- 您現在的位置：買賣IC網 > PDF目錄384973 > TH7111 (Electronic Theatre Controls, Inc.) FSK /FM/ASK Receiver PDF資料下載
參數資料
| 型號： | TH7111 |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | FSK /FM/ASK Receiver |
| 中文描述： | FSK信號/調頻/ ASK接收機 |
| 文件頁數： | 2/20頁 |
| 文件大?。?/td> | 705K |
| 代理商： | TH7111 |
TH7111
868/915MHz
FSK/FM/ASK Receiver
TH7111 Data Sheet
3901007111
Page 2 of 20
Nov. 2001
Rev. 005
General Desc ription
The TH7111 receiver IC consists of the following building blocks:
"
"
PLL synthesizer (PLL SYNTH) for generation of the first and second local oscillator signals LO1 and LO2
Parts of the PLL SYNTH are the high-frequency VCO1, the feedback dividers DIV_16 and DIV_2,
a phase-frequency detector (PFD) with charge pump (CP) and a crystal-based reference oscillator (RO)
Low-noise amplifier (LNA) for high-sensitivity RF signal reception
First mixer (MIX1) for down-conversion of the RF signal to the first IF (IF1)
second mixer (MIX2) for down-conversion of the IF1 to the second IF (IF2)
IF amplifier (IFA) to amplify and limit the IF2 signal and for RSSI generation
Phase coincidence demodulator (DEMOD) with third mixer (MIX3) to demodulate the IF signal
Operational amplifier (OA) for data slicing, filtering, ASK detection and automatic-frequency control (AFC)
Bias circuitry for bandgap biasing and circuit shutdown
"
"
"
"
"
"
"
With the TH7111 receiver chip, various circuit configurations can be arranged in order to meet a number of
different customer requirements. For FM/FSK reception the IF tank used in the phase coincidence demodu-
lator can be constituted either by a ceramic resonator or an LC tank (optionally with varactor to create an AFC
circuit). In PLL demodulator configuration, the multiplier MIX3 forms a phase comparator. In ASK configurati-
on, the RSSI signal is feed to an ASK detector, which is constituted by the operational amplifier. The second
VCO (VCO2) can be used either as the VCO of a PLL demodulator or as the LO2 source of a second exter-
nal PLL in a multi-channel system. The following table briefly summarizes the various configurations.
Single-conversion configuration
Double-conversion configuration
FM/FSK
narrow-band RX with ceramic demodulation
tank
wide-band RX with LC demod. tank and AFC
narrow-band RX with ceramic demodulation
tank
wide-band RX with LC demod. tank and AFC
FM/FSK
FM/FSK
FM/FSK
extended sensitivity RX with PLL demodulator
extended sensitivity RX with PLL demodulator
multi-channel RX with ceramic demodulation
tank and external channel synthesizer
RX with RSSI-based demodulation
ASK
ASK
RX with RSSI-based demodulation
RX with RSSI-based demodulation and exter-
nal channel synthesizer
The preferred superheterodyne configuration is
double conversion
where MIX1 and MIX2 are driven by the
internal local oscillator signals LO1 and LO2, respectively. This allows a
high degree of image rejection
,
achieved in conjunction with an RF front-end filter. Efficient RF front-end filtering is realized by using a SAW,
ceramic or helix filter in front of the LNA and by adding a LC filter at the LNA output.
It is also possible to use the TH7111 in
single-conversion
configuration. This can be achieved by switching
the LO2 input of MIX2 from the on-chip PLL synthesizer to the pin IN_MIX2 by means of an internal switch
(done via pin SW_MIX2). Now MIX2 operates as an amplifier for the IF1 signal if an external pull-down re-
sistor at pin IN_MIX2 is added.
The same setting of MIX2 can be used for
multi-channel applications
. In this situation IN_MIX2 must be
driven by an external LO2 signal. This signal can be generated by the VCO2, which is mainly a bipolar tran-
sistor that can be configured as a varactor-tuned VCO. Furthermore, a second external PLL for channel
selection via LO2 tuning is required. This may be arranged by using a PLL synthesizer chip that can be con-
trolled through a 3-wire bus serial interface. The reference signal for the external PLL synthesizer can be
directly taken from the crystal-based reference oscillator RO.
相關PDF資料 |
PDF描述 |
|---|---|
| TH7121 | 300 to 930MHz FSK/FM/ASK Transceiver |
| TH8080 | Single LIN Bus Transceiver |
| TH8080JDC | Single LIN Bus Transceiver |
| THAT1240 | Balanced Line Receiver ICs |
| THAT1243 | Balanced Line Receiver ICs |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TH71111 | 制造商:MELEXIS 制造商全稱:Melexis Microelectronic Systems 功能描述:868/915MHz FSK/FM/ASK Receiver |
| TH71111ENE | 制造商:MELEXIS 制造商全稱:Melexis Microelectronic Systems 功能描述:868/915MHz FSK/FM/ASK Receiver |
| TH71111ENE-BAA-000-RE | 制造商:Melexis Semiconductors 功能描述:IC RECEIVER FSK/FM/ASK 32LQFP |
| TH71111ENE-BAA-000-TR | 功能描述:IC RECEIVER SGL CONV 32-LQFP RoHS:否 類別:RF/IF 和 RFID >> RF 接收器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS 產品變化通告:Product Discontinuation 09/Jan/2012 標準包裝:50 系列:* 頻率:850MHz ~ 2.175GHz 靈敏度:- 數據傳輸率 - 最大:- 調制或協議:- 應用:* 電流 - 接收:* 數據接口:PCB，表面貼裝 存儲容量:- 天線連接器:PCB，表面貼裝 特點:- 電源電壓:4.75 V ~ 5.25 V 工作溫度:0°C ~ 85°C 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（6x6） 包裝:托盤 |
| TH71112 | 制造商:MELEXIS 制造商全稱:Melexis Microelectronic Systems 功能描述:868/915MHz FSK/FM/ASK Receiver |
發布緊急采購，3分鐘左右您將得到回復。