- 您現在的位置：買賣IC網 > PDF目錄98155 > TA2012F AM/FM, AUDIO SINGLE CHIP RECEIVER, PDSO24 PDF資料下載
參數資料
| 型號： | TA2012F |
| 元件分類： | 接收器 |
| 英文描述： | AM/FM, AUDIO SINGLE CHIP RECEIVER, PDSO24 |
| 封裝： | SSOP-24 |
| 文件頁數： | 19/21頁 |
| 文件大?。?/td> | 1451K |
| 代理商： | TA2012F |
TA8132AN / AF , TA2012N / F
2002-10-30
7
Application Note
1. How to control the IF count output signal (pin(9) output)
TUN LED
ON
OFF
H
Come out
Non output
V8
L
Non output
Whether or not there is the IF count output signal (pin(9) output) is determined by the and of the pin(8)
control voltage: V8 and tuning LED on / off switching.
In the condition of
V8: High (active high, VTH = 0.8V (typ.))
TUN LED: ON (Vin ≥ VL+2dBV EMF (typ.))
the IF count output signal comes out from the pin(9).
In the case of the tuning LED function is not needed, it doesn't matter the pin(10) is opened.
The output impedance of pin(9) is 1.5k (typ.) (cf.P.4)
It is possible to reduce the IF count output signal level to add the resistance between the pin(9) and the VCC
line.
The signal waveform is the rectangular wave, and the level is 500mVp-p (typ.)
2. How to control the divider of FM IF
Switch
VCC: 10.7MHz output
GND or OPEN: 1.3375MHz output (1 / 8 dividing)
3. How to adjust the IF count output sensitivity
The IF count output sensitivity (search sensitivity)
Can be adjusted by varying the IF AMP gain for FM and varying the MIXER gain for AM.
This setting is made by changing the value of external resistance R2 which is connected to
pin(2).
However, this is only possible at the auto-tuning mode. (external voltage supplied to pin(8) is at high level.)
The original again returns while receiving a broadcast station (supplied voltage to pin(8) is at low level.)
相關PDF資料 |
PDF描述 |
|---|---|
| TA2012N | AM/FM, AUDIO SINGLE CHIP RECEIVER, PDIP24 |
| TA8155FG | 2 CHANNEL, AUDIO PREAMPLIFIER, PDSO24 |
| TA8155FNG | 2 CHANNEL, AUDIO PREAMPLIFIER, PDSO24 |
| TA8157AFN | 0.014 W, 3 CHANNEL, AUDIO AMPLIFIER, PDSO24 |
| TA8157AF | 0.014 W, 3 CHANNEL, AUDIO AMPLIFIER, PDSO24 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TA2012N | 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:3V AM / FM IF + MPX (For Digital Tuning System) |
| TA201416 | 制造商:POWEREX 制造商全稱:Powerex Power Semiconductors 功能描述:Phase Control SCR (1600-1800 Amperes Avg 100-2200 Volts) |
| TA201418 | 制造商:POWEREX 制造商全稱:Powerex Power Semiconductors 功能描述:Phase Control SCR (1600-1800 Amperes Avg 100-2200 Volts) |
| TA20141803DH | 功能描述:SCR PHASE CTRL 1400V 1800A RoHS:是 類別:半導體模塊 >> SCR 系列:- 其它有關文件:SCR Module Selection Guide 標準包裝:10 系列:- 結構:串聯 - SCR/二極管 SCR 數目，二極管:1 SCR，1 個二極管 電壓 - 斷路:1600V 電流 - 柵極觸發電流 (Igt)（最大）:150mA 電流 - 導通狀態 (It (AV))（最大）:95A 電流 - 導通狀態 (It (RMS))（最大）:210A 電流 - 非重復電涌，50、60Hz (Itsm):1785A，1870A 電流 - 維持(Ih):250mA 安裝類型:底座安裝 封裝/外殼:ADD-A-PAK（3 + 2） 包裝:散裝 其它名稱:*IRKL92/16AIRKL92/16IRKL92/16-ND |
| TA2015FN | 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:RIPPLE FILTER (1.5V USE) |
發布緊急采購，3分鐘左右您將得到回復。