- 您現在的位置：買賣IC網 > PDF目錄384931 > ST16C450CJ44 (EXAR CORP) UNIVERSAL ASYNCHRONOUS RECEIVER/TRANSMITTER (UART) PDF資料下載
參數資料
| 型號： | ST16C450CJ44 |
| 廠商： | EXAR CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | UNIVERSAL ASYNCHRONOUS RECEIVER/TRANSMITTER (UART) |
| 中文描述： | 1 CHANNEL(S), 1.5M bps, SERIAL COMM CONTROLLER, PQCC44 |
| 封裝： | PLASTIC, LCC-44 |
| 文件頁數： | 10/28頁 |
| 文件大?。?/td> | 182K |
| 代理商： | ST16C450CJ44 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
ST16C450
10
Rev. 4.20
Figure 3, EXTERNAL CRYSTAL OSCILLATOR
CONNECTION
Loopback Mode
The internal loop-back capability allows onboard diag-
nostics. In the loop-back mode the normal modem
interface pins are disconnected and reconfigured for
loop-back internally. In this mode MSR bits 4-7 are
also disconnected. However, MCR register bits 0-3
can be used for controlling loop-back diagnostic test-
ing. In the loop-back mode -OP1 and -OP2 in the MCR
register (bits 0-1) control the modem -RI and -CD
inputs respectively. MCR signals -DTR and -RTS (bits
0-1) are used to control the modem -CTS and -DSR
inputs respectively. The transmitter output (TX) and
the receiver input (RX) are disconnected from their
associated interface pins, and instead are connected
together internally (See Figure 4). The -CTS, -DSR, -CD,
and -RI are disconnected from their normal modem
control inputs pins, and instead are connected inter-
nally to -DTR, -RTS, -OP1 and -OP2. Loop-back test
data is entered into the transmit holding register via the
user data bus interface, D0-D7. The transmit UART
serializes the data and passes the serial data to the
receive UART via the nternal oop-back connection. The
receive UART converts the serial data back into parallel
data that is then made available at the user data
interface, D0-D7. The user optionally compares the
received data to the initial transmitted data for verifying
error free operation of the UART TX/RX circuits.
In this mode , the receiver and transmitter interrupts are
fully operational. The Modem Control Interrupts are also
operational. However, the interrupts can only be read
using lower four bits of the Modem Control Register
(MCR bits 0-3) instead of the four Modem Status
Register bits 4-7. The interrupts are still controlled by
the IER.
C1
22pF
C2
33pF
X1
1.8432 MHz
R1
50-120
R2
1M
X
X
相關PDF資料 |
PDF描述 |
|---|---|
| ST16C450CP40 | UNIVERSAL ASYNCHRONOUS RECEIVER/TRANSMITTER (UART) |
| ST16C450CQ48 | UNIVERSAL ASYNCHRONOUS RECEIVER/TRANSMITTER (UART) |
| ST16C450IJ44 | UNIVERSAL ASYNCHRONOUS RECEIVER/TRANSMITTER (UART) |
| ST16C450IP40 | UNIVERSAL ASYNCHRONOUS RECEIVER/TRANSMITTER (UART) |
| ST16C450IQ48 | UNIVERSAL ASYNCHRONOUS RECEIVER/TRANSMITTER (UART) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ST16C450CJ44-F | 功能描述:UART 接口集成電路 SINGLE UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| ST16C450CJ44TR | 制造商:Rochester Electronics LLC 功能描述: 制造商:Exar Corporation 功能描述: |
| ST16C450CJ44TRF | 制造商:EXAR 功能描述:NEW |
| ST16C450CJ44TR-F | 功能描述:UART 接口集成電路 SINGLE UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| ST16C450CP40 | 功能描述:UART 接口集成電路 SINGLE UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。