參數資料
型號： TC9400COD713
元件分類： 模擬專用變換器
英文描述： VOLTAGE-FREQUENCY CONVERTER, 0.1 MHz, PDSO14
封裝： SOIC-14
文件頁數： 6/28頁
文件大小： 545K
代理商： TC9400COD713
TC9400/9401/9402
DS21483D-page 14
2007 Microchip Technology Inc.
6.0
F/V CONVERTER DESIGN
INFORMATION
6.1
Input/Output Relationships
The output voltage is related to the input frequency
(FIN) by the transfer equation:
EQUATION 6-1:
The response time to a change in FIN is equal to (RINT
CINT). The amount of ripple on VOUT is inversely
proportional to CINT and the input frequency.
CINT can be increased to lower the ripple. Values of
1 F to 100 F are perfectly acceptable for low frequen-
cies.
When the TC9400 is used in the Single Supply mode,
VREF is defined as the voltage difference between Pin 7
and Pin 2.
6.2
Input Voltage Levels
The input frequency is applied to the Threshold
Detector input (Pin 11). As discussed in the V/F circuit
section of this data sheet, the threshold of Pin 11 is
approximately (VDD + VSS)/2 ±400 mV. Pin 11’s input
voltage range extends from VDD to about 2.5V below
the threshold. If the voltage on Pin 11 goes more than
2.5 volts below the threshold, the V/F mode start-up
comparator will turn on and corrupt the output voltage.
The Threshold Detector input has about 200 mV of
hysteresis.
In ±5V applications, the input voltage levels for the
TC9400 are ±400 mV, minimum. If the frequency
source being measured is unipolar, such as TTL or
CMOS operating from a +5V source, then an AC
coupled level shifter should be used. One such circuit
is shown in Figure 6-1(a).
The level shifter circuit in Figure 6-1(b) can be used in
single supply F/V applications. The resistor divider
ensures that the input threshold will track the supply
voltages. The diode clamp prevents the input from
going far enough in the negative direction to turn on the
start-up comparator. The diode’s forward voltage
decreases by 2.1 mV/°C, so for high ambient
temperature operation, two diodes in series are
recommended.
FIGURE 6-1:
Frequency Input Level Shifter.
VOUT = [VREF CREF RINT] FIN
+5V
14
64
+5V
-5V
VDD
1.0
11
33 k
Ω
IN914
VSS
DET
TC9400
(a) ±5V Supply
(b) Single Supply
0.01 F
Frequency
Input
0V
GND
+8V to +15V
14
10 k
Ω
4
+5V
VDD
1.0
11
33 k
Ω
IN914
VSS
DET
TC9400
0.01 F
Frequency
Input
0V
0.1 F 10 kΩ
M
Ω
M
Ω
相關PDF資料
PDF描述
TC9402EJD VOLTAGE-FREQUENCY CONVERTER, 0.1 MHz, CDIP14
TC9400EJD VOLTAGE-FREQUENCY CONVERTER, 0.1 MHz, CDIP14
TC9404FNG PARALLEL, WORD INPUT LOADING, 1-BIT DAC, PDSO24
TC9404FN SERIAL INPUT LOADING, 1-BIT DAC, PDSO24
TC9404F 1-BIT DAC, PDSO24
相關代理商/技術參數
參數描述
TC9400CPD 功能描述:電壓頻率轉換及頻率電壓轉換 V/F Converter RoHS:否 制造商:Texas Instruments 全標度頻率:4000 KHz 線性誤差:+/- 1 % FSR 電源電壓-最大: 電源電壓-最小: 最大工作溫度:+ 85 C 最小工作溫度:- 25 C 安裝風格:Through Hole 封裝 / 箱體:PDIP-14 封裝:Tube
TC9400CPD 制造商:Microchip Technology Inc 功能描述:IC F/V-V/F CONVERTER 9400 DIP14
TC9400CPD 制造商:Microchip Technology Inc 功能描述:IC F/V-V/F CONVERTER 9400 DIP14
TC9400EJD 功能描述:電壓頻率轉換及頻率電壓轉換 V/F Converter RoHS:否 制造商:Texas Instruments 全標度頻率:4000 KHz 線性誤差:+/- 1 % FSR 電源電壓-最大: 電源電壓-最小: 最大工作溫度:+ 85 C 最小工作溫度:- 25 C 安裝風格:Through Hole 封裝 / 箱體:PDIP-14 封裝:Tube
TC9400F 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:SIGMA-DELTA MODULATION SYSTEM DA CONVERTER WITH A BUILT-IN 8-TIMES OVER SAMPLING DIGITAL FILTER / DIGITALATTENUATOR
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*