- 您現在的位置：買賣IC網 > PDF目錄383941 > TDA8551 (NXP SEMICONDUCTORS) 1 W BTL audio amplifier with digital volume control PDF資料下載
參數資料
| 型號： | TDA8551 |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 音頻控制 |
| 英文描述： | 1 W BTL audio amplifier with digital volume control |
| 中文描述： | 1 CHANNEL(S), VOLUME CONTROL CIRCUIT, PDIP8 |
| 封裝： | 0.300 INCH, PLASTIC, MO-001, SOT97-1, SC-504, DIP-8 |
| 文件頁數： | 8/20頁 |
| 文件大?。?/td> | 163K |
| 代理商： | TDA8551 |
1998 Feb 23
8
Philips Semiconductors
Product specification
1 W BTL audio amplifier with digital volume control
TDA8551
TEST AND APPLICATION INFORMATION
Fig.4 Test and application circuit.
handbook, full pagewidth
MGM560
20 k
TDA8551
5 k
8
15 k
15 k
C2
100
μ
F
C4
220
μ
F
C1
330 nF
C5
100 nF
C3
100
nF
2.2 k
R1
STANDBY/
MUTE/
OPERATING
VOLUME
CONTROL
2
MODE
7
R
R
8
5
3
operating
standby
VP
mute
UP
DOWN
volume
control
1
6
4
VP
VP
VP = 5 V
VP
Vi
SLAVE
MASTER
OUT
+
GND
OUT
IN
SVR
UP/DOWN
Reduction of the value of capacitor C2 results in a
decrease of the SVRR performance at low frequencies
(see Fig.9).
The UP/DOWN pin can be driven by a 3-state logic output
stage (microcontroller) without extra external components.
If the UP/DOWN pin is driven by push-buttons, then it is
advised to have an RC filter between the buttons and the
UP/DOWN pin. Advised values for the RC filter are 2.2 k
and 100 nF.
The volume control circuit responds to the trailing edge of
the pulse on the volume pin; connecting to V
P
results in a
one step (1.25 dB) higher gain; connecting to ground
results in a one step lower gain.
To avoid audible plops while switching the supply voltage
on and off pin MODE has to be connected to V
P
(standby
condition) during charge or discharge of the input and
SVRR capacitors.
The measured thermal resistance of the IC package is
highly dependent on the configuration and size of the
application board. Data may not be comparable between
different semiconductor manufacturers because the
application boards and test methods are not standardized
yet. In addition, the thermal performance of packages for a
specific application may be different than presented here,
because the configuration of the application boards
(copper area) may be different. Philips Semiconductors
uses FR-4 type application boards with 1 oz. copper traces
with solder coating. The measurements have been carried
out with vertical placed boards.
相關PDF資料 |
PDF描述 |
|---|---|
| TDA8552 | 2 x 1.4 W BTL audio amplifiers with digital volume control and headphone sensing |
| TDA8552T | 2 x 1.4 W BTL audio amplifiers with digital volume control and headphone sensing |
| TDA8763A | 10-bit high-speed low-power ADC |
| TDA8763 | 10-bit high-speed low-power ADC with internal reference regulator |
| TDA9151 | Transient Voltage Suppressor Diodes |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA8551T | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:1 W BTL audio amplifier with digital volume control |
| TDA8551T/N1 | 制造商:NXP Semiconductors 功能描述:Bulk 制造商:NXP Semiconductors 功能描述:AMP AUDIO PWR 1.4W MONO 8SOIC 制造商:NXP Semiconductors 功能描述:AMP, AUDIO, PWR, 1.4W, MONO, 8SOIC 制造商:NXP Semiconductors 功能描述:AMP, AUDIO, PWR, 1.4W, MONO, 8SOIC; Amplifier Class:AB; No. of Channels:1; Output Power:1.4W; Supply Voltage Range:2.7V to 5.5V; Amplifier Case Style:SOIC; No. of Pins:8; Load Impedance:8ohm; Operating Temperature Min:-40C; ;RoHS Compliant: Yes |
| TDA8551T/N1,112 | 功能描述:音頻放大器 1W CMOS PWR AMP VOL CTRL RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TDA8551T/N1,118 | 功能描述:音頻放大器 1W CMOS AMP+VOLCTR RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TDA8551T/N1,118-CUT TAPE | 制造商:NXP 功能描述:TDA8551 Series 1 W BTL Audio Amplifier with Digital Volume Control - SOIC-8 |
發布緊急采購，3分鐘左右您將得到回復。