參數資料
型號: TDA7512
廠商: STMICROELECTRONICS
元件分類: 接收器
英文描述: AM/FM, AUDIO SINGLE CHIP RECEIVER, PQFP64
封裝: TQFP-64
文件頁數: 10/43頁
文件大?。?/td> 833K
代理商: TDA7512
TDA7512
18/42
narrow filtered IF2 before demodulation. A switch controlled by IF counter mode (IFCM) is chosing the input sig-
nal for IF counter.
The grade of integration is adjustable by eight different measuring cycle times. The tolerance of the accepted
count value is adjustable, to reach an optimum compromise for search speed and precision of the evaluation.
1.7.8
The IF-Counter Mode
The IF counter works in 3 modes controlled by IFCM register.
1.7.9
Sampling Timer
A sampling timer generates the gate signal for the main counter. The basically sampling time are in FM mode
6.25kHz (tTIM=160s) and in AM mode 1kHz (tTIM=1ms). This is followed by an asynchronous divider to gener-
ate several sampling times.
1.7.10 Intermediate Frequency Main Counter
This counter is a 11 - 21-bit synchronous autoreload down counter. Five bits (CF) are programmable to have
the possibility for an adjust to the centre frequency of the IF-filter. The counter length is automatic adjusted to
the chosen sampling time and the counter mode (FM, AM-UPC, AM).
At the start the counter will be loaded with a defined value which is an equivalent to the divider value
(tSample xfIF).
If a correct frequency is applied to the IF counter frequency input at the end of the sampling time the main
counter is changing its state from 0h to 1FFFFFh.
This is detected by a control logic and an external search stop output is changing from LOW to HIGH. The fre-
quency range inside which a successful count result is adjustable by the EW bits.
tCNT = (CF + 1696+1) / fIF
FM mode
tCNT = (CF + 10688+1) / fIF
AM up conversion mode
tCNT = (CF + 488+1) / fIF
AM mode
Counter result succeeded:
tTIM
tCNT - tERR
tTIM tCNT + tERR
Counter result failed:
tTIM > tCNT + tERR
tTIM < tCNT - tERR
tTIM = IF timer cycle time (sampling time)
tCNT = IF counter cycle time
tERR = discrimination window (controlled by the EW registers)
The IF counter is only started by inlock information from the PLL part. It is enabled by software (IFENA).
1.7.11 Adjustment of the Measurement Sequence Time
The precision of the measurements is adjustable by controlling the discrimination window. This is adjustable by
programming the control registers EW.
The measurement time per cycle is adjustable by setting the registers IFS.
1.7.12 Adjust of the Frequency Value
The center frequency of the discrimination window is adjustable by the control registers CF.
相關PDF資料
PDF描述
TDA7513T AM/FM, AUDIO SINGLE CHIP RECEIVER, PQFP80
TDA7521 SPECIALTY ANALOG CIRCUIT, PQFP44
TDA7528 SPECIALTY CONSUMER CIRCUIT, PQFP64
TDA7531 SPECIALTY CONSUMER CIRCUIT, PQFP64
TDA7535013TR SERIAL INPUT LOADING, 20-BIT DAC, PDSO14
相關代理商/技術參數
參數描述
TDA7512F 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:FM car-radio tuner IC with intelligent selectivity system (ISS)
TDA7513T 制造商:STMicroelectronics 功能描述:
TDA7513T_07 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Single chip FM/AM tuner with stereo decoder and audio processor
TDA7514 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:SINGLE-CHIP FM/AM TUNER WITH STEREO DECODER AND AUDIO PROCESSOR
TDA7515 功能描述:音頻 DSP RF Front End RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube