- 您現在的位置：買賣IC網 > PDF目錄383955 > TLE6263G (INFINEON TECHNOLOGIES AG) LS CAN, LDO and HS Switch PDF資料下載
參數資料
| 型號： | TLE6263G |
| 廠商： | INFINEON TECHNOLOGIES AG |
| 英文描述： | LS CAN, LDO and HS Switch |
| 中文描述： | 儲蓄的CAN，開關穩壓器和HS |
| 文件頁數： | 9/40頁 |
| 文件大?。?/td> | 811K |
| 代理商： | TLE6263G |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
Final Datasheet TLE 6263
Version 2.08
9
2004-06-07
off by disabling the voltage regulator. That allows the total current consumption to drop
down to less than 100 μA.
When a reset occurs, due to false watchdog triggering, the TLE6263 automatically
switches from normal mode or receive-only mode respectively, to the V
bat
stand-by
mode. If a watchdog reset occurs in the V
bat
stand-by mode the IC remains in this mode.
In sleep mode a wake-up at any of the wake-up inputs as well as via the bus lines
(CANH or CANL) automatically sets the TLE 6263 in V
bat
stand-by mode. In the V
bat
stand-by mode a wake-up is monitored by setting the output RxD low. This feature
works as a flag, to indicate a wake event to the microcontroller. To send and to receive
messages, the CAN-transceiver has to be set to normal operation mode by the
microcontroller.
In case the IC shall directly be set back to sleep mode after a wake-up, an internal wake-
flip-flop has to be reseted via the SPI. Therefore IBIT1 has to be set high and then low
again by a second SPI transmission. A transition from the V
bat
stand-by mode to the
normal mode or receive-only mode respectively, automatically resets the wake-flip-flop.
6.2
Low Dropout Voltage Regulator
The integrated low dropout voltage regulator is able to drive the internal loads (e.g.
CAN-circuit) as well as external 5V loads. Its output voltage tolerance is better than ±
2%. The maximum output current is limited to 110 mA.
An external reverse current protection is recommended at the pin Vs to prevent the
output capacitor from being discharged by negative transients or low input voltage.
Stability of the output voltage is guaranteed for output capacitors C
Q
≥
100 nF,
nevertheless it is recommended to use capacitors C
Q
≥
10 μF to buffer the output
voltage and therefore improve the reset behavior at input voltage transients.
To stabilize the internal supply a capacitor C
VI
≥
100 nF directly connected to the pin V
CI
is required.
6.3
CAN Transceiver
The TLE 6263 is optimized for low speed data transmission up to 125 kBaud in
automotive applications.
Figure 4
shows the principle configuration of a CAN
network.Normally a differential signal is transmitted and received respectively. When a
bus wiring failure (see
table 2
) is detected the device automatically switches to a
dedicated CANH or CANL single-wire mode to maintain the communication if
necessary. Further a receive-only mode is implemented that allows a separate CAN
node diagnosis. During normal and RxD-only mode, RTL is switched to V
CC
and RTH
to GND. During V
bat
stand-by and the cyclic wake mode, RTL is switched to V
S
and RTH
to GND.
相關PDF資料 |
PDF描述 |
|---|---|
| TLE6280 | 3-Phase Bridge Driver IC |
| TLE6280GP | 3-Phase Bridge Driver IC |
| TLE6285 | LIN-Transceiver LDO |
| TLE6285G | LIN-Transceiver LDO |
| TLE6286 | LIN-Transceiver LDO |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TLE6263GNUMA1 | 制造商:Infineon Technologies AG 功能描述:CAN 125KBd Sleep/Standby 5V Automotive 28-Pin DSO 制造商:Infineon Technologies AG 功能描述:BODY SYSTEM ICS - Tape and Reel |
| TLE6266G | 功能描述:CAN 接口集成電路 BODY SYSTEM ICS RoHS:否 制造商:Texas Instruments 類型:Transceivers 工作電源電壓:5 V 電源電流: 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:SOIC-8 封裝:Tube |
| TLE6266GNT | 制造商:Infineon Technologies AG 功能描述:CAN 125KBd Shutdown 5V Automotive 28-Pin DSO |
| TLE6270R | 功能描述:基準電壓& 基準電流 POWERTRAIN RoHS:否 制造商:STMicroelectronics 產品:Voltage References 拓?fù)浣Y(jié)構:Shunt References 參考類型:Programmable 輸出電壓:1.24 V to 18 V 初始準確度:0.25 % 平均溫度系數（典型值）:100 PPM / C 串聯 VREF - 輸入電壓（最大值）: 串聯 VREF - 輸入電壓（最小值）: 分流電流（最大值）:60 mA 最大工作溫度:+ 125 C 封裝 / 箱體:SOT-23-3L 封裝:Reel |
| TLE6270RAUMA1 | 制造商:Infineon Technologies AG 功能描述:QUAD LOW SIDE INJECTOR DRIVER 制造商:Infineon Technologies AG 功能描述:ENGINECONTROL_IC - Tape and Reel 制造商:Infineon Technologies AG 功能描述:IC DRIVER INJECTOR QUAD DSO-36 |
發布緊急采購，3分鐘左右您將得到回復。