• <ins id="ejk2g"><noframes id="ejk2g"></noframes></ins>
    <pre id="ejk2g"><span id="ejk2g"></span></pre><kbd id="ejk2g"><label id="ejk2g"><meter id="ejk2g"></meter></label></kbd><em id="ejk2g"><strike id="ejk2g"></strike></em>
    <ins id="ejk2g"></ins>
  • 參數資料
    型號: TLC3578IPWG4
    廠商: TEXAS INSTRUMENTS INC
    元件分類: ADC
    英文描述: 8-CH 14-BIT SUCCESSIVE APPROXIMATION ADC, SERIAL ACCESS, PDSO24
    封裝: GREEN, PLASTIC, TSSOP-24
    文件頁數: 15/49頁
    文件大小: 1137K
    代理商: TLC3578IPWG4
    TLC3574, TLC3578, TLC2574, TLC2578
    5V ANALOG, 3/5V DIGITAL, 14/12BIT, 200KSPS, 4/8CHANNEL
    SERIAL ANALOGTODIGITAL CONVERTERS WITH ±10V INPUTS
    SLAS262C OCTOBER 2000 REVISED MAY 2003
    22
    WWW.TI.COM
    detailed description (continued)
    Table 2. Configuration Register (CFR) Bit Definition
    SDI BIT
    DEFINITION
    D11
    Always 1. Otherwise the performance is degraded.
    D10
    Conversion output code format select:
    0: BOB (bipolar offset binary);
    1: BTC (binary 2s complement)
    D9
    Sample period select for normal sampling. Don’t care in extended sampling.
    D9
    0: Long sampling (4x) 44 SCLKs;
    1: Short sampling 12 SCLKs
    D8
    Conversion clock source select:
    0: Conversion clock = Internal OSC;
    1: Conversion clock = SCLK/4
    D7
    Input mode select:
    0: Single-ended;
    1: Pseudodifferential. Pin configuration shown below.
    Pin Configuration of TLC3578 and TLC2578
    Pin Configuration of TLC3574 and TLC2574
    Pin No.
    Single-ended
    Pseudodifferential polarity
    Pin No.
    Single-ended
    Pseudodifferential polarity
    9
    10
    A0
    A1
    Plus
    Minus
    Pair A
    9
    10
    A0
    A1
    PLUS
    MINUS
    Pair A
    11
    12
    A2
    A3
    Plus
    Minus
    Pair B
    11
    12
    A2
    A3
    PLUS
    MINUS
    Pair B
    13
    14
    A4
    A5
    Plus
    Minus
    Pair C
    15
    16
    A6
    A7
    Plus
    Minus
    Pair D
    D[6:5]
    Conversion mode select
    00: One shot mode
    01: Repeat mode
    10: Sweep mode
    11: Repeat sweep mode.
    D[4:3]
    Sweep auto sequence select (Note: These bits only take effect in conversion mode 10 and 11.)
    D[4:3]
    TLC3578 and TLC2578
    TLC3574 and TLC2574
    Single-ended (by ch)
    Pseudodifferential (by pair)
    Single-ended (by ch)
    Pseudodifferential (by pair)
    00: 01234567
    01: 02460246
    10: 00224466
    11: 02020202
    00:
    N/A
    01: ABCDABCD
    10: AABBCCDD
    11: ABABABAB
    00: 01230123
    01: 02020202
    10: 00112233
    11: 00002222
    00:
    N/A
    01: ABABABAB
    10:
    N/A
    11: AAAABBBB
    D2
    EOC/INT pin function select
    0: Pin used as INT
    1: Pin used as EOC ( for mode 00 only)
    D[1:0]
    FIFO trigger level (sweep sequence length). Don’t care in one shot mode.
    00: Full (INT generated after FIFO Level 7 filled)
    01: 3/4 (INT generated after FIFO Level 5 filled)
    10: 1/2 (INT generated after FIFO Level 3 filled)
    11: 1/4 (INT generated after FIFO Level 1 filled)
    sampling period
    The sampling period follows the command period. The selected signal is sampled during this time. The device
    has three different sampling modes: normal short mode, normal long mode, and extended mode.
    Normal Short Sampling Mode: Sampling time is controlled by the SCLK and lasts 12 SCLK periods. At the
    end of sampling, the converter automatically starts the conversion period. After the configuration, the normal
    sampling starts automatically after the falling edge of fourth SCLK that follows the falling edge of CS if CS
    triggers the operation, or follows the rising edge of FS if FS initiates the operation, except the FIFO READ and
    WRITE CFR commands.
    相關PDF資料
    PDF描述
    TLC3578IPWRG4 8-CH 14-BIT SUCCESSIVE APPROXIMATION ADC, SERIAL ACCESS, PDSO24
    TLC3578IPWR 8-CH 14-BIT SUCCESSIVE APPROXIMATION ADC, SERIAL ACCESS, PDSO24
    TLC3574IPWG4 4-CH 14-BIT SUCCESSIVE APPROXIMATION ADC, SERIAL ACCESS, PDSO20
    TLC2574IPWG4 4-CH 12-BIT SUCCESSIVE APPROXIMATION ADC, SERIAL ACCESS, PDSO20
    TLC3578IDWR 8-CH 14-BIT SUCCESSIVE APPROXIMATION ADC, SERIAL ACCESS, PDSO24
    相關代理商/技術參數
    參數描述
    TLC3578IPWR 功能描述:模數轉換器 - ADC Serial Out Low Power RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32
    TLC3578IPWRG4 功能描述:模數轉換器 - ADC Serial Out Low Power RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32
    TLC363C 制造商:DIODES 制造商全稱:Diodes Incorporated 功能描述:TRIPLE LOW CAPACITANCE MOUNT ZENER DIODE ARRAY
    TLC363C20V8 制造商:DIODES 制造商全稱:Diodes Incorporated 功能描述:TRIPLE LOW CAPACITANCE MOUNT ZENER DIODE ARRAY
    TLC363C20V8-7 制造商:Diodes Incorporated 功能描述:ZENER TRIPLE PARALLEL 20.8V 5% 200MW 6PIN SOT-363 - Tape and Reel