- 您現在的位置：買賣IC網 > PDF目錄384969 > TFA3354 (Electronic Theatre Controls, Inc.) Control and Monitoring IC for Electronic Ballasts PDF資料下載
參數資料
| 型號： | TFA3354 |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | Control and Monitoring IC for Electronic Ballasts |
| 中文描述： | 控制與監測集成電路電子鎮流器 |
| 文件頁數： | 5/12頁 |
| 文件大?。?/td> | 123K |
| 代理商： | TFA3354 |
Pin 3
TR
Trigger and Turn-off Output
This pin realizes three functions:
Delivery of trigger pulses with a repetition instalment of 960 μs, a pulse width of 1 μs and a current flow of
600 mA with 10
resistance.
Monitoring of the control signals up to a frequency of 100 kHz and a minimum amplitude of 400 mV. The
oscillation detector gates trigger pulses, if a minimum three periode burst indicated during the trigger pulse
repetition rate.
Attenuation of the oscillations by a turn-off transistor with a low saturation voltage.
Negative pulses may be applied at pin TR according the specification. Negative voltage peaks can cause an
increase of the current consumption. An external Schottky diode between TR and ground prevents this.
Pin 4
GND
Connection to ground
Pin 5
EI
Error Indication
At pin 5 it is possible to indicate different error values.
A static error signal greater than 3.75 V, which is supplied by a suitable network at pin 5 releases after one
second by means of an error enquiry cycle the storage of the error.
Furthermore the IC allows to supervise high-frequency oscillations.
An elaborate enquiry routine has been set up for secure and reliable acquisition of errors under consideration of
distortions. This routine consists of the valuation time of 840 μs with following evaluation time of 120 μs. These two
periods make the enquiry cycle repeating continuously, when no error signal is stored.
Signals with an amplitude > 3.75 V and a minimum duration of 1 μs are valuated as errors. If such events happen
at least 4 times within a time window of 840 μs, or a level > 3.75 V is statically applied, a counter starts to realize a
delay time of one second.
If those signals are detected again in the following valuation cycle, the error memory is setted.
This enquiry system saves that the RF-amplitude of the oscillating frequency is supervised, so that feed backs of
damaged lamps on the oscillation circuit would be detected.
The kind of lamp damage is depending on the type and sample of lamp. That is the reason for an adaptive
network for error detection, therefore the input EI is universal applicable.
Pin 6
LW
Input of Lamp Change
This input serves to detect a lamp change and cause a re-start with simultaneous reset of the error memory.
Input LW detects whether a lamp is connected, when a voltage > 4.25 V is applied.
A voltage < 3.25 V indicates a lamp as removed.
Is a lamp exchanged after a stored error, the error memory is reset and the trigger stop is activated.
The circuit is blocked without lamp. By removal a lamp the trigger gate is opened.
With a normal lamp change under operational conditions, triggers are continuously generated with lamp removed,
therefore, the circuit starts oscillation immediately by exchange of lamp.
The switching level for lamp change will be provided by a special circuitry.
For internal testing purposes at the input LW will be applied a special test level that decreases the internal time
response by factor 16.
This divider factor is active, if V
LW
is more than 2 V above V
CC
, but limited by max.15 V. Pay attention that the
voltage difference between V
CC
and V
LW
do not has to increase above 6 V also in case of supply voltage break
down.
Pin 7
S
Switching Output
The switching output enables the control of the preheat duration of the coiled filament by means of an additional
circuit to be selected by the customer.
The switching output is an open collector output which is low active for one second during the phase of start. It is
able to drive a maximum current of 1 mA at a typical saturation voltage of 200 mV.
4
09/00
TFA3354
相關PDF資料 |
PDF描述 |
|---|---|
| TFBS4650 | Standard IrDA with Low Power Consumption; Small Foodprint; |
| TFBS4650-TR1 | Infrared Transceiver 9.6 kbit/s to 115.2 kbit/s (SIR) |
| TFBS4650-TR3 | Infrared Transceiver 9.6 kbit/s to 115.2 kbit/s (SIR) |
| TFBS4710 | Serial Infrared Transceiver SIR, 115.2 kbit/s, 2.7 V to 5.5 V Operation |
| TFBS4710-TR1 | Serial Infrared Transceiver SIR, 115.2 kbit/s, 2.7 V to 5.5 V Operation |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TFA37 | 制造商:SANKEN 制造商全稱:Sanken electric 功能描述:Reverse Blocking Triode Thyristor |
| TFA37I | 制造商:SANKEN 制造商全稱:Sanken electric 功能描述:Reverse Blocking Triode Thyristor |
| TFA37S | 制造商:Sanken Electric Co Ltd 功能描述:THYRISTOR |
| TFA38 | 制造商:SANKEN 制造商全稱:Sanken electric 功能描述:Reverse Blocking Triode Thyristor |
| TFA38I | 制造商:SANKEN 制造商全稱:Sanken electric 功能描述:Reverse Blocking Triode Thyristor |
發布緊急采購，3分鐘左右您將得到回復。