- 您現在的位置：買賣IC網 > PDF目錄361458 > TISP3095H3SL (Power Innovations International, Inc.) DUAL BIDIRECTIONAL THYRISTOR OVERVOLTAGE PROTECTORS PDF資料下載
參數資料
| 型號： | TISP3095H3SL |
| 廠商： | Power Innovations International, Inc. |
| 英文描述： | DUAL BIDIRECTIONAL THYRISTOR OVERVOLTAGE PROTECTORS |
| 中文描述： | 雙雙向可控硅過電壓保護器 |
| 文件頁數： | 9/12頁 |
| 文件大?。?/td> | 231K |
| 代理商： | TISP3095H3SL |
9
JANUARY 1999 - REVISED MAY 1999
TISP3070H3SL THRU TISP3095H3SL, TISP3125H3SL THRU TISP3210H3SL
TISP3250H3SL THRU TISP3350H3SL
DUAL BIDIRECTIONAL THYRISTOR OVERVOLTAGE PROTECTORS
P R O D U C T I N F O R M A T I O N
APPLICATIONS INFORMATION
impulse testing
To verify the withstand capability and safety of the equipment, standards require that the equipment is tested
with various impulse wave forms. The table below shows some common values.
If the impulse generator current exceeds the protectors current rating then a series resistance can be used to
reduce the current to the protectors rated value and so prevent possible failure. The required value of series
resistance for a given waveform is given by the following calculations. First, the minimum total circuit
impedance is found by dividing the impulse generators peak voltage by the protectors rated current. The
impulse generators fictive impedance (generators peak voltage divided by peak short circuit current) is then
subtracted from the minimum total circuit impedance to give the required value of series resistance. In some
cases the equipment will require verification over a temperature range. By using the rated waveform values
from Figure 10, the appropriate series resistor value can be calculated for ambient temperatures in the range
of -40 °C to 85 °C.
a.c. power testing
The protector can withstand the G return currents applied for times not exceeding those shown in Figure 8.
Currents that exceed these times must be terminated or reduced to avoid protector failure. Fuses, PTC
(Positive Temperature Coefficient) resistors and fusible resistors are overcurrent protection devices which can
be used to reduce the current flow. Protective fuses may range from a few hundred milliamperes to one
ampere. In some cases it may be necessary to add some extra series resistance to prevent the fuse opening
during impulse testing. The current versus time characteristic of the overcurrent protector must be below the
line shown in Figure 8. In some cases there may be a further time limit imposed by the test standard (e.g. UL
1459 wiring simulator failure).
capacitance
The protector characteristic off-state capacitance values are given for d.c. bias voltage, V
D
, values of 0, -1 V,
-2 V and -50 V. Where possible values are also given for -100 V. Values for other voltages may be calculated
by multiplying the V
D
= 0 capacitance value by the factor given in Figure 6. Up to 10 MHz the capacitance is
essentially independent of frequency. Above 10 MHz the effective capacitance is strongly dependent on
connection inductance. In many applications, the typical conductor bias voltages will be about -2 V and -50 V.
Figure 7 shows the differential (line unbalance) capacitance caused by biasing one protector at -2 V and the
other at -50 V.
STANDARD
PEAK VOLTAGE
SETTING
V
2500
1000
1500
800
1500
1000
1500
1500
4000
VOLTAGE
WAVE FORM
μs
2/10
10/1000
10/160
10/560
9/720
9/720
0.5/700
PEAK CURRENT
VALUE
A
500
100
200
100
37.5
25
37.5
37.5
100
CURRENT
WAVE FORM
μs
2/10
10/1000
10/160
10/560
5/320
5/320
0.2/310
TISP3xxxH3
25 °C RATING
A
500
100
250
160
200
200
200
SERIES
RESISTANCE
GR-1089-CORE
0
FCC Part 68
(March 1998)
0
0
0
0
0
I3124
ITU-T K20/K21
10/700
5/310
200
0
FCC Part 68 terminology for the waveforms produced by the ITU-T recommendation K21 10/700 impulse generator
相關PDF資料 |
PDF描述 |
|---|---|
| TISP3072F3 | DUAL SYMMETRICAL TRANSIENT VOLTAGE SUPPRESSORS |
| TISP3082L | DUAL SYMMETRICAL TRANSIENT VOLTAGE SUPPRESSORS |
| TISP3082 | DUAL SYMMETRICAL TRANSIENT VOLTAGE SUPPRESSORS |
| TISP3082F3 | IC, CLOCK PLL, DTV |
| TISP3150F3 | DUAL SYMMETRICAL TRANSIENT VOLTAGE SUPPRESSORS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TISP3095H3SLS | 制造商:Bourns Inc 功能描述: |
| TISP3095H3SL-S | 功能描述:硅對稱二端開關元件 Dual Bidirectional overvolt protecter RoHS:否 制造商:Bourns 轉折電流 VBO:40 V 最大轉折電流 IBO:800 mA 不重復通態電流: 額定重復關閉狀態電壓 VDRM:25 V 關閉狀態漏泄電流（在 VDRM IDRM 下）: 保持電流（Ih 最大值）:50 mA 開啟狀態電壓:5 V 關閉狀態電容 CO:120 pF 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:DO-214AA |
| TISP3095T3 | 制造商:BOURNS 制造商全稱:Bourns Electronic Solutions 功能描述:Overvoltage Protector Series |
| TISP30XXF3 | 制造商:BOURNS 制造商全稱:Bourns Electronic Solutions 功能描述:LOW-VOLTAGE DUAL BIDIRECTIONAL THYRISTOR OVERVOLTAGE PROTECTORS |
| TISP3115H3 | 制造商:BOURNS 制造商全稱:Bourns Electronic Solutions 功能描述:Overvoltage Protector Series |
發布緊急采購，3分鐘左右您將得到回復。