
Page 10
June 1999 TOKO, Inc.
TK15327
KEY INPUT CIRCUIT
1ch and 2ch is separate action by each control keys. Figure
11 is an equivalence circuit of key input. If two keys are low
level or high level at the same time then the output is floating
condition. (See Terminal DC Voltage and Circuit table on
page 9).
SWITCHING TIME
This time is the signal change response time compared to
the control key input signal. Figure 12 illustrates the timimg
chart. T = 2
μ
s typically.
APPLICATION
Figure 13 illustrates an example of a typical application.
The standard application is to use capacitor coupling at the
inputs and output of the TK15327M. For characteristics of
distortion and dynamic range versus R
, refer to the graphs
in the Typical Performance Characteristics. The TK15327M
can also be used with direct coupling, but the characteris-
tics will get worse (distortion, etc.). If direct coupling is
desired, then it is recommended to use external circuitry
that is biased compatible with the TK15329M. Input of the
TK15329M is the open base type.
APPLICATION INFORMATION
Figure 11
Figure 12
Figure 13
Figure 14
CROSS TALK (ISOLATION AND SEPARATION)
Figure 14 is an example of a layout pattern. In the
application of the TK15327M, the following must be
considered. Because of the high impedance at the inputs,
the capacitors can act as antennas to each other. If the
parts are bigger, and the space between the capacitors is
too narrow, then cross talk will increase. Therefore, when
designing the printed circuit pattern, separate the input
capacitors as far as possible and use as small a part as
possible (e.g., surface mount types, etc.).
Key in
to Logic
Key in
Bch (Ach)
SW out
50%
Ach (Bch)
t
1OUT
1BIN
VCC
GND
2BIN
2OUT
1AIN
1KEY
2KEY
2AIN
+
+
10 μF
RL
10 μF
1Bin
11
10
9
8
7
+
10 μF
+
2 Bin
1Key
2Key
10 μF
+
RL
10 μF
+
10 μF
+
33 μF
1Ain
2Ain