- 您現在的位置：買賣IC網 > PDF目錄365786 > TJA1054 (NXP Semiconductors N.V.) Fault-tolerant CAN transceiver(容錯CAN收發器) PDF資料下載
參數資料
| 型號： | TJA1054 |
| 廠商： | NXP Semiconductors N.V. |
| 元件分類： | CAN |
| 英文描述： | Fault-tolerant CAN transceiver(容錯CAN收發器) |
| 中文描述： | 容錯CAN收發器（容錯的CAN收發器） |
| 文件頁數： | 3/16頁 |
| 文件大小： | 75K |
| 代理商： | TJA1054 |
Philips Semiconductors
APPLICATION HINTS
Systems Laboratory Hamburg, Germany
Fault-tolerant CAN transceiver
V2.0
Page 3 of 16
1. Comparison PCA82C252 / TJA1053 / TJA1054
Reference for the below technical information is:
- Data sheet PCA82C252, revision Oct. 28, 1997
- Data sheet TJA1053,
- Data sheet TJA1054,
revision Oct. 15, 1997
revision Feb. 11, 1999
1.1. System parameters
Key
System size
Speed
Emission
Immunity
TxD dominant monitoring
Extended bus failure
management
(CANH to Vcc)
Resolved problem of
arbitration across open
failures
PCA82C252
10 – 15 nodes
1) 2)
20 - <125 kbps
3)
+
+
no
no
TJA1053
10 – 15 nodes
2)
20 – 125 kbps
+
+
yes
no
TJA1054
> 32 nodes
40 – 125 kbps
++
++
yes
yes
no
yes
yes
1) The limit is given by the performance during CANH to ground failures, which very much depends
on the size and type of cable used.
2) The limit is given by the wake-up capability during CANH to ground failures, which very much
depends on the values of the distributed terminations across the network. Therefore, exact figures
of system size cannot be given.
3) With CANH to VBAT failures the delay of the dominant edge is increased. The maximum speed
strongly depends on the inductance of the cable used.
1.2. Device parameters
Key
Current consumption in
Normal Mode (I
CC
)
Current consumption in
Standby Modes (I
BAT
+ I
CC
)
Minimum operating voltage
Prevention of VBAT
reverse current
1)
NWAKE sensitivity
Vcc Standby mode
NERR reporting of open
failures
PCA82C252
6 mA
(recessive)
29 mA (dominant)
70 uA
TJA1053
(recessive)
TJA1054
(recessive)
17 mA (dominant)
30 uA
6 mA
29 mA (dominant)
70 uA
7 mA
6V
no
6V
no
5V
yes
negative edge
yes
during frame only
negative edge
yes
during frame only
both edges
no
during frame and
interframe space
1) In case a module looses its battery connection, a reverse power supply of this module via the CAN
Bus lines is prevented. For the PCA82C252 and the TJA1053 an external diode at the battery pin
of the Transceiver is required. This diode is required additionally to the control unit’s polarity
protection diode typically implemented at the battery connector of the entire module.
相關PDF資料 |
PDF描述 |
|---|---|
| TK1-L2-1.5V | ULTRA LOW PROFILE 2 AMP. POLARIZED RELAY |
| TK1-L2-12V | ULTRA LOW PROFILE 2 AMP. POLARIZED RELAY |
| TK1-L2-24V | ULTRA LOW PROFILE 2 AMP. POLARIZED RELAY |
| TK1-L2-3V | ULTRA LOW PROFILE 2 AMP. POLARIZED RELAY |
| TK1-L2-4.5V | ULTRA LOW PROFILE 2 AMP. POLARIZED RELAY |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TJA1054_1008 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Fault-tolerant CAN transceiver |
| TJA1054A | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Fault-tolerant CAN transceiver |
| TJA1054AT | 制造商:NXP Semiconductors 功能描述:TRANSCEIVER CAN FAULT TOL SO-14 制造商:NXP Semiconductors 功能描述:TRANSCEIVER, CAN FAULT TOL, SO-14 制造商:NXP Semiconductors 功能描述:Fault-tolerant CAN transceiver,TJA1054AT |
| TJA1054AT,512 | 功能描述:網絡控制器與處理器 IC HI SPD CAN TRANSCVR RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| TJA1054AT,518 | 功能描述:網絡控制器與處理器 IC CAN XCVR FAULT-TOL RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。