAGER CHIPSET |
| TLV5592D | 2-BIT ANALOG-TO-DIGITAL CONVERTER FOR FLEX PAGER CHIPSET |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TLV5510IPW | 制造商:TI 制造商全稱:Texas Instruments 功能描述:2.7-V TO 3.6-V 8-BIT HIGH-SPEED ANALOG-TO-DIGITAL CONVERTER |
| TLV5535 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:8-BIT, 35 MSPS, LOW-POWER ANALOG-TO-DIGITAL CONVERTER |
| TLV5535EVM | 功能描述:數據轉換 IC 開發工具 TLV5535 Eval Mod RoHS:否 制造商:Texas Instruments 產品:Demonstration Kits 類型:ADC 工具用于評估:ADS130E08 接口類型:SPI 工作電源電壓:- 6 V to + 6 V |
| TLV5535IPW | 功能描述:模數轉換器 - ADC 8bit 35Msps 1ch 3.3V RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| TLV5535IPWG4 | 功能描述:模數轉換器 - ADC 8 Bit 35 MSPS Single Ch. Low Pwr RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
發布緊急采購，3分鐘左右您將得到回復。