
2
PI49FCT807T
Fast CMOS Clock Driver
PS7008G
11/25/09
Notes:
1. For Max. or Min. conditions, use appropriate value specied under Electrical Characteristics for the applicable device type.
2. Typical values are at Vcc = 5.0V, +25°C ambient and maximum loading.
3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second.
4. This parameter is determined by device characterization but is not production tested.
Storage Temperature .......................................................... –65°C to +150°C
Ambient Temperature with Power Applied ..........................-40°C to +85°C
Supply Voltage to Ground Potential (Inputs & VCC Only)... –0.5V to +7.0V
Supply Voltage to Ground Potential (Outputs & D/O Only) –0.5V to +7.0V
DC Input Voltage .................................................................. –0.5V to +7.0V
DC Output Current............................................................................. 120mA
Power Dissipation ................................................................................. 0.5W
Note:
Stresses greater than those listed under MAXIMUM RAT-
INGS may cause permanent damage to the device. This is
a stress rating only and functional operation of the device
at these or any other conditions above those indicated in the
operational sections of this specication is not implied. Ex-
posure to absolute maximum rating conditions for extended
periods may affect reliability.
Maximum Ratings
(Above which the useful life may be impaired. For user guidelines, not tested.)
Parameters
Description
Test Conditions(1)
Min
Typ(2)
Max
Units
VOH
Output HIGH Voltage
VCC=Min., VIN = VIH or VIL IOH = –15.0mA
2.4
3.3
V
VOL
Output LOW Current
VCC=Min., VIN = VIH or VIL IOL= 48.0mA
0.2
0.5
V
IOL = 12mA
0.2
V
VIH
Input HIGH Voltage
Guaranteed Logic HIGH Level
2.0
V
VIL
Input LOW Voltage
Guaranteed Logic LOW Level
0.8
V
IIH
Input HIGH Current
VCC = Max.
VIN = 2.7V
1
μA
IIL
Input LOW Current
VCC = Max.
VIN = 0.5V
-1
μA
II
Input HIGH Current
VCC = Max., VIN =VCC (Max.)
20
μA
VIK
Clamp Diode Voltage
VCC = Min., IIN = –18mA
-60
-0.7
-1.2
V
IOS
Short Circuit Current
VCC = Max.(3), VOUT = GND
-120
mA
IOFF
Power Down Disable
VCC= GND, VOUT = 4.5V
100
μA
VH
Input Hysteresis
150
mV
Capacitance (TA = 25°C, f = 1 MHz)
Parameters(4)
Description
Test Conditions
Typ
Max
Units
CIN
Input Capacitance
VIN = 0V
6.0
10
pF
COUT
Output Capacitance
VOUT = 0V
8
12
pF
DC Electrical Characteristics (Over the Operating Range, TA = 40°C to +85°C, VCC = 5.0V ±5%)
09-0006