- 您現在的位置：買賣IC網 > PDF目錄98167 > TB7102AF(TE85L,F) SWITCHING REGULATOR, 1150 kHz SWITCHING FREQ-MAX, PDSO8 PDF資料下載
參數資料
| 型號： | TB7102AF(TE85L,F) |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING REGULATOR, 1150 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封裝： | 3 X 3 MM, 0.65 MM PITCH, PLASTIC, SON-8 |
| 文件頁數： | 14/17頁 |
| 文件大小： | 253K |
| 代理商： | TB7102AF(TE85L,F) |
TB7102AF
2009-10-26
6
Application Circuit Example
Figure 1 TB7102AF Application Circuit Example
Component values (@VIN = 5 V, VOUT = 3.3 V, Ta = 25°C)
These values are presented only as a guide.
CIN:
Input filter capacitor = 10
μF
(ceramic capacitor: GRM21BB30J106K from Murata Manufacturing Co., Ltd.)
COUT: Output filter capacitor = 10 μF
(ceramic capacitor: GRM21BB30J106K from Murata Manufacturing Co., Ltd.)
RFB1: Output voltage setting resistor = 7.5 kΩ
RFB2: Output voltage setting resistor = 2.4 kΩ
L:
Inductor = 3.3
μH (NP04SB3R3N from Taiyo Yuden Co., Ltd.)
Component values (@VIN = 5 V, VOUT = 1.2 V, Ta = 25°C)
These values are presented only as a guide.
CIN:
Input filter capacitor = 10
μF
(ceramic capacitor: GRM21BB30J106K from Murata Manufacturing Co., Ltd.)
COUT: Output filter capacitor = 22 μF
(ceramic capacitor: GRM31CB30J226K from Murata Manufacturing Co., Ltd.)
RFB1: Output voltage setting resistance = 1.2 kΩ
RFB2: Output voltage setting resistance = 2.4 kΩ
L:
Inductor = 3.3
μH (NP04SB3R3N from Taiyo Yuden Co., Ltd.)
Component values need to be adjusted, depending on the TB7102AF’s input/output conditions and the board layout.
Application Notes
Inductor Selection
The inductance required for inductor L can be calculated as follows:
IN
OUT
L
osc
OUT
IN
V
I
f
V
L
Δ
=
(1)
VIN:
Input voltage (V)
VOUT:
Output voltage (V)
fosc:
Oscillation frequency
= 1 MHz (typ.)
ΔIL:
Inductor ripple current (A)
*: Generally,
ΔIL should be set to approximately 30% of the maximum output current. Since the maximum output
current of the TB7102AF is 1 A,
ΔIL should be 0.3 A or so. Therefore, the inductor should have a current rating
greater than the peak output current of 1.15 A. If the inductor current rating is exceeded, the inductor becomes
saturated, leading to an unstable DC-DC converter operation.
When VIN = 5 V and VOUT = 3.3 V, the required inductance can be calculated as follows. Be sure to select an
appropriate inductor, taking the VIN range into account.
PGND
TB7102AF
SGND
GND
VOUT
R
FB2
R
FB1
LX
VFB
C
OUT
GND
VIN
C
IN
C
EN
VIN
L
相關PDF資料 |
PDF描述 |
|---|---|
| TB7102AF(TE85L,F) | SWITCHING REGULATOR, 1150 kHz SWITCHING FREQ-MAX, PDSO8 |
| TB7102F(TE85L,F) | SWITCHING REGULATOR, 1150 kHz SWITCHING FREQ-MAX, PDSO8 |
| TBA229-5 | FM, AUDIO DEMODULATOR, PDIP16 |
| TBB278B | SPECIALTY CONSUMER CIRCUIT, PDIP22 |
| TBB278B | SPECIALTY CONSUMER CIRCUIT, PDIP22 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TB7102F | 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:Step-down DC-DC Converter IC |
| TB7102F(TE85L,F) | 功能描述:直流/直流開關轉換器 Buck In=2.7 to 5.5V Out=Adj.V 1A RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| TB7106F | 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:Buck DC-DC Converter IC |
| TB7106F(T2LPP1,Q) | 功能描述:直流/直流開關轉換器 DC DC Converter IC 4.5 to 20V 0.18Ohm RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| TB7107FN | 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:Buck DC-DC Converter IC |
發布緊急采購，3分鐘左右您將得到回復。