- 您現在的位置：買賣IC網 > PDF目錄361412 > TC913A (TelCom Semiconductor, Inc.) DUAL AUTO-ZEROED OPERATIONAL AMPLIFIERS PDF資料下載
參數資料
| 型號： | TC913A |
| 廠商： | TelCom Semiconductor, Inc. |
| 英文描述： | DUAL AUTO-ZEROED OPERATIONAL AMPLIFIERS |
| 中文描述： | 雙自動歸零運算放大器 |
| 文件頁數： | 3/4頁 |
| 文件大小： | 48K |
| 代理商： | TC913A |
3-271
TELCOM SEMICONDUCTOR, INC.
7
6
5
4
3
1
2
8
DUAL AUTO-ZEROED
OPERATIONAL AMPLIFIERS
TC913A
TC913B
Theory of Operation
Each of the TC913's two op-amps actually consists of
two amplifiers. A main amplifier is always connected from
the input to the output. A separate nulling amplifier alter-
nately nulls its own offset and then the offset of the amplifier.
Since each amplifier is continuously being nulled, offset
voltage drift with time, temperature, and power supply
variations is greatly reduced.
All nulling circuitry is internal and the nulling operation is
transparent to the user. Offset nulling voltages are stored on
two internal capacitors. An internal oscillator and control
logic, shared by the TC913's two amplifiers, control the
nulling process.
Pin Compatibility
The TC913 pinout is compatible with OP-14, LM358,
MC1458, LT1013, TLC322, and similar dual op amps. In
many circuits operating from single or
±
5V supplies, the
TC913 is a drop-in replacement offering DC performance
rivaling that of the best single op amps.
The TC913's amplifiers include a low-impedance class
AB output buffer. Some previous CMOS chopper amplifiers
used a high-impedance output stage which made open-loop
gain dependent on load resistance. The TC913's open-loop
gain is not dependent on load resistance.
Overload Recovery
The TC913 recovers quickly from output saturation.
Typical recovery time from positive output saturation is
20msec. Negative output saturation recovery time is typi-
cally 5msec.
Avoiding Latch-Up
Junction-isolated CMOS circuits inherently contain a
parasitic p-n-p-n transistor circuit. Voltages exceeding the
supplies by 0.3V should not be applied to the device pins.
Larger voltages can turn the p-n-p-n device on, causing
excessive device power supply current and power dissipa-
tion. The TC913's power supplies should be established at
the same time or before input signals are applied. If this is
not possible, input current should be limited to 0.1mA to
avoid triggering the p-n-p-n structure.
相關PDF資料 |
PDF描述 |
|---|---|
| TC913ACPA | DUAL AUTO-ZEROED OPERATIONAL AMPLIFIERS |
| TC913BCPA | DUAL AUTO-ZEROED OPERATIONAL AMPLIFIERS |
| TC913BCOA | KPT 26C 26#20 SKT RECP |
| TC9401 | VOLTAGE-TO-FREQUENCY/FREQUENCY-TO-VOLTAGE CONVERTERS |
| TC9400EJD | SOCKET, 120 WAYSOCKET, 120 WAY; Ways, No. of:120; Colour:Grey; Contacts, No. of:120; Current rating:8.5A; Dielectric strength, VAC:1800V; Poles, No. of:120; Resistance, insulation:5000MR; Voltage, working:125V |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TC913A_06 | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:Dual Auto-Zeroed Operational Amplifiers |
| TC913A_13 | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:Dual Auto-Zeroed Operational Amplifiers |
| TC913ACOA | 功能描述:運算放大器 - 運放 Dual Low VOS w/Caps RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| TC913ACOA713 | 功能描述:運算放大器 - 運放 Dual Low VOS w/Caps RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| TC913ACPA | 功能描述:運算放大器 - 運放 Dual Low VOS w/Caps RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。