- 您現在的位置：買賣IC網 > Datasheet目錄46 > TC9402EJD (Microchip Technology)IC V-FREQ/FREQ-V CONV 14CDIP Datasheet資料下載
參數資料
| 型號： | TC9402EJD |
| 廠商： | Microchip Technology |
| 文件頁數： | 14/28頁 |
| 文件大?。?/td> | 545K |
| 描述： | IC V-FREQ/FREQ-V CONV 14CDIP |
| 標準包裝： | 29 |
| 類型： | 電壓至頻率和頻率至電壓 |
| 頻率 - 最大： | 100kHz |
| 全量程： | ±100ppm/°C |
| 線性： | ±0.25% |
| 安裝類型： | 通孔 |
| 封裝/外殼： | 14-CDIP（0.300"，7.62mm） |
| 供應商設備封裝： | 14-CERDIP |
| 包裝： | 管件 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
TC9400/9401/9402
DS21483D-page 14
?2007 Microchip Technology Inc.
6.0 F/V CONVERTER DESIGN
INFORMATION
6.1 Input/Output Relationships
The output voltage is related to the input frequency
(F
IN
) by the transfer equation:
EQUATION 6-1:
The response time to a change in F
IN
is equal to (R
INT
C
INT
). The amount of ripple on V
OUT
is inversely
proportional to C
INT
and the input frequency.
C
INT
can be increased to lower the ripple. Values of
1礔 to 100礔 are perfectly acceptable for low frequen-
cies.
When the TC9400 is used in the Single Supply mode,
V
REF
is defined as the voltage difference between Pin7
and Pin 2.
6.2 Input Voltage Levels
The input frequency is applied to the Threshold
Detector input (Pin 11). As discussed in the V/F circuit
section of this data sheet, the threshold of Pin 11 is
approximately (V
DD
+ V
SS
)/2 ?00mV. Pin 11s input
voltage range extends from V
DD
to about 2.5V below
the threshold. If the voltage on Pin 11 goes more than
2.5 volts below the threshold, the V/F mode start-up
comparator will turn on and corrupt the output voltage.
The Threshold Detector input has about 200mV of
hysteresis.
In ?V applications, the input voltage levels for the
TC9400 are ?00mV, minimum. If the frequency
source being measured is unipolar, such as TTL or
CMOS operating from a +5V source, then an AC
coupled level shifter should be used. One such circuit
is shown in Figure6-1(a).
The level shifter circuit in Figure6-1(b) can be used in
single supply F/V applications. The resistor divider
ensures that the input threshold will track the supply
voltages. The diode clamp prevents the input from
going far enough in the negative direction to turn on the
start-up comparator. The diodes forward voltage
decreases by 2.1mV/癈, so for high ambient
temperature operation, two diodes in series are
recommended.
FIGURE 6-1: Frequency Input Level Shifter.
V
OUT
= [V
REF
C
REF
R
INT
] F
IN
+5V
14
6 4
+5V
-5V
V
DD
1.0
11
33k?/DIV>
IN914
V
SS
DET
TC9400
(a) ?V Supply
(b) Single Supply
0.01礔
Frequency
Input
0V
GND
+8V to +15V
14
10k?/DIV>
4
+5V
V
DD
1.0
11
33k?/DIV>
IN914
V
SS
DET
TC9400
0.01礔
Frequency
Input
0V
0.1礔
10k?/DIV>
M?/DIV>
M?/DIV>
相關PDF資料 |
PDF描述 |
|---|---|
| TCN75-5.0MUAG | IC TEMP SENSOR SRL 5.0V 8MSOP |
| TEA1750T/N1,518 | IC PFC CONTROLLER DCM16SOIC |
| TEA1751T/N1,518 | IC CTRLR GREENCHIP SMPS 16-SOIC |
| TEA1761T/N2,118 | IC CTRLR GREENCHIP SYNC 8-SOIC |
| TEA1762T/N2/DG,118 | IC CTLR SMPS SW SO14 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TC9404FN | 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:MODULATION SYSTEM DA CONVERTER WITH ANALOG FILTER |
| TC9404FNG | 制造商:Toshiba 功能描述:1Bit Cut Tape |
| TC9409BF | 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:SINGLE CHIP KARAOKE LSI |
| TC9411 | 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:CD GRAPHICS DECODER |
| TC9411F | 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:CD GRAPHICS DECODER |
發布緊急采購，3分鐘左右您將得到回復。