參數資料
    型號: TK65936MTL
    廠商: TOKO INC
    元件分類: 顯示驅動器
    英文描述: LARGE EL LAMP DRIVER
    中文描述: EL DISPLAY DRIVER, PDSO6
    封裝: SOT-23L, 6 PIN
    文件頁數: 14/16頁
    文件大?。?/td> 194K
    代理商: TK65936MTL
    Page 14
    May 2000 TOKO, Inc.
    TK6593x
    NOISE CONSIDERATIONS
    There are two specific noise types relevant to the user when it comes to choosing EL Drivers: the Audio Noise and the
    Electromagnetic Interference (EMI) Noise.
    The EMI Noise would most likely come from the boost converter section of the EL Driver circuit. The Toko EL Driver has
    specifically been designed to address this issue.
    The device runs at a fixed frequency and the frequency is controlled tightly in order to avoid interference.
    Furthermore, the panel frequency is forced to be a 128 submultiple of the boost frequency avoiding any type of beating
    frequencies.
    By choosing shielded coils, the EMI noise problem can further be reduced.
    The Audio Noise can come from several components which make up the system.
    The coil, if operated in the audio range would be a source of noise. The Toko EL Driver was carefully designed to give
    the user the choice of 10 frequencies such that the coil frequency will always be above audio range. Since the device
    operates at a fixed frequency in discontinuous conduction mode, there are no possible submultiples which would cause
    audible noise.
    The filter capacitor can be a source of audio noise. Furthermore, depending on how this cap is mounted, the mounting
    can act as an amplifier (as a speaker box). Certain ceramic caps driven from a high voltage source as in the EL Driver
    case, demonstrate a PIEZOELECTRIC effect which is distinguishable in the Audio Range.
    Other types of caps, such as film type do not denote an audio noise.
    The panel itself, being operated well into the Audio Range (175 Hz to 400 Hz) and of a capacitive nature driven from high
    voltage may also display Audible Noise. Mounting of this panel can enhance or diminish this natural effect of the panel.
    APPLICATION INFORMATION
    FIGURE 4: INTENSITY CONTROL APPLICATION
    CEL
    1C1
    D1
    EL +
    HV
    GND
    IND
    EL -
    VCC
    L1
    Vpower
    1.8 to 7 V
    R1
    R2
    3 k
    200~ 1 mA sink
    3 V ~ 1 mA source
    R1 = 1.5 k
    R2 = 3.0 k
    C2 = 10 nF
    1C2
    EL LAMP INTENSITY CONTROL APPLICATION
    In driving EL lamp panels, it is sometimes desirable to be able to adjust the intensity of the EL lamp. The TK6593x can
    be used in such an application. By reducing the voltage supplied to the V
    pin of the TK6593x, one can reduce the peak
    current regulation point of the IC. This translates into a reduction in the peak to peak output voltage across the EL panel,
    which reduces the intensity of the light being emitted from the EL lamp.
    By decreasing the input voltage to the V
    pin from 2.9 V to 2.1 V, the peak current regulation point will be reduced about
    53 mA. This correlates to about a 2/3 reduction in the peak to peak voltage appearing across the EL lamp panel.
    The V
    pin only takes 200
    μ
    A max. when the EL driver is in operation. Therefore, it can normally be controlled by logic
    power level signals. One way of accomplishing this with two digital logic signals is shown in Figure 4.
    相關PDF資料
    PDF描述
    TK65937M LARGE EL LAMP DRIVER
    TK65937MTL LARGE EL LAMP DRIVER
    TK65938M LARGE EL LAMP DRIVER
    TK65938MTL LARGE EL LAMP DRIVER
    TK65939M LARGE EL LAMP DRIVER
    相關代理商/技術參數
    參數描述
    TK65936MTL/C6 制造商:TOKO 制造商全稱:TOKO, Inc 功能描述:LARGE EL LAMP DRIVER
    TK65937M 制造商:TOKO 制造商全稱:TOKO, Inc 功能描述:LARGE EL LAMP DRIVER
    TK65937MTL 制造商:TOKO 制造商全稱:TOKO, Inc 功能描述:LARGE EL LAMP DRIVER
    TK65937MTL/C7 制造商:TOKO 制造商全稱:TOKO, Inc 功能描述:LARGE EL LAMP DRIVER
    TK65938M 制造商:TOKO 制造商全稱:TOKO, Inc 功能描述:LARGE EL LAMP DRIVER