參數資料
型號: TK11900MTL
廠商: TOKO INC
元件分類: 基準電壓源/電流源
英文描述: Cap-Free, NMOS, 150mA Low Dropout Regulator with Reverse Current Protection
中文描述: 1.5 V-15 V ADJUSTABLE POSITIVE LDO REGULATOR, 0.35 V DROPOUT, PDSO6
封裝: SOT-23L, SMT-6
文件頁數: 8/10頁
文件大?。?/td> 73K
代理商: TK11900MTL
Page 8
November 2000 TOKO, Inc.
TK11900
BOARD LAYOUT
Copper pattern should be as large as possible. Power
dissipation is 400 mW for the SOT-23L package. A low
Equivalent Series Resistance (ESR) capacitor is recom-
mended. For low temperature operation, select a capacitor
with a low ESR at the lowest operating temperature to
prevent oscillation, degradation of ripple rejection and in-
crease in noise. The minimum recommended capacitance
is 2.2 μF.
SOT-23L BOARD LAYOUT
INPUT/OUTPUT DECOUPLING CAPACITOR CONSID-
ERATIONS
Voltage regulators require input and output decoupling
capacitors. The required values of these capacitors vary
with application. Capacitors made by different manufactur-
ers can have different characteristics, particularly with
regard to high frequencies and ESR over temperature. The
type of capacitor is also important. For example, a 4.7 μF
aluminum electrolytic may be required for a certain applica-
tion. If a tantalum capacitor is used, a lower value of 2.2 μF
would be adequate. It is important to consider the tempera-
ture characteristics of the decoupling capacitors. While
Toko regulators are designed to operate as low as -30
°
C,
many capacitors will not operate properly at this tempera-
ture. The capacitance of aluminum electrolytic capacitors
may decrease to 0 at low temperatures. This may cause
oscillation on the output of the regulator since some capaci-
tance is required to guarantee stability. Thus, it is important
GND
VIN
VOUT
CONTROL
NOISE BYPASS
+
+
GND
FEEDBACK
to consider the characteristics of the capacitor over tem-
perature when selecting decoupling capacitors.
The ESR is another important parameter. The ESR will
increase with temperature but low ESR capacitors are often
larger and more costly. In general, tantalum capacitors offer
lower ESR than aluminum electrolytic, but new low ESR
aluminum electrolytic capacitors are now available from
several manufacturers. Usually a bench test is sufficient to
determine the minimum capacitance required for a particu-
lar application. After taking thermal characteristics and
tolerance into account, the minimum capacitance value
should capacitor or 3.3 μF for an aluminum electrolytic.
Please note that linear regulators with a low dropout voltage
have high internal loop gains which require care in guarding
against oscillation caused by insufficient decoupling ca-
pacitance. The use of high quality decoupling capacitors
suited for your application will guarantee proper operation of
the circuit.
NOISE BYPASS CAPACITOR SECTION
The noise bypass capacitor (C
N
) should be connected as
close as possible to pin 1 and ground. The recommended
value for C
N
is 0.01 mF. The noise bypass terminal has a
high impedance and care should be taken if the noise
bypass capacitor is not used. This terminal is susceptible
to external noise, and oscillation can occur when C
N
is not
used and the solder pad for this pin is too large.
OUTPUT VOLTAGE SETTING
The output voltage can be set from 1.5 to 15 V by two
external resistors according to the following equation:
V
OUT
= 1.25 V x [(R
1
+ R
2
) / R
2
]
where 10 k
- R
2
- 60 k
APPLICATION INFORMATION
VOUT
R2
R1
FEEDBACK
相關PDF資料
PDF描述
TK11922 VOLTAGE REGULATOR WITH RESET OUTPUT
TK11922MTL VOLTAGE REGULATOR WITH RESET OUTPUT
TK11927 VOLTAGE REGULATOR WITH RESET OUTPUT
TK11927MTL VOLTAGE REGULATOR WITH RESET OUTPUT
TK11930 VOLTAGE REGULATOR WITH RESET OUTPUT
相關代理商/技術參數
參數描述
TK11950MTL 制造商:TOKO 功能描述:
TK119A 制造商:Thomas & Betts 功能描述:3 1/2" COUPLING,COMP.,EMT,STL 制造商:Thomas & Betts 功能描述:Fittings Coupler 3.5inch Steel
TK119A-RT 制造商:Thomas & Betts 功能描述:3 1/2 IN RAINTIGHT COMPRESSION CPL
TK11A45D(Q) 制造商:Toshiba America Electronic Components 功能描述:
TK11A45D(STA4,Q,M) 功能描述:MOSFET N-Ch MOS 10A 40V 25W 410pF 0.029 RoHS:否 制造商:STMicroelectronics 晶體管極性:N-Channel 汲極/源極擊穿電壓:650 V 閘/源擊穿電壓:25 V 漏極連續電流:130 A 電阻汲極/源極 RDS(導通):0.014 Ohms 配置:Single 最大工作溫度: 安裝風格:Through Hole 封裝 / 箱體:Max247 封裝:Tube