- 您現在的位置：買賣IC網 > PDF目錄382560 > STHS2375A (意法半導體) IEEE 802.3af PoE Powered Device (PD) Interface Controller(IEEE802.3af PoE PD(受電設備)接口控制器) PDF資料下載
參數資料
| 型號： | STHS2375A |
| 廠商： | 意法半導體 |
| 英文描述： | IEEE 802.3af PoE Powered Device (PD) Interface Controller(IEEE802.3af PoE PD(受電設備)接口控制器) |
| 中文描述： | IEEE 802.3af標準的PoE供電設備（PD）接口控制器（IEEE802.3af標準的PoE（私隱受電設備）接口控制器） |
| 文件頁數： | 7/20頁 |
| 文件大?。?/td> | 187K |
| 代理商： | STHS2375A |
STHS237x
Summary description
7/20
1.1
Pin descriptions
1.1.1
Current limit (I
LIM
)
Connect a resistor between I
LIM
and V
SS
to set the start-up inrush current limit.
I
LIM
= 25 000/R
ILIM
[A
]
. Practical values of R
ILIM
are between 62.5k
Ω
and 500k
Ω
.
R
ILIM
= 178k
Ω
for inrush current of 140mA for compatibility with legacy PSEs. Do not leave
open or connect to V
SS
.
1.1.2
Classification (CLASS)
Connect a Classification resistor between this pin and V
SS
to tell the PSE which power class
will be connected. Do not connect this pin directly to V
SS
.
For classification resistor values, see
Table 3 on page 8
.
1.1.3
Detection resistor (DET)
Connect a 24.9k
Ω
resistor between DET and V
DD
to allow the PSE to detect the Powered
Device properly.
1.1.4
Ground (V
SS
)
This is the return power line on the PSE side (negative).
1.1.5
Return (RTN)
This is the return power output on the load side, negative rail.
1.1.6
Power Good output (PG)
This pin indicates that the STHS power MOSFET is fully on and works in normal operation
mode (Power Good). Open drain, high impedance means that the power is good; in all other
cases, the impedance is low (referenced to RTN).
1.1.7
Undervoltage Lockout Input (UVLO, STHS2376A/L only)
Connect the tap of the resistor divider between V
DD
and V
SS
to set the UVLO voltage limits
(see
Figure 6 on page 10
).
Note:
STHS2376A/L only, for all other devices, this is No Connect.
1.1.8
Power supply (V
DD
)
This is the Power Input/Output, positive rail.
相關PDF資料 |
PDF描述 |
|---|---|
| STHS2375L | IEEE 802.3af PoE Powered Device (PD) Interface Controller(IEEE802.3af PoE PD(受電設備)接口控制器) |
| STHS2376A | IEEE 802.3af PoE Powered Device (PD) Interface Controller(IEEE802.3af PoE PD(受電設備)接口控制器) |
| STHS2376L | IEEE 802.3af PoE Powered Device (PD) Interface Controller(IEEE802.3af PoE PD(受電設備)接口控制器) |
| STHS2377A | IEEE 802.3af PoE Powered Device (PD) Interface Controller(IEEE802.3af PoE PD(受電設備)接口控制器) |
| STHS2377L | IEEE 802.3af PoE Powered Device (PD) Interface Controller(IEEE802.3af PoE PD(受電設備)接口控制器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| STHS2375ADW6E | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:IEEE 802.3af PoE Powered Device (PD) interface controller |
| STHS2375ADW6F | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:IEEE 802.3af PoE Powered Device (PD) interface controller |
| STHS2375AM6E | 功能描述:熱插拔功率分布 IEEE 802.3af PD Interface RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| STHS2375AM6F | 功能描述:開關變換器、穩壓器與控制器 STHS2375A STHS2375L RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel |
| STHS2375L | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:IEEE 802.3af PoE Powered Device (PD) interface controller |
發布緊急采購，3分鐘左右您將得到回復。