- 您現在的位置：買賣IC網 > PDF目錄383939 > TDA16846 (INFINEON TECHNOLOGIES AG) ICs for Consumer Electronics PDF資料下載
參數資料
| 型號： | TDA16846 |
| 廠商： | INFINEON TECHNOLOGIES AG |
| 英文描述： | ICs for Consumer Electronics |
| 中文描述： | 消費電子集成電路 |
| 文件頁數： | 5/28頁 |
| 文件大?。?/td> | 351K |
| 代理商： | TDA16846 |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
TDA 16846
TDA 16847
Data Sheet
5
2000-01-14
1.4
Short Description of the Pin Functions
Pin
1
Function
A parallel RC-circuit between this pin and ground determines the ringing
suppression time and the standby-frequency.
A capacitor between this pin and ground and a resistor between this pin and
the positive terminal of the primary elcap quantifies the max. possible output
power of the SMPS.
This is the input of the error amplifier and the zero crossing input. The output
of a voltage divider between the control winding and ground is connected to
this input. If the pulses at pin 3 exceed a 5 V threshold, the control voltage at
pin 4 is lowered.
This is the pin for the control voltage. A capacitor has to be connected
between this pin and ground. The value of this capacitor determines the
duration of the softstart and the speed of the control.
If an opto coupler for the control is used, it’s output has to be connected
between this pin and ground. The voltage divider at pin 3 has then to be
changed, so that the pulses at pin 3 are below 5 V.
Fault comparator 2: If a voltage > 1.2 V is applied to this pin, the SMPS stops.
If fixed frequency mode is wanted, a parallel RC circuit has to be connected
between this pin and ground. The RC-value determines the frequency. If
synchronized mode is wanted, sync pulses have to be fed into this pin.
Not connected (TDA 16846). / This is the power measurement output of the
Temporary High Power Circuit. A capacitor and a RC-circuit has to be
connected between this pin and ground (TDA 16847).
Output for reference voltage (5 V). With a resistor between this pin and ground
the fault comparator 2 (pin 6) is enabled.
Fault comparator 1: If a voltage > 1 V is applied to this pin, the SMPS stops.
This is the input of the primary voltage check. The voltage at the anode of the
primary elcap has to be fed to this pin via a voltage divider. If the voltage of
this pin falls below 1 V, the SMPS is switched off. A second function of this pin
is the primary voltage dependent fold back point correction (only active in free
running mode).
Common ground.
Output signal. This pin has to be connected across a serial resistor with the
gate of the power transistor.
Connection for supply voltage and startup capacitor. After startup the supply
voltage is produced by the control winding of the transformer and rectified by
an external diode.
2
3
4
5
6
7
8
9
10
11
12
13
14
相關PDF資料 |
PDF描述 |
|---|---|
| TDA16846G | ICs for Consumer Electronics |
| TDA16847 | ICs for Consumer Electronics |
| TDA16847G | ICs for Consumer Electronics |
| TDA16888 | High Performance Power Combi Controller |
| TDA16888G | High Performance Power Combi Controller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA16846_03 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Controller for Switch Mode Power Supplies Supporting Low Power Standby and Power Factor |
| TDA16846-2 | 功能描述:功率因數校正 IC CTRLR FOR SWITCH MODE PWR SUPPLIES RoHS:否 制造商:Fairchild Semiconductor 開關頻率:300 KHz 最大功率耗散: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Reel |
| TDA168462G | 制造商:Infineon Technologies AG 功能描述: |
| TDA16846-2G GEG | 功能描述:功率因數校正 IC CTRLR FOR SWITCH MODE PWR SUPPLIES RoHS:否 制造商:Fairchild Semiconductor 開關頻率:300 KHz 最大功率耗散: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Reel |
| TDA168462GGEGHUMA1 | 制造商:Infineon Technologies AG 功能描述:Power Factor Correction PWM CONTRLR 1mA 14-Pin DSO 制造商:Infineon Technologies AG 功能描述:IC POWER SUPPLY CONTROLLER DSO14 |
發布緊急采購，3分鐘左右您將得到回復。