- 您現在的位置：買賣IC網 > PDF目錄98198 > TDA7563 (STMICROELECTRONICS) 46 W, 4 CHANNEL, AUDIO AMPLIFIER, PZFM27 PDF資料下載
參數資料
| 型號： | TDA7563 |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | 46 W, 4 CHANNEL, AUDIO AMPLIFIER, PZFM27 |
| 封裝： | FLEXIWATT-27 |
| 文件頁數： | 3/20頁 |
| 文件大小： | 248K |
| 代理商： | TDA7563 |
11/20
TDA7563
– To avoid momentary re-circulation spikes from giving erroneous diagnostics, a check of the output sta-
tus is made after 1ms: if normal situation (no overloads) is detected, the diagnostic is not performed and
the channel returns back active.
– Instead, if an overload is detected during the check after 1 ms, then a diagnostic cycle having a duration
of about 100 ms is started.
– After a diagnostic cycle, the audio channel interested by the fault is switched to RESTART mode. The
relevant data are stored inside the device and can be read by the microprocessor. When one cycle has
terminated, the next one is activated by an I2C reading. This is to ensure continuous diagnostics
throughout the car-radio operating time.
– To check the status of the device a sampling system is needed. The timing is chosen at microprocessor
level (over half a second is recommended).
Figure 19. Restart timing without Diagnostic Enable (Permanent) - Each 1mS time, a sampling of
the fault is done
Figure 20. Restart timing with Diagnostic Enable (Permanent)
OUTPUT DC OFFSET DETECTION
Any DC output offset exceeding +/- 2 V are signalled out. This inconvenient might occur as a consequence of
initially defective or aged and worn-out input capacitors feeding a DC component to the inputs, so putting the
speakers at risk of overheating.
This diagnostic has to be performed with low-level output AC signal (or Vin = 0).
The test is run with selectable time duration by microprocessor (from a "start" to a "stop" command):
– START = Last reading operation or setting IB1 - D5 - (OFFSET enable) to 1
t
1-2mS
1mS
Overcurrent and short
circuit protection intervention
(i.e. short circuit to GND)
Short circuit removed
Out
t
Overcurrent and short
circuit protection intervention
(i.e. short circuit to GND)
Short circuit removed
1-2mS
100/200mS
1mS
相關PDF資料 |
PDF描述 |
|---|---|
| TDA7564BH | 50 W, 4 CHANNEL, AUDIO AMPLIFIER, ZFM25 |
| TDA7564B | 50 W, 4 CHANNEL, AUDIO AMPLIFIER, ZFM25 |
| TDA7564BPDTR | 50 W, 4 CHANNEL, AUDIO AMPLIFIER, PDSO36 |
| TDA7564BPD | 50 W, 4 CHANNEL, AUDIO AMPLIFIER, PDSO36 |
| TDA7564 | 46 W, 4 CHANNEL, AUDIO AMPLIFIER, PZFM25 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA7563A | 功能描述:音頻放大器 4 x 50W Multi Quad Power Amplifer D RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TDA7563AH | 功能描述:音頻放大器 4 x 50W Multi Quad Power Amplifer D RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TDA7563APD | 功能描述:音頻放大器 4 x 50W Multi Quad Power Amplifer D RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TDA7563APDTR | 功能描述:音頻放大器 4x28V 4Ohm 14.4V High Eff Quad Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TDA7563ASM | 功能描述:音頻放大器 4 x 50W Multi Quad Power Amplifer D RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。