- 您現在的位置：買賣IC網 > PDF目錄98198 > TDA7563B (STMICROELECTRONICS) 50 W, 4 CHANNEL, AUDIO AMPLIFIER, PZFM27 PDF資料下載
參數資料
| 型號： | TDA7563B |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | 50 W, 4 CHANNEL, AUDIO AMPLIFIER, PZFM27 |
| 封裝： | ROHS COMPLIANT, FLEXIWATT-27 |
| 文件頁數： | 8/33頁 |
| 文件大?。?/td> | 465K |
| 代理商： | TDA7563B |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁
Diagnostics functional description
TDA7563B
Doc ID 12733 Rev 3
4.2
Permanent diagnostics
Detectable conventional faults are:
–
Short to GND
–Short to Vs
–
Short across the speaker
The following additional features are provided:
–
Output offset detection
The TDA7563B has 2 operating statuses:
1.
Restart mode. The diagnostic is not enabled. Each audio channel operates
independently from each other. If any of the a.m. faults occurs, only the channel(s)
interested is shut down. A check of the output status is made every 1 ms (Figure 25).
Restart takes place when the overload is removed.
2.
Diagnostic mode. It is enabled via I2C bus and self activates if an output overload (such
to cause the intervention of the short-circuit protection) occurs to the speakers outputs.
Once activated, the diagnostics procedure develops as follows (Figure 26):
–
To avoid momentary re-circulation spikes from giving erroneous diagnostics, a
check of the output status is made after 1ms: if normal situation (no overloads) is
detected, the diagnostic is not performed and the channel returns back active.
–
Instead, if an overload is detected during the check after 1 ms, then a diagnostic
cycle having a duration of about 100 ms is started.
–
After a diagnostic cycle, the audio channel interested by the fault is switched to
restart mode. The relevant data are stored inside the device and can be read by
the microprocessor. When one cycle has terminated, the next one is activated by
an I2C reading. This is to ensure continuous diagnostics throughout the car-radio
operating time.
–
To check the status of the device a sampling system is needed. The timing is
chosen at microprocessor level (over half a second is recommended).
Figure 25. Restart timing without diagnostic enable (permanent) - Each 1mS time, a
sampling of the fault is done
Figure 26. Restart timing with diagnostic enable (permanent)
t
1-2mS
1mS
Overcurrent and short
circuit protection intervention
(i.e. short circuit to GND)
Short circuit removed
Out
t
Overcurrent and short
circuit protection intervention
(i.e. short circuit to GND)
Short circuit removed
1-2mS
100/200mS
1mS
相關PDF資料 |
PDF描述 |
|---|---|
| TDA7563PDTR | 46 W, 4 CHANNEL, AUDIO AMPLIFIER, PDSO36 |
| TDA7563PD | 46 W, 4 CHANNEL, AUDIO AMPLIFIER, PDSO36 |
| TDA7563 | 46 W, 4 CHANNEL, AUDIO AMPLIFIER, PZFM27 |
| TDA7564BH | 50 W, 4 CHANNEL, AUDIO AMPLIFIER, ZFM25 |
| TDA7564B | 50 W, 4 CHANNEL, AUDIO AMPLIFIER, ZFM25 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA7563BH | 功能描述:音頻放大器 4 x 50W Multi Quad Power Amplifer D RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TDA7563BPD | 功能描述:音頻放大器 4 x 50W Multi Quad Power Amplifer D RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TDA7563BPDTR | 功能描述:音頻放大器 4 x 50W Multi Quad Power Amplifer D RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TDA7563H | 制造商:STMicroelectronics 功能描述: |
| TDA7563PD | 功能描述:音頻放大器 MULTIFUNCTION QUAD Pwr AMP RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。