- 您現在的位置：買賣IC網 > PDF目錄383988 > TDA1596 (NXP SEMICONDUCTORS) IF amplifier/demodulator for FM radio receivers PDF資料下載
參數資料
| 型號： | TDA1596 |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 接收器 |
| 英文描述： | IF amplifier/demodulator for FM radio receivers |
| 中文描述： | FM, AUDIO DEMODULATOR, PDIP18 |
| 封裝： | 0.300 INCH, PLASTIC, DIP-18 |
| 文件頁數： | 5/20頁 |
| 文件大?。?/td> | 346K |
| 代理商： | TDA1596 |
April 1991
5
Philips Semiconductors
Product specification
IF amplifier/demodulator for
FM radio receivers
TDA1596
FUNCTIONAL DESCRIPTION
Limiter-amplifier
This has five stages of IF amplification using balanced differential limiter-amplifiers with emitter-follower coupling.
Decoupling of the stages from the voltage supply lines and an internal high-ohmic DC feed-back loop give a very stable
IF performance. The amplifier gain is virtually independent from temperature changes.
FM demodulator
The demodulator is fully balanced and comprises two cross-coupled differential amplifiers. Quadrature detection of the
FM signal is performed by feeding one differential amplifier directly from the limiter-amplifier output, and the other via an
external 90
°
phase-shifting network. The demodulator has good stability and its zero cross-over shift is small.
The bandwidth of the demodulator output is restricted to approximately 1 MHz by an internal low-pass filter.
THD compensation
This circuit compensates non-linearities introduced by demodulation. For this to operate correctly the demodulator circuit
between pins 9 and 10 must have a loaded Q-factor of 19. Consequently there is no need for the demodulator tuned
circuit to be adjusted for minimum THD, instead the adjustment criterium is for a symmetrical stop pulse.
Mute attenuator and AF output
The control voltage for the mute attenuator at pin 14 is generated from the values of the level detector and the detuning
detector outputs. The mute attenuator has a fast attack and a slow decay which is determined by the capacitor at pin 14.
The AF signal is passed via the mute attenuator to the output at pin 4.
A weighted control voltage, available from pin 6, is obtained from the mute attenuator control voltage via a buffer-amplifier
which introduces an additional voltage shift and gain.
Level detector
The level detector generates a voltage output which is proportional to the field strength of the input signal.
The unweighted level detector output is available when the mode switch is operating in the FM, mute-on condition.
Tuning-stop outputs
The open collector outputs STOP-0 and STOP-1 (from pins 13 and 12 respectively) are voltages derived from the
detuning level and the field strength of the input signal. If only one tuning-stop output is required, pins 12 and 13 may be
tied together.
相關PDF資料 |
PDF描述 |
|---|---|
| TDA1596T | IF amplifier/demodulator for FM radio receivers |
| TDA1597 | IF amplifier/demodulator for FM radio receivers |
| TDA1597T | IF amplifier/demodulator for FM radio receivers |
| TDA1599 | IF amplifier/demodulator for FM radio receivers |
| TDA1599T | IF amplifier/demodulator for FM radio receivers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA1596T | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:IF amplifier/demodulator for FM radio receivers |
| TDA1596T/V3,512 | 功能描述:調諧器 IF AMP/DEM RoHS:否 制造商:NXP Semiconductors 功能: 噪聲系數: 工作電源電壓: 最小工作溫度: 最大工作溫度: |
| TDA1596T/V3,518 | 功能描述:調諧器 FM IF CIRCUIT RoHS:否 制造商:NXP Semiconductors 功能: 噪聲系數: 工作電源電壓: 最小工作溫度: 最大工作溫度: |
| TDA1596T/V3-T | 功能描述:調諧器 FM IF CIRCUIT RoHS:否 制造商:NXP Semiconductors 功能: 噪聲系數: 工作電源電壓: 最小工作溫度: 最大工作溫度: |
| TDA1596TD | 功能描述:射頻接收器 IF AMP/DEM FOR FM RADIO REC RoHS:否 制造商:Skyworks Solutions, Inc. 類型:GPS Receiver 封裝 / 箱體:QFN-24 工作頻率:4.092 MHz 工作電源電壓:3.3 V 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。