- 您現在的位置：買賣IC網 > PDF目錄384007 > TLE4942 (INFINEON TECHNOLOGIES AG) Differential Two-Wire Hall Effect Sensor IC PDF資料下載
參數資料
| 型號： | TLE4942 |
| 廠商： | INFINEON TECHNOLOGIES AG |
| 元件分類： | 霍爾效應傳感器 |
| 英文描述： | Differential Two-Wire Hall Effect Sensor IC |
| 中文描述： | 差分兩線霍爾效應傳感器IC |
| 文件頁數： | 5/9頁 |
| 文件大?。?/td> | 802K |
| 代理商： | TLE4942 |
TLE4942-2, TLE4942-2C Supplement
TLE4942-2 - TLE4942-2C Data sheet supplement
February 2002
5
Example: The 14th row describes the behaviour shown in Fig. 1: The standstill pulse length
can be cut by the first detected speed pulse, therefore the minimum distance between the
rising edges will be 45μs. The distance between the first and second detected speed pulse is
determined by the initial signal phase and amplitude and a possible first PGA switching. As
the first pulse length also can theoretically be cut off by the following pulse, the minimum
distance could be 45μs. The rising edge between the first signal minimum and the first signal
maximum can cause the PGA switching into a lower gain range. As a result the digital noise
constant value can increase in relation to the signal amplitude. That typically leads to an
increased delay between the second and the third pulse, its maximum value is 260°. The
following minimum and maximum are necessary for peak detection. After offset correction,
the delay between the 5
th
and the 6
th
pulse can have a maximum value 270°. As this marks
the transition from uncalibrated to calibrated mode, the following consecutive pulses (4, 5, 6
...) will be spaced 180° nominally.
Same example with numbers:
B = 10mT sin (
ω
t +
).
= 30°
Typical startup-behaviour at a sinusoidal input signal of 10mT amplitude, initial phase= 30°.
1
43,6°
2
133,9°
3
333,2°
4
513,2°
5
693,2°
6
900°
7
1080°
8
1260°
9
1440°
10
...
90,3°
(PGA,
uncal)
199,3°
(PGA,
uncal)
180°
(uncal)
180°
(uncal)
206,8°
(Offset-
correction)
180°
(cal)
180°
(cal)
180°
(cal)
180°
(cal)
→
This corresponds to row 14 in the table, behaviour similar to Fig. 1
As a special (and rare) case instead of an offset correction after edge number 5, a further
(extra) PGA switching could occur before edge number 5. PGA switching inhibits an
immediate offset update. It
can
happen if one of the signal peaks is exactly at a PGA
switching threshold (speed-ADC overflow). In this case the offset update (switching from
uncalibrated mode to calibrated mode) would be delayed by two to three further edges. The
referring phase shifts of the example would then be as follows:
1
43,6°
2
133,9°
3
333,2°
4
513,2°
5
727,5°
6
907,5°
7
1087,5°
8
1260°
9
1440°
10
...
90,3°
(PGA,
uncal)
199,3°
(PGA,
uncal)
180°
(uncal)
214,3°
(extra PGA)
180°
(uncal)
180°
(uncal)
172,5°
(Offset-
correction)
180°
(cal)
180°
(cal)
→
This corresponds to row 13 of the table.
相關PDF資料 |
PDF描述 |
|---|---|
| TLE4942-2C | Differential Two-Wire Hall Effect Sensor IC |
| TLE4942C | Differential Two-Wire Hall Effect Sensor IC |
| TLE4945-2G | Uni- and Bipolar Hall IC Switches for Magnetic Field Applications |
| TLE4945-2L | Uni- and Bipolar Hall IC Switches for Magnetic Field Applications |
| TLE4945 | Uni- and Bipolar Hall IC Switches for Magnetic Field Applications |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TLE4942-1 | 功能描述:板機接口霍耳效應/磁性傳感器 Smart Hall Effct Ics Actve Wheel Spd Sens RoHS:否 制造商:Honeywell 類型:Bipolar Hall-Effect Digital Position Sensor 工作電源電壓:3 V to 24 V 電源電流:3.5 mA 最大輸出電流:20 mA 工作點最小值/最大值:5 G, 55 G 最小/最大釋放點（Brp）:- 55 G, - 5 G 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23 |
| TLE4942-1C | 功能描述:板機接口霍耳效應/磁性傳感器 Differential 4.5V - 20V 16.8 mA RoHS:否 制造商:Honeywell 類型:Bipolar Hall-Effect Digital Position Sensor 工作電源電壓:3 V to 24 V 電源電流:3.5 mA 最大輸出電流:20 mA 工作點最小值/最大值:5 G, 55 G 最小/最大釋放點（Brp）:- 55 G, - 5 G 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23 |
| TLE4942-1C PCN PART | 制造商:Infineon Technologies AG 功能描述:INFTLE4942-1C PCN PART SP000710676_HALL |
| TLE49421CBAMA1 | 制造商:Infineon Technologies AG 功能描述:Hall Effect Sensor Monolithic 5V/9V/12V/15V/18V 2-Pin SSO T/R 制造商:Infineon Technologies AG 功能描述:MAGNETIC SENSOR IC'S - Ammo Pack 制造商:Infineon Technologies AG 功能描述:IC HALL EFFECT SENSOR SSO-2-2 |
| TLE4942-1C-HT | 功能描述:板機接口霍耳效應/磁性傳感器 Rotational Speed Sensor RoHS:否 制造商:Honeywell 類型:Bipolar Hall-Effect Digital Position Sensor 工作電源電壓:3 V to 24 V 電源電流:3.5 mA 最大輸出電流:20 mA 工作點最小值/最大值:5 G, 55 G 最小/最大釋放點（Brp）:- 55 G, - 5 G 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23 |
發布緊急采購，3分鐘左右您將得到回復。