參數資料
型號： TC9402EJD
元件分類： 模擬專用變換器
英文描述： VOLTAGE-FREQUENCY CONVERTER, 0.1 MHz, CDIP14
封裝： CERDIP-14
文件頁數： 26/28頁
文件大?。?/td> 545K
代理商： TC9402EJD
2007 Microchip Technology Inc.
DS21483D-page 7
TC9400/9401/9402
2.6
Pulse Freq Out
This output is an open-drain N-channel FET, which
provides a pulse waveform whose frequency is propor-
tional to the input voltage. This output requires a pull-
up resistor and interfaces directly with MOS, CMOS,
and TTL logic (see Figure 2-1).
2.7
Output Common
The sources of both the FREQ/2 OUT and the PULSE
FREQ OUT are connected to this pin. An output level
swing from the drain voltage to ground, or to the VSS
supply, may be obtained by connecting this pin to the
appropriate point.
2.8
Freq/2 Out
This output is an open-drain N-channel FET, which
provides a square-wave one-half the frequency of the
pulse frequency output. The FREQ/2 OUT output will
change state on the rising edge of PULSE FREQ OUT.
This output requires a pull-up resistor and interfaces
directly with MOS, CMOS, and TTL logic.
2.9
Threshold Detector Input
In the V/F mode, this input is connected to the AMPLI-
FIER OUT output (Pin 12) and triggers a 3 s pulse
when the input voltage passes through its threshold. In
the F/V mode, the input frequency is applied to this
input.
The nominal threshold of the detector is half way
between the power supplies, or (VDD + VSS)/2 ±400
mV. The TC9400’s charge balancing V/F technique is
not dependent on a precision comparator threshold,
because the threshold only sets the lower limit of the op
amp output. The op amp’s peak-to-peak output swing,
which determines the frequency, is only influenced by
external capacitors and by VREF.
2.10
Amplifier Out
This pin is the output stage of the operational amplifier.
During V/F operation, a negative going ramp signal is
available at this pin. In the F/V mode, a voltage
proportional to the frequency input is generated.
FIGURE 2-1:
Output Waveforms.
3ms
Typ.
1/f
FOUT
FOUT/2
Amp Out
VREF
0V
CREF
CINT
Note 1: To adjust FMIN, set VIN = 10 mV and adjust the 50 kΩ offset for 10 Hz output.
2: To adjust FMAX, set VIN = 10V and adjust RIN or VREF for 10 kHz output.
3: To increase FOUTMAX to 100 kHz, change CREF to 2 pF and CINT to 75 pF.
4: For high performance applications, use high stability components for RIN, CREF. VREF (metal film
resistors and glass capacitors). Also, separate output ground (Pin 9) from input ground (Pin 6).
相關PDF資料
PDF描述
TC9400EJD VOLTAGE-FREQUENCY CONVERTER, 0.1 MHz, CDIP14
TC9404FNG PARALLEL, WORD INPUT LOADING, 1-BIT DAC, PDSO24
TC9404FN SERIAL INPUT LOADING, 1-BIT DAC, PDSO24
TC9404F 1-BIT DAC, PDSO24
TC9409BF SPECIALTY CONSUMER CIRCUIT, PQFP44
相關代理商/技術參數
參數描述
TC9404FN 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:MODULATION SYSTEM DA CONVERTER WITH ANALOG FILTER
TC9404FNG 制造商:Toshiba 功能描述:1Bit Cut Tape
TC9409BF 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:SINGLE CHIP KARAOKE LSI
TC9411 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:CD GRAPHICS DECODER
TC9411F 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:CD GRAPHICS DECODER
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*