- 您現在的位置：買賣IC網 > PDF目錄98198 > TDA7575BPDTR (STMICROELECTRONICS) 50 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO36 PDF資料下載
參數資料
| 型號： | TDA7575BPDTR |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | 50 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO36 |
| 封裝： | ROHS COMPLIANT, SOP-36 |
| 文件頁數： | 18/32頁 |
| 文件大小： | 487K |
| 代理商： | TDA7575BPDTR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
TDA7575B
Diagnostics functional description
Doc ID 14103 Rev 2
7.2
Permanent diagnostics
Detectable conventional faults are:
–
Short to GND
–Short to Vs
–
Short across the speaker
The following additional features are provided:
–
Output offset detection
The TDA7575B has 2 operating statuses:
1.
RESTART mode. The diagnostic is not enabled. Each audio channel operates
independently from each other. If any of the a.m. faults occurs, only the channel(s)
interested is shut down. A check of the output status is made every 1 ms (fig. 30).
Restart takes place when the overload is removed.
2.
DIAGNOSTIC mode. It is enabled via I2C bus and self activates if an output overload
(such to cause the intervention of the short-circuit protection) occurs to the speakers
outputs. Once activated, the diagnostics procedure develops as follows (fig. 31):
–
To avoid momentary re-circulation spikes from giving erroneous diagnostics, a
check of the output status is made after 1ms: if normal situation (no overloads) is
detected, the diagnostic is not performed and the channel returns back active.
–
Instead, if an overload is detected during the check after 1 ms, then a diagnostic
cycle having a duration of about 100 ms is started.
–
After a diagnostic cycle, the audio channel interested by the fault is switched to
RESTART mode. The relevant data are stored inside the device and can be read
by the microprocessor. When one cycle has terminated, the next one is activated
by an I2C reading. This is to ensure continuous diagnostics throughout the car-
radio operating time.
–
To check the status of the device a sampling system is needed. The timing is
chosen at microprocessor level (over than half a second is recommended).
Figure 35.
Restart timing without diagnostic enable (permanent)
each 1ms time, a sampling of the fault is done
Figure 36.
Restart timing with diagnostic enable (permanent)
circuit protection intervention
t
1-2mS
1mS
Overcurrent and short
(i.e. short circuit to GND)
Short circuit removed
Out
circuit protection intervention
t
Overcurrent and short
(i.e. short circuit to GND)
Short circuit removed
1mS
100mS
1mS
相關PDF資料 |
PDF描述 |
|---|---|
| TDA7575BPD | 50 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO36 |
| TDA7575B | 50 W, 2 CHANNEL, AUDIO AMPLIFIER, ZFM27 |
| TDA7575 | 50 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO36 |
| TDA758013TR | SPECIALTY CONSUMER CIRCUIT, PQFP64 |
| TDA7580 | SPECIALTY CONSUMER CIRCUIT, PQFP64 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA7575PD | 功能描述:音頻放大器 INFOTAINMENT S PWR RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TDA7575PDTR | 功能描述:音頻放大器 INFOTAINMENT S PWR RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TDA7576B | 制造商:STMicroelectronics 功能描述:Dual bridge MOSFET power amplifier for 24V systems |
| TDA7577BLV | 功能描述:Amplifier IC 2-Channel (Stereo) Class AB 27-Flexiwatt (Vertical) 制造商:stmicroelectronics 系列:- 包裝:管件 零件狀態:有效 類型:AB 類 輸出類型:2 通道（立體聲） 不同負載時的最大輸出功率 x 通道數:45W x 2 @ 4 歐姆 電壓 - 電源:6 V ~ 18 V 特性:靜音，短路保護，待機 安裝類型:通孔 工作溫度:-40°C ~ 105°C（TA） 供應商器件封裝:27 Flexiwatt（垂直） 封裝/外殼:27 Flexiwatt（成型引線） 標準包裝:17 |
| TDA7577LV | 制造商:STMicroelectronics 功能描述:ABD AUDIO & POWER - Rail/Tube 制造商:STMicroelectronics 功能描述:Dual BTL output pwr amplifier for 24 V |
發布緊急采購，3分鐘左右您將得到回復。