參數資料
型號: STV6404E-001
廠商: 意法半導體
英文描述: Mono and Colour Digital Video CMOS Image Sensors
中文描述: 莫諾和數字視頻彩色CMOS圖像傳感器
文件頁數: 5/54頁
文件大小: 786K
代理商: STV6404E-001
VV5404 & VV6404
CD5404-6404F-A
5/54
1. Fast QCK: the falling edge of the clock qualifies the nibble data irrespective of whether it is the most or the least
significant nibble.
2. Slow QCK: the rising edge of the clock qualifies the most significant nibbles while the falling edge of the clock
qualifies the least significant nibbles.
The FST can be enabled/disabled via the serial interface.
OEB tri-states all 4 databus lines, D[3:0], the qualification clock, QCK and the frame start signal, FST.
There are 3 main ways of interfacing to the VV5404 or VV6404 sensor based on the above signals:
1. The processor capturing the data (or colour co-processor for VV6404) supplies the sensor clock, CKI, and uses
the embedded control sequences to synchronise with the frame and line level timings. Thus the processor and
sensor are running off derivatives of the same fundamental clock (4 fsc - 14.31818 MHz). To allow the receiver
to determine the best sampling position of the video data, during its power-up sequence the sensor outputs a
101010... sequence on each of its databus lines for the video processor to lock on to.
2. The video processor uses a free-running QCK supplied by the sensor to sample the incoming video data
stream. The embedded control sequences are used to synchronise the frame and line level timings. A crystal is
used to generate the clock for the sensor.
3. The video processor uses FST and the data only mode for QCK to synchronise to the incoming video data. Pri-
marily intended for interfacing to frame grabbers.
The 2-wire serial interface provides complete control over how the sensor is setup and run. Exposure and gain values
are programmed via this interface. Section 5. defines the communications protocol and the register map of all the
locations which can be accessed via the serial interface.
Using the first two interface options outlined above it is possible to control the sensor and receive video data via a 9-
wire cable between the sensor and the video processor/colour-processor.
1. A 4-wire data bus (D[3:0]) for sending both video data and embedded timing references.
2. A 2-wire serial interface (SDA,SCL).
3. The clock for the sensor or QCK from the sensor.
4. VCC and GND power lines.
The various image read-out and frame rate options are detailed in Sections 2 and 3 respectively.
Figure 2 : Interfacing Options
SDA
SCL
D[3:0]
CLKI
Sensor
Colour
Co-processor
(processor)
SDA
SCL
D[3:0]
QCK
Sensor
Colour
Co-processor
(processor)
FST
相關PDF資料
PDF描述
STV5730 Advanced FM Audio Play-Back and Record Amplifier For VCR(用于VCR,收費電視和衛星接收器的多標準熒幕顯示)
STV6436 Filtered Video Buffers for STB and DVD Devices
STV6436D Filtered Video Buffers for STB and DVD Devices
STV6436S Filtered Video Buffers for STB and DVD Devices
STV6688 Video Switch Matrix for TV Applications with S Terminal
相關代理商/技術參數
參數描述
STV6407 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Graphic/Video Support Circuit
STV6408 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:VIDEO MATRIX
STV6410 制造商:未知廠家 制造商全稱:未知廠家 功能描述:TV Switch Circuit
STV-6410/6500-E01 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Mono and Colour Digital Video CMOS Image Sensors
STV6410A 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:AUDIO/VIDEO SWITCH MATRIX