- 您現在的位置：買賣IC網 > PDF目錄384949 > TB6556FG (Toshiba Corporation) 3-Phase Full-Wave Sine-Wave PWM Brushless Motor Controller PDF資料下載
參數資料
| 型號： | TB6556FG |
| 廠商： | Toshiba Corporation |
| 英文描述： | 3-Phase Full-Wave Sine-Wave PWM Brushless Motor Controller |
| 中文描述： | 三相全波正弦波脈寬調制無刷電機控制器 |
| 文件頁數： | 15/22頁 |
| 文件大小： | 305K |
| 代理商： | TB6556FG |
TB6556F/FG
2005-01-19
15
The modulation waveform is generated using Hall signals. The modulation waveform is then compared
with the triangular wave and a sine-wave PWM signal is generated.
The time (electrical degrees: 60°) from the rising (or falling) edges of the three Hall signals to the next
falling (or rising) edges is counted. The counted time is used as the data for the next 60° phase of the
modulation waveform.
There are 32 items of data for the 60° phase of the modulation waveform. The time width of one data
item is 1/32 of the time width of the 60° phase of the previous modulation waveform. The modulation
waveform moves forward by the width.
In the above diagram, the modulation waveform (1)’ data moves forward by the 1/32 time width of the
time (1) from HU:
↑
to HW:
↓
. Similarly, data (2)’ moves forward by the 1/32 time width of the time (2) from
HW:
↓
to HV:
↑
.
If the next edge does not occur after the 32 data items end, the next 32 data items move forward by the
same time width until the next edge occurs.
The modulation wave is brought into phase with every zero-cross point of the Hall signal.
The modulation wave is reset in synchronization with the rising and falling edges of the Hall signal at
every 60° electrical angle. Thus, when the Hall device is not placed at the correct position or during
acceleration and deceleration, the modulation waveform is not continuous at every reset.
*
t
S
V
(1)’
1
2
3
4
5
6
30
31
32
32
data items
*
t
=
t(1)
×
1/32
HU
HV
HW
S
U
S
V
Sw
⑤
②
⑥
①
③
⑥
’
①
’
②
’
③
’
*
HU, HV, HW: Hall signals
相關PDF資料 |
PDF描述 |
|---|---|
| TB6556F | 3-Phase Full-Wave Sine-Wave PWM Brushless Motor Controller |
| TB6581H | 3-Phase Full-Wave Sine-Wave PWM Brushless Motor Controller |
| TB8235 | 8-BIT CMOS MICROCONTROLLERS USERS MANUAL |
| TB8238 | 8-BIT CMOS MICROCONTROLLERS USERS MANUAL |
| TB9228 | 8-BIT CMOS MICROCONTROLLERS USERS MANUAL |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TB6556FG(EL,DRY) | 功能描述:馬達/運動/點火控制器和驅動器 BRUSHLESS DC MOTOR CONTROLLER 3-PHASE RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube |
| TB6556FG(O,EL,DRY) | 功能描述:馬達/運動/點火控制器和驅動器 3-Phase Full-Wave 12V Vcc=6V to 10V RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube |
| TB6556FG(O8,EL,DRY | 功能描述:馬達/運動/點火控制器和驅動器 3-phase PWM 252Hz 5V 30mA 6V to 10V RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube |
| TB6556FGELDRY | 功能描述:馬達/運動/點火控制器和驅動器 Brushless DC Motor Controller RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube |
| TB6557FLG(EL) | 功能描述:馬達/運動/點火控制器和驅動器 Combination Motor Driver RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。