參數資料
型號: TEA1762T/N2/DG,118
廠商: NXP Semiconductors
文件頁數: 5/15頁
文件大小: 82K
描述: IC CTLR SMPS SW SO14
產品培訓模塊: GreenChip Synchronous Rectification Control Family of ICs
標準包裝: 1
模式: 間歇導電(DCM)
電源電壓: 8.6 V ~ 38 V
工作溫度: -20°C ~ 150°C
安裝類型: 表面貼裝
封裝/外殼: 14-SOIC(0.154",3.90mm 寬)
供應商設備封裝: 14-SO
包裝: 標準包裝
其它名稱: 568-5348-6
TEA1762T_2
?NXP B.V. 2007. All rights reserved.
Product data sheet
Rev. 02  25 April 2007
5 of 15
NXP Semiconductors
TEA1762T
GreenChip synchronous rectier controller
7.3  SMPS output voltage and current regulation
The output voltage of the yback Switched Mode Power Supply (SMPS) can be controlled
by sensing the output voltage via the VSENSE pin. The feedback loop via the primary
controller can regulate the output voltage of the switched mode power supply by
regulating the voltage on the VSENSE pin to 2.5 V above the voltage on pin SENSEGND.
Also the output current of the yback SMPS can be controlled or limited. The voltage on
the ISENSE pin is regulated or limited to 50 mV above the voltage on pin POWERGND.
7.4  Opto outputs
The opto output is intended to drive an opto coupler (see
Figure
5). The opto outputs have
an open drain output conguration. The maximum sink current is internally limited to 5 mA
(typical). The outputs are linearly controlled via the VSENSE and ISENSE input pins. An
over-temperature situation will switch the protection opto output (OPTOPROT) to its
maximum sink current.
During start-up (V
CC
< V
startup
) and undervoltage lock-out the outputs are disabled.
7.5  Protection input
The PROTECT pin is a general purpose input pin which can be used for additional
protection of the switched mode power supply. With a Negative Temperature Coefcient
(NTC) thermistor external temperature protection can be provided, e.g. the external power
switches and transformer can be protected against high temperatures. With a Zener diode
a secondary overvoltage protection can be made.
7.6  Reference voltage output
The reference voltage output pin can be used for supplying external circuitry. The
maximum output current must be limited to 1 mA.
The reference voltage is activated as soon as the start-up voltage is reached on the V
CC
pin and switched off again after the V
CC
 pin voltage drops below the V
CC
 stop level.
7.7  Supply management
All (internal) reference voltages are derived from a temperature compensated, on-chip
band gap circuit. The reference voltage is trimmed to an accuracy within 1 %.
7.8  OverTemperature Protection (OTP)
The IC provides an accurate internal overtemperature protection of 150 癈 (typical). The
IC will maximize the current of pin OPTOPROT as soon as the internal temperature limit is
reached. The opto signal can be used on the primary side of the yback controller to
activate the SMPS protection or limit the output power. As soon as the overtemperature
condition is solved, normal operation will resume.
相關PDF資料
PDF描述
TEA1791T/N1,118 IC CTRLR GREENCHIP SYNC 8-SOIC
TMP03FS-REEL IC SENSOR TEMP/SERIAL OC 8SOIC
TMP141AIDBVTG4 IC TEMP SENSOR DGTL OUT SOT23-6
TMP401AIDGKTG4 IC TEMP SENSOR DGTL OUT 8-MSOP
TPS2346PWRG4 IC HOT SWAP POWER MGR 24-TSSOP
相關代理商/技術參數
參數描述
TEA1771 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:GreenChip PC primary control IC
TEA1771T/N2,518 功能描述:DC/DC 開關控制器 TEA1771T/SO24/REEL13DP//N2 RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
TEA1781T 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:GreenChip PC secondary control ICs
TEA1781T/N2,518 功能描述:DC/DC 開關控制器 TEA1781T/SO28/REEL13DP//N2 RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
TEA1782T 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:GreenChip PC secondary control ICs