參數資料
型號: TDA9898HL/V2/S1
廠商: NXP SEMICONDUCTORS
元件分類: 消費家電
英文描述: SPECIALTY CONSUMER CIRCUIT, PQFP48
封裝: 7 X 7 MM, 1.40 MM HEIGHT, PLASTIC, SOT313-2, MS-026, LQFP-48
文件頁數: 86/103頁
文件大?。?/td> 511K
代理商: TDA9898HL/V2/S1
TDA9897_TDA9898_3
NXP B.V. 2008. All rights reserved.
Product data sheet
Rev. 03 — 11 January 2008
83 of 103
NXP Semiconductors
TDA9897; TDA9898
Multistandard hybrid IF processing
[3]
Output current can be increased by application of single-ended resistor from each output pin to GND. Recommended resistor value is
minimum 1 k
.
[4]
With single-ended load for fIF < 45 MHz RL ≥ 1k and CL ≤ 5 pF to ground and for fIF = 45 MHz to 60 MHz RL =1k and CL ≤ 3 pF to
ground.
[5]
Noise level is measured without input signal but AGC adjusted corresponding to the given input level.
[6]
Set with AGC nominal output voltage as reference. For C/N measurement switch input signal off.
[7]
With single-ended load RL ≥ 1k and CL ≤ 5 pF to ground.
[8]
The tolerance of the reference frequency determines the accuracy of VIF AFC, RIF AFC, FM demodulator center frequency, maximum
FM deviation, sound trap frequency, LIF band-pass cut-off frequency and ZIF low-pass cut-off frequency as well as the accuracy of the
synthesizer.
[9]
The value of Cpull determines the accuracy of the resonance frequency of the crystal. It depends on the used type of crystal.
[1]
Calculation of the PLL loop lter by using the following formulae, valid under the condition for the damping
factor d
≥ 1.2.
and
with the following
parameters
KO = VCO steepness (MHz/V),
N = divider ratio:
,
KD = phase frequency detector steepness (A/rad),
RLFSYN2 = synthesizer loop lter serial resistor (),
CLFSYN2 = synthesizer loop lter serial capacitor (F),
BLF(3dB) = 3 dB LF bandwidth (Hz),
d = damping factor.
[2]
If more than one frequency range is used in the application, then the smallest resistor value should be
applied.
Table 57.
Conversion synthesizer PLL; loop lter dimensions[1]
fVCO (MHz)
RLFSYN2 (k)[2]
CLFSYN2 (nF)
22 to 29.5
1.5
4.7
30 to 37.5
1.8
4.7
38 to 45.5
2.2
4.7
46 to 53.5
2.7
4.7
57
3.3
4.7
B
LF
3dB
()
K
O
N
-------K
DRLFSYN2
=
d
1
2
---R
LFSYN2
2
π
K
O
N
-------K
DCLFSYN2
=
N
f
VCO
0.5 MHz
--------------------
=
相關PDF資料
PDF描述
TDA9897HL/V2/S1 SPECIALTY CONSUMER CIRCUIT, PQFP48
TDA9897HN/V2 SPECIALTY CONSUMER CIRCUIT, PQCC48
TDA9910HW/8/C1 1-CH 12-BIT RESISTANCE LADDER ADC, PARALLEL ACCESS, PQFP48
TDA9917HW/12/C1 1-CH 8-BIT RESISTANCE LADDER ADC, PARALLEL ACCESS, PQFP48
TDA9917HW/25/C1 1-CH 8-BIT RESISTANCE LADDER ADC, PARALLEL ACCESS, PQFP48
相關代理商/技術參數
參數描述
TDA9898HN 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Multistandard hybrid IF processing
TDA9898HN/V2,518 功能描述:上下轉換器 MULTI APPL SYS RoHS:否 制造商:Texas Instruments 產品:Down Converters 射頻:52 MHz to 78 MHz 中頻:300 MHz LO頻率: 功率增益: P1dB: 工作電源電壓:1.8 V, 3.3 V 工作電源電流:120 mA 最大功率耗散:1 W 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-128
TDA9898HN/V2,551 功能描述:上下轉換器 MULTI APPL SYS RoHS:否 制造商:Texas Instruments 產品:Down Converters 射頻:52 MHz to 78 MHz 中頻:300 MHz LO頻率: 功率增益: P1dB: 工作電源電壓:1.8 V, 3.3 V 工作電源電流:120 mA 最大功率耗散:1 W 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-128
TDA9898HN/V2-S 功能描述:上下轉換器 MULTI APPL SYS FOR TERRESTR IF RoHS:否 制造商:Texas Instruments 產品:Down Converters 射頻:52 MHz to 78 MHz 中頻:300 MHz LO頻率: 功率增益: P1dB: 工作電源電壓:1.8 V, 3.3 V 工作電源電流:120 mA 最大功率耗散:1 W 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-128
TDA9898HN/V2-T 功能描述:上下轉換器 MULTI APPL SYS FOR TERRESTR IF RoHS:否 制造商:Texas Instruments 產品:Down Converters 射頻:52 MHz to 78 MHz 中頻:300 MHz LO頻率: 功率增益: P1dB: 工作電源電壓:1.8 V, 3.3 V 工作電源電流:120 mA 最大功率耗散:1 W 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-128