
TA1276AF
2002-01-29
50
Test Conditions (unless otherwise stated, VCC1 = 5 V, VCC2/VCC3/DEF VCC = 9 V, Ta = 25 ± 3°C)
Subaddress
Switching Mode
Note
Parameter
07
10
17
18
SW5
SW6
SW13
SW15
Test Conditions
C5
NTSC Ident Sensitivity
↑
C0
or
D0
00
↑
B
↑
1)
Input a 3.58-NTSC rainbow (C-4 signal) burst/chroma signal with the same
burst/chroma amplitudes to the chroma input pin (TP54).
2)
Observe the BUS READ mode (5
th and 6th bits of the 1st byte).
3)
Switch the Indent sensitivity (set the subaddress (10) data low (C0) and high (D0))
and perform the following measurements.
4)
Increase the input signal amplitude from 0 and measure the input signal amplitude
at the switch to 3.58 NTSC mode.
(LOW (C0): vNCL, High (D0): vNCH)
5)
Lower the input signal amplitude from 100 mVp-p and measure the input signal
amplitude at the deviation from 3.58 NTSC mode.
(LOW (C0): vNBL, High (D0): vNBH)
C6
PAL Ident Sensitivity
80
C0
or
D0
00
OPEN
B
A
1)
Input a 4.43-PAL rainbow (C-4 signal) burst/chroma signal with the same
burst/chroma amplitude to the chroma input pin (TP54).
2)
Observe the BUS READ mode (5
th and 6th bits of the 1st byte).
3)
Switch the Indent sensitivity (set the subaddress (10) data low (C0) and high (D0))
and perform the following measurements.
4)
Increase the input signal amplitude from 0 and measure the input signal amplitude
at the switch to 4.43 PAL mode.
(LOW (C0): vPCL, High (D0): vPCH)
5)
Lower the input signal amplitude from 100 mVp-p and measure the input signal
amplitude at the deviation from 4.43 PAL mode.
(LOW (C0): vPBL, High (D0): vPBH)
C7
TOF Characteristics
↑
00
or
60
↑
38
↑
1)
Input the signal C-1 to the chroma input pin (TP54).
(signal amplitude
= 50 mVp-p).
2)
When the subaddress (10) data are f0 = 3.58 MHz (00) and f0 = 4.43 MHz (60), and
subaddress (18) data are (38), connect 1.5 k
between the VI output pin 6 and the
5 V-VCC and observe the VI output pin 64.
3)
Measure the output amplitude when f0 = 3.58 MHz and calculate the gain in
decibels from the input (GFC3).
4)
Measure the output amplitude when f0 = 3.58 MHz ± 500 kHz and calculate the
gain in decibels from the input
(
+500 kHz: GFH3, 500 kHz: GFL3).
5)
Measure the output amplitude when f0 = 4.43 MHz and calculate the gain in
decibels from the input (GFC4).
6)
Measure the output amplitude when f0 = 4.43 MHz ± 500 kHz and calculate the
gain in decibels from the input
(
+500 kHz: GFH4, 500 kHz: GFL4).