- 您現在的位置：買賣IC網 > PDF目錄361463 > TK11136S (TOKO Inc.) VOLTAGE REGULATOR WITH ON/OFF SWITCH PDF資料下載
參數資料
| 型號： | TK11136S |
| 廠商： | TOKO Inc. |
| 英文描述： | VOLTAGE REGULATOR WITH ON/OFF SWITCH |
| 中文描述： | 調壓器ON / OFF開關 |
| 文件頁數： | 10/16頁 |
| 文件大?。?/td> | 84K |
| 代理商： | TK11136S |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁
Page 10
March 1999 TOKO, Inc.
TK111xxS
Reverse Voltage Protection
Reverse voltage protection prevents damage due to the
output voltage being higher than the input voltage. This
fault condition can occur when the output capacitor remains
charged and the input is reduced to zero, or when an
external voltage higher than the input voltage is applied to
the output side.
REDUCTION OF OUTPUT NOISE
Although the architecture of the Toko regulators is designed
to minimize semiconductor noise, further reduction can be
achieved by the selection of external components. The
obvious solution is to increase the size of the output
capacitor. A more effective solution would be to add a
capacitor to the noise bypass terminal. The value of this
capacitor should be 0.1
μ
F or higher (higher values provide
greater noise reduction). Although stable operation is
possible without the noise bypass capacitor, this terminal
has a high impedance and care should be taken to avoid
a large circuit area on the printed circuit board when the
capacitor is not used. Please note that several parameters
are affected by the value of the capacitors and bench
testing is recommended when deviating from standard
values.
CONTROL FUNCTION
The TK111xxS has an active high control pin. The control
pin requires over 1.8 V for operation and under
0.6 V for
standby. For the range of 0.6 V < V
CONT
< 1.8 V
, operation
is undefined. If the control function is not used, connect the
control pin to V
IN
.
DEFINITION AND EXPLANATION OF TECHNICAL TERMS (CONT.)
SW
CN
VIN
OUTPUT VOLTAGE RESPONSE A
(OFF
→
ON)
-5
5
25
15
35
CL = 0.47μF
45
CL = 0.68 μF
CL = 1.5 μF
CL = 1.0 μF
TIME (μs)
ILOAD = 30 mA, CN = 3300 pF
V
V
OUTPUT VOLTAGE RESPONSE B
(OFF
→
ON)
0
2
6
4
8
CN = 0.47 μF
CN = 0.33 μF
CN = 0.68μF
CN = 1.0 μF
TIME (ms)
ILOAD = 30 mA, CL = 2.2 μF
V
V
CN = 0.1 μF
CONTROL FUNCTION
ON/OFF RESPONSE WITH CONTROL
The turn-on time depends upon the value of the output
capacitor and the noise bypass capacitor. The turn-on time
will increase with the value of either capacitor. The graphs
below show the relationship between turn-on time and
load capacitance. If the value of these capacitors is reduced,
the load and line regulation will suffer and the noise voltage
will increase. If the value of these capacitors is increased,
the turn-on time will increase.
相關PDF資料 |
PDF描述 |
|---|---|
| TK11137S | VOLTAGE REGULATOR WITH ON/OFF SWITCH |
| TK11138S | VOLTAGE REGULATOR WITH ON/OFF SWITCH |
| TK11139S | VOLTAGE REGULATOR WITH ON/OFF SWITCH |
| TK11150S | VOLTAGE REGULATOR WITH ON/OFF SWITCH |
| TK11120S | VOLTAGE REGULATOR WITH ON/OFF SWITCH |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TK11136SCL | 制造商:TOKO 制造商全稱:TOKO, Inc 功能描述:VOLTAGE REGULATOR WITH ON/OFF SWITCH |
| TK11136SIL | 制造商:TOKO 制造商全稱:TOKO, Inc 功能描述:VOLTAGE REGULATOR WITH ON/OFF SWITCH |
| TK11137M | 制造商:TOKO 制造商全稱:TOKO, Inc 功能描述:VOLTAGE REGULATOR WITH ON/OFF SWITCH |
| TK11137MCL | 制造商:TOKO 制造商全稱:TOKO, Inc 功能描述:VOLTAGE REGULATOR WITH ON/OFF SWITCH |
| TK11137MIL | 制造商:TOKO 制造商全稱:TOKO, Inc 功能描述:VOLTAGE REGULATOR WITH ON/OFF SWITCH |
發布緊急采購，3分鐘左右您將得到回復。