參數資料
型號: STPM01
廠商: Electronic Theatre Controls, Inc.
英文描述: PROGRAMMABLE SINGLE PHASE ENERGY METERING IC WITH TAMPER DETECTION
中文描述: 可編程單相電能計量IC篡改檢測
文件頁數: 1/9頁
文件大?。?/td> 137K
代理商: STPM01
1/9
September 2004
I
INTEGRATED LINEAR VREGS TO SUPPLY
THE DIGITAL AND ANALOG CORES
ADVANCED BICMOS TECHNOLOGY FOR
HIGH PERFORMANCE
OTP FOR CALIBRATION AND
CONFIGURATION
INTEGRATED OSCILLATOR WITH
EXTERNAL RESISTOR OR CRYSTAL
MONITOR BOTH LIVE AND NEUTRAL FOR
TAMPER DETECTION
SIGMA DELTA 1
st
ORDER CONVERTER
POWER SUPPLY CURRENT LESS THAN
6mA
SUPPORT 50 ÷ 60 Hz – IEC 62052-11,
IEC 62053-2X SPECIFICATION FOR CLASS
0.5 AC WATT METERS
PRECISION VOLTAGE REFERENCE ON
CHIP: 1.25 V AND 30 ppm/°C MAX
TSSOP20 PACKAGE
I
I
I
I
I
I
I
I
I
DESCRIPTION
The
STPM01
measurement of active energy in a power line
system using the Rogowski and/or Shunt
principle. This device can be implemented as a
single chip 1-phase energy meter or as a
peripheral measurement in a microprocessor
based 1-phase or 3-phase energy meter.
The STPM01 consists, essentially, of two parts:
the analog part and the digital part. The former, is
composed by preamplifier and 1
st
order
Σ
D AD
converter blocks, Bandgap voltage reference,
Lowdrop voltage regulator and a pair of DC buffer,
the latter, is composed by system control, clock
generator, hard wired DSP and SPI interface.
There is also a OTP block, which is controlled
is
designed
for
effective
through the SPI by means of a dedicated
command set. The configured bits are used for
testing, configuration and calibration purpose.
From a pair of
Σ
D output signals coming from
analog section, a DSP unit computes the amount
of consummated active, reactive and apparent
energy, RMS values of voltage and current value.
The results of computation are available as pulse
frequency and states on the digital outputs of the
device or as data bits in a data stream, which can
be read from the device by means of SPI
interface. This system bus interface is used also
during production testing of the device and/or for
temporary or permanent programming of bits of
internal OTP.
In the STPM01 the calibration is very easy: an
output signal with pulse frequency proportional to
energy is generated, this signal is used to enable
the calibration of the energy meter.
When the device is fully configured and calibrated,
a dedicated bit of OTP block, can be written
permanently in order to prevent accidental
entering into some test mode or changing any
configuration.
Table 1: Order Codes
Type
Temperature
Range
Package
Comments
STPM01
-40 to 85 °C
TSSOP20 (Tape & Reel)
2500 parts per reel
STPM01
PROGRAMMABLE SINGLE PHASE ENERGY METERING
IC WITH TAMPER DETECTION
This is preliminary information on a new product now in development or undergoing evaluation. Details are subject to change without notice.
TSSOP
PRELIMINARY DATA
Rev. 1
相關PDF資料
PDF描述
STPR806D Ultra Fast Recovery Diodes
STPRF1605CT SUPER FAST GLASS PASSIVATED RECTIFIERS
STPRF1605CT 16A SUPER-FAST GLASS PASSIVATED RECTIFIER
STPRF1610CT 16A SUPER-FAST GLASS PASSIVATED RECTIFIER
STPRF1615CT 16A SUPER-FAST GLASS PASSIVATED RECTIFIER
相關代理商/技術參數
參數描述
STPM01_11 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Programmable single phase energy metering IC with tamper detection
STPM01FTR 功能描述:電流和電力監控器、調節器 Programmable 1-phase Energy Metering RoHS:否 制造商:STMicroelectronics 產品:Current Regulators 電源電壓-最大:48 V 電源電壓-最小:5.5 V 工作溫度范圍:- 40 C to + 150 C 安裝風格:SMD/SMT 封裝 / 箱體:HPSO-8 封裝:Reel
STPM10 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Programmable single-phase energy metering IC with tamper detection
STPM10BTR 功能描述:電流和電力監控器、調節器 Programmable single phase energy meter RoHS:否 制造商:STMicroelectronics 產品:Current Regulators 電源電壓-最大:48 V 電源電壓-最小:5.5 V 工作溫度范圍:- 40 C to + 150 C 安裝風格:SMD/SMT 封裝 / 箱體:HPSO-8 封裝:Reel
STPM11 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Single phase energy metering IC with pulsed output and digital calibration