參數資料
型號： TDA7402TR
廠商： STMICROELECTRONICS
元件分類： 消費家電
英文描述： SPECIALTY CONSUMER CIRCUIT, PQFP44
封裝： 10 X 10 MM, 1.40 MM HEIGHT, TQFP-44
文件頁數： 41/74頁
文件大?。?/td> 1232K
代理商： TDA7402TR
Functional description of the noise blanker
TDA7402
7.3
Additional threshold control mechanism
7.3.1
Automatic threshold control by the stereo blend voltage
Besides the noise controlled threshold adjustment there is an additional possibility for
influencing the trigger threshold which depends on the stereo blend control.
The point where the MPX signal starts to become noisy is fixed by the RF part. Therefore
also the starting point of the normal noise-controlled trigger adjustment is fixed (
In some cases the behavior of the noiseblanker can be improved by increasing the threshold
even in a region of higher fieldstrength. Sometimes a wrong triggering occurs for the MPX
signal often shows distortion in this range which can be avoided even if using a low
threshold. Because of the overlap of this range and the range of the stereo/mono transition it
can be controlled by stereo blend. This increase of the threshold is programmable in 3 steps
or switched off.
7.3.2
Over deviation detector
If the system is tuned to stations with a high deviation the noiseblanker can trigger on the
higher frequencies of the modulation or distortion. To avoid this behavior, which causes
audible noise in the output signal, the noiseblanker offers a deviation-dependent threshold
adjustment. By rectifying the MPX signal a further signal representing the actual deviation is
obtained. It is used to increase the PEAK voltage. Offset and gain of this circuit are
programmable in 3 steps with the bits D6 and D7 of the noiseblanker byte I (bit combination
'00' turns off the detector, see
7.3.3
Multipath level
To react on high repetitive spikes caused by a multipath-situation, the discharge time of the
PEAK voltage can be decreased depending on the voltage-level at pin MPout. The A619
offers a linear as well as a threshold driven control. The linear influence of the multipath level
on the PEAK-signal (D7 of multipath control byte) gives a discharge slewrate of 1V/ms
(1) .
The second possibility is to activate the threshold driven discharge which switches on the
18kOhm discharge if the multipath level is below 2.5V (D7 of noiseblanker byte II byte).
(1)
The slewrate is measured with RDischarge=infinite and VMPout=2.5V
7.3.4
AM mode of the noiseblanker
The A619 noiseblanker is also suitable for AM noise cancelling. The detector uses in AM
mode the 450kHz unfiltered IF output of the tuner for spike detection. A combination of
programmable gain stage and lowpass filter forms an envelope detector which drives the
noiseblanker's input via a 120kHz 1st order highpass. In order to blank the whole spike in
AM mode the hold-times of the sample and hold circuit are much longer then in FM (640s
to 1.2ms). All threshold controls can be used like in FM mode.
相關PDF資料
PDF描述
TDA7402 SPECIALTY CONSUMER CIRCUIT, PQFP44
TDA7403D SPECIALTY CONSUMER CIRCUIT, PDSO20
TDA7403DTR SPECIALTY CONSUMER CIRCUIT, PDSO20
TDA7404DTR 1 CHANNEL(S), TONE CONTROL CIRCUIT, PDSO28
TDA7404D 1 CHANNEL(S), TONE CONTROL CIRCUIT, PDSO28
相關代理商/技術參數
參數描述
TDA7403 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:BASIC SIGNAL PROCESSOR
TDA7403_02 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:BASIC SIGNAL PROCESSOR
TDA7403D 功能描述:音頻 DSP Basic Signal Process RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube
TDA7403DTR 功能描述:音頻 DSP Basic Signal Process RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube
TDA7404 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:CARRADIO-SIGNAL-PROCESSOR
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*