- 您現在的位置：買賣IC網 > PDF目錄384964 > tda 6612-2 (SIEMENS AG) TV-Stereo-Sound(TV 立體聲) PDF資料下載
參數資料
| 型號： | tda 6612-2 |
| 廠商： | SIEMENS AG |
| 英文描述： | TV-Stereo-Sound(TV 立體聲) |
| 中文描述： | 電視，立體音響（電視立體聲） |
| 文件頁數： | 4/47頁 |
| 文件大小： | 1967K |
| 代理商： | TDA 6612-2 |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁
Semiconductor Group
4
TDA 6612-2
center frequency of the filter is switched between "dual" and "stereo" by a multiplexer. The
multiplexing frequency is adjustable by software. If a side band is detected, the multiplexer stops.
The interferences on the first "detected" criterion are suppressed by a digital integrator with a
following comparator and can be read out via
I
2
C Bus (talk mode) as the "stereo" or "dual" mode.
The control of the corresponding signal can be either directly internally or through the
μ
C. All the
necessary clock signal are derived from a fast setting PLL which is synchronized by a reference
frequency. This reference frequency must be sufficiently close to the horizontal frequency, but a
rigid phase coupling is not required
. Therefore, alternatively the use of a crystal controlled 62.5-
kHz frequency commonly found in PLL-tuning systems is possible. A further alternative for the clock
signal generation is a build-in crystal oscillator with an external 4-MHz crystal or the use an external
1- or 4-MHz clock frequency.
Control Section
All functions are controlled via an
I
2
C Bus interface with "listen" / "talk" functions. The data bytes
currently used are stored in a block of latches.
The telegram structure is formed in the following manner:
start condition - chip address - any number of bytes - stop condition
The following conditions apply to the data bytes:
Before the actual data byte (with the adjustment information),
always
an
I
2
C Bus sub-address byte
has to be transmitted. The
I
2
C Bus interface however is interpreting this sub-address byte as a data
byte.
Example: The headphone volume is to be increased in a number of steps.
Within a telegram (i.e. without a new start condition) any different sub-addresses can be accessed.
The changeover between "listen" and "talk" access to the IC however must always occur using the
following sequence: stop condition - start condition - chip address. Before each read access always
a start condition and chip address (talk) must be transmitted. The data to be read out are then
loaded into the
I
2
C Bus interface and can be transferred to the
μ
C.
Right
Wrong
Start condition
Chip address 84 (Hex)
Sub-addr. vol. HP 03 (Hex)
Vol. step 8 08 (Hex)
Sub-addr. vol. HP 03 (Hex)
Vol. step 9 09 (Hex)
Sub-addr. vol. HP 03 (Hex)
Vol. step 10 0A (Hex)
Stop condition
Start condition
Chip address 84 (Hex)
Sub-addr. vol. HP 03 (Hex)
Vol. step 8 08 (Hex)
Vol. step 9 09 (Hex)
Vol. step 10 0A (Hex)
Stop condition
相關PDF資料 |
PDF描述 |
|---|---|
| tda 6621 | TV-Stereocoder(TV 立體聲編碼器) |
| tda 6812-5 | TV-Stereo Processor(TV 立體聲處理器) |
| tda 6920 | 7 x 5 Video Matrix Switch(視頻陣列開關) |
| tda 6930 | Multistandard VIF-PLL(多級標準的VIF-PLL) |
| TDA1006A | MOTOR REGULATOR WITH AUTOMATIC TAPE END INDICATOR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA6612-5 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:TV-STEREO-SOUND |
| TDA6612-5X | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:TV-STEREO-SOUND |
| TDA6650 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:5 V mixer/oscillator and low noise PLL synthesizer for hybrid terrestrial tuner (digital and analog) |
| TDA6650ATT | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:5 V mixer/oscillator and low noise PLL synthesizer for hybrid terrestrial tuner (digital and analog) |
| TDA6650ATT/C3 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:5 V mixer/oscillator and low noise PLL synthesizer for hybrid terrestrial tuner (digital and analog) |
發布緊急采購，3分鐘左右您將得到回復。