參數資料
型號： TLE6244
廠商： INFINEON TECHNOLOGIES AG
英文描述： 18 Channel Smart Lowside Switch
中文描述： 18頻道智能Lowside開關
文件頁數： 37/70頁
文件大?。?/td> 721K
代理商： TLE6244
Final Data Sheet
37
V4.2, 2003-08-29
TLE 6244X
1.11 Notes for the Application in Commercial Vehicles
For electric systems with 24V battery voltage, that can even increase to > 37V in case of
load dump, some peculiarities have to be observed!
The static voltage at pin UBatt without destruction is limited to 37V, therefore this pin must either
be connected to the 5V supply voltage VDD or else the voltage at pin UBatt has to be limited by
adequate external circuitry. By connecting pin UBatt to VDD the values of R
ds, on
of the power
switches will increase up to 20%.
The power stages 7...18 are equipped with a 40V active clamping. Therefore this power stages
must only drive loads with an accordingly high resistance that can be switched on in case of over-
voltage (e.g. a maximum load dump voltage of 60V and a load resistor of 1k
result in a power
dissipation of 0.8W for each power stage. For all of the 12 power stages together there is a power
dissipation of 9.6W for the typical duration of a load dump of 500ms.).
The restrictions listed above are no longer relevant in case of a overvoltage-protected
battery voltage“within the 24V electric system that limits the voltage to e.g. a maximum of
37V.
The thresholds of the currents, on which the power stages are switched off in case of overload,
are increased by approximately 25% if there is a voltage at pin UBatt higher than19V (reason:
jump start requirements in 12V electric systems). Exception: OUT9 and OUT10 and OUT15...
OUT18. See characteristics in chapters 3.5.3, 3.6.3, 3.7.3 and 3.8.3.
The restrictions concerning overload of power stages (see 3.5.2, 3.6.2, 3.7.2 and 3.8.2) and per-
missible clamping energy (see 3.5.8, 3.6.8, 3.7.8 and 3.8.8) are relevant further on.
1.11.1 Notes for short circuit limitation
The power stages are short circuit protected for the following conditions:
The max. voltage at the output pins are limited to 36V and the TLE6244 is not operating in the
booster mode.
The power stages will be switched on/off with a max. frequency of 1 kHz.
Only a 40 msec burst with the 1 kHz on/off-frequency is allowed, with a minimum burst repetition
time of 1 sec. The maximum number of burst repetition cycles is 25. The number of driving cycles
under these conditions is limited to 100 in lifetime. The temperature of the slug of the MQFP64
package must not exceed 130°C.
These limitations are valid for UBatt > 24 V.
For Ubatt
≤
24 V the number of driving cycles under these conditions is extended to 1000 in life-
time.
相關PDF資料
PDF描述
TLE6244X 18 Channel Smart Lowside Switch
TLE6250 CAN-Transceiver
TLE6250C CAN-Transceiver
TLE6250CV33 CAN-Transceiver
TLE6250G CAN-Transceiver
相關代理商/技術參數
參數描述
TLE6244X 功能描述:電源開關 IC - 配電 18 CH. SMART LOW SIDE SWITCH RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻（最大值）:85 mOhms 開啟時間（最大值）:400 us 關閉時間（最大值）:20 us 工作電源電壓:3.2 V to 6.5 V 電源電流（最大值）: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5
TLE6244XAUMA1 制造商:Infineon Technologies AG 功能描述:Power Switch Lo Side 1.1A 64-Pin MQFP T/R 制造商:Infineon Technologies AG 功能描述:ENGINECONTROL_IC - Tape and Reel 制造商:Infineon Technologies AG 功能描述:IC LOW SIDE SWITCH 18CHAN MQFM64
TLE6244XNT 制造商:Infineon Technologies AG 功能描述:Power Switch Lo Side 1.1A 64-Pin MQFP
TLE6244X-T 功能描述:電源開關 IC - 配電 18 CH. SMART LOW SIDE SWITCH RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻（最大值）:85 mOhms 開啟時間（最大值）:400 us 關閉時間（最大值）:20 us 工作電源電壓:3.2 V to 6.5 V 電源電流（最大值）: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5
TLE6250 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:CAN-Transceiver
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*