- 您現在的位置：買賣IC網 > PDF目錄384007 > TLE4923 (INFINEON TECHNOLOGIES AG) Dynamic Differential Hall Effect Sensor IC(動態差分霍爾效應傳感器芯片) PDF資料下載
參數資料
| 型號： | TLE4923 |
| 廠商： | INFINEON TECHNOLOGIES AG |
| 英文描述： | Dynamic Differential Hall Effect Sensor IC(動態差分霍爾效應傳感器芯片) |
| 中文描述： | 動態差分霍爾效應傳感器集成電路（動態差分霍爾效應傳感器芯片） |
| 文件頁數： | 4/18頁 |
| 文件大?。?/td> | 127K |
| 代理商： | TLE4923 |
TLE 4923
Data Sheet
4
2000-07-01
Functional Description
The Differential Hall sensor IC detects the motion and position of ferromagnetic and
permanent magnet structures by measuring the differential flux density of the magnetic
field. To detect ferromagnetic objects the magnetic field must be provided by a back
biasing permanent magnet (
south or north
pole of the magnet attached to the rear
unmarked side of the IC package).
Using an external capacitor the generated Hall voltage signal is slowly adjusted via an
active high pass filter with low frequency cut-off. This causes the output to switch into a
biased mode after a time constant is elapsed. The time constant is determined by the
external capacitor. Filtering avoids aging and temperature influence from Schmitt-trigger
input and eliminates device and magnetic offset.
The TLE 4923 can be exploited to detect toothed wheel rotation in a rough environment.
Jolts against the toothed wheel and ripple have no influence on the output signal.
The on and off state of the IC are indicated by high and low current consumption.
Circuit Description (see Figure 2)
The TLE 4923 is comprised of a supply voltage reference, a pair of Hall probes spaced
at 2.5 mm, differential amplifier, filter for offset compensation, Schmitt-trigger, and a
switched current source.
The TLE 4923 was designed to have a wide range of application parameter
variations. Differential fields up to
±
40 mT can be detected without influence to
the switching performance. The pre-induction field can either come from a
magnetic south or north pole, whereby the field strength up to 500 mT or more will
not influence the switching points
1)
. The improved temperature compensation
enables a superior sensitivity and accuracy over the temperature range. Finally,
the
optimized
piezo
compensation
compensation enable easy manufacturing and elimination of magnet offsets.
Protection is provided at the input/supply (pin 1) for reverse polarity.
and
the
integrated
dynamic
offset
1)
Differential bias fields exceeding
±
20 mT, e. g. caused by a misaligned magnet, should be avoided.
相關PDF資料 |
PDF描述 |
|---|---|
| TLE4935L | Bipolar Hall IC Switches for Magnetic Field Applications(用于磁場應用的雙極霍爾芯片開關) |
| TLE4935-2L | Bipolar Hall IC Switches for Magnetic Field Applications(用于磁場應用的雙極霍爾芯片開關) |
| TLE4941C | Differential Two-Wire Hall Effect Sensor IC |
| TLE4941-2C | Differential Two-Wire Hall Effect Sensor IC |
| TLE4942-2 | Differential Two-Wire Hall Effect Sensor IC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TLE4923_05 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Dynamic Differential Hall Effect Sensor IC |
| TLE4923HALA1 | 制造商:Infineon Technologies AG 功能描述:Hall Effect Sensor Bipolar 5V/9V/12V/15V 制造商:Infineon Technologies AG 功能描述:MAGNETIC SENSOR IC'S - Ammo Pack 制造商:Infineon Technologies AG 功能描述:IC HALL EFFECT SENSOR PSSO-3-6 |
| TLE4924C-1 E6547 | 功能描述:板機接口霍耳效應/磁性傳感器 MAGNETIC SENSOR IC’S RoHS:否 制造商:Honeywell 類型:Bipolar Hall-Effect Digital Position Sensor 工作電源電壓:3 V to 24 V 電源電流:3.5 mA 最大輸出電流:20 mA 工作點最小值/最大值:5 G, 55 G 最小/最大釋放點（Brp）:- 55 G, - 5 G 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23 |
| TLE4924C-1E6547 | 制造商:Infineon Technologies AG 功能描述: |
| TLE4924C1E6547HAMA1 | 制造商:Infineon Technologies AG 功能描述:HIGH ACCURATE HALL BASED CRANK SENSOR 制造商:Infineon Technologies AG 功能描述:MAGNETIC SENSOR IC'S - Ammo Pack |
發布緊急采購，3分鐘左右您將得到回復。