參數資料
型號: TC818ACBU
元件分類: ADC
英文描述: 1-CH DUAL-SLOPE ADC, PQFP64
封裝: PLASTIC, QFP-64
文件頁數: 13/24頁
文件大小: 528K
代理商: TC818ACBU
TC818A
DS21475C-page 20
2005 Microchip Technology Inc.
FIGURE 3-15:
R
Ω CALCULATION (200Ω
MANUAL OPERATION)
Where:
VANCOM = Potential at Analog Common ≈ 2.7V
RS
=220
Ω
RI
=163.85
Ω
RX
=300
Ω
RS
= Internal switch 33 resistance
≈ 600Ω
EQUATION 3-2:
For a 3.1V integrator swing, the value of R
ΩBUF is
easily calculated:
Where:
VINT
= Integrator swing = 3.1V
TI
= Integration time = 100msec
CI
= Integration capacitor = 0.1F
RXMAX
= 300
Ω
VXMAX
= 700mV
EQUATION 3-3:
With a low battery voltage of 6.6V, analog common will
be approximately 3.6V above the negative supply termi-
nal. With the integrator swinging down from analog com-
mon toward the negative supply, a 3.1V swing will set
the integrator output to 0.5V above the negative supply.
3.21
Capacitors - CINT, CAZ and CREF
The integration capacitor, CINT, must have low dielec-
tric absorption. A 0.1
μF polypropylene capacitor is sug-
gested. The auto-zero capacitor, CAZ, and reference
capacitor, CREF, should be selected for low leakage
and dielectric absorption. Polystyrene capacitors are
good choices.
3.22
Reference Voltage Adjustment
The TC818A contains a low temperature drift internal
voltage reference. The analog common potential
(Pin 29) is established by this reference. Maximum drift
is a low 75ppm/°C. Analog common is designed to be
approximately 2.6V below VCC (Pin 28). A resistive
divider (R18/R19, Functional Diagram) sets the
TC818A reference input voltage (REFHI, Pin 34) to
approximately 163.85mV.
With an input voltage near full scale on the 200mV
range, R19 is adjusted for the proper reading.
3.23
Display Hold Feature
The LCD will not be updated when HOLD (Pin 60) is
connected to GND (Pin 58). Conversions are made, but
the display is not updated. A HOLD mode LCD annun-
ciator is activated when HOLD is low.
The LCD HOLD annunciator is activated through the
triplex LCD driver signal at Pin 13.
3.24
Flat Package Socket
Sockets suitable for prototype work are available. A
USA source is:
Nepenthe Distribution
2471 East Bayshore, Suite 520
Palo Alto, CA 94303
(415) 856-9332
TWX: 910-373-2060
“CBQ” Socket, Part No. IC51-064-042
3.25
Resistive Ladder Networks
Resistor attenuator networks for voltage and resistance
measurements are available from:
Caddock Electronics
1717 Chicago Avenue
Riverside, CA 92507
Tel: (714) 788-1700
TWX: 910-332-6108
TABLE 3-6:
RESISTIVE LADDER
NETWORKS
163.85
Ω
220
Ω
300
Ω
RS ≈ 600Ω
SW33
R1
R2
R3
VX
Analog Common = VCC – 3V
VCC = 9V
R
ΩBUF =
(VCC – VANCOM)RX
(RX + RS + R1 + R8)
= 0.63V
R
ΩBUF =
VXMAX(TI)
CI(VINT)
= 200k
Ω
Attenuator
Accuracy
Attenuator Type
Caddock
Part Number
0.1%
Voltage
1776-C441
0.25%
Voltage
1776-C44
0.25%
Resistance
T1794-204-1
相關PDF資料
PDF描述
TC818ACBUTR 1-CH DUAL-SLOPE ADC, PQFP64
TC818DCOP CONVERTER SUBSYSTEM ADC, PARALLEL ACCESS, PDSO20
TC818ACBQ CONVERTER SUBSYSTEM ADC, PARALLEL ACCESS, PQFP60
TC820C/LW 1-CH 3-BIT DUAL-SLOPE ADC, PARALLEL ACCESS, PQCC44
TC820C/PL 1-CH 3-BIT DUAL-SLOPE ADC, PARALLEL ACCESS, PDIP40
相關代理商/技術參數
參數描述
TC-819-SC 制造商:Thomas & Betts 功能描述:
TC820 制造商:TELCOM 制造商全稱:TelCom Semiconductor, Inc 功能描述:3-3/4 DIGIT A/D CONVERTER WITH FREQUENCY COUNTER AND LOGIC PROBE
TC820CKW 功能描述:LCD 驅動器 3-3/4 A/D Converter RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube
TC820CKW713 功能描述:LCD 驅動器 3-3/4 A/D Converter RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube
TC820CLW 功能描述:LCD 驅動器 3-3/4 A/D Converter RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube