- 您現在的位置：買賣IC網 > PDF目錄383836 > ST16C1550 (Exar Corporation) 2.97V TO 5.5V UART WITH 16-BYTE FIFO PDF資料下載
參數資料
| 型號： | ST16C1550 |
| 廠商： | Exar Corporation |
| 英文描述： | 2.97V TO 5.5V UART WITH 16-BYTE FIFO |
| 中文描述： | 2.97V至5.5V的UART具有16字節FIFO |
| 文件頁數： | 12/37頁 |
| 文件大?。?/td> | 428K |
| 代理商： | ST16C1550 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁
ST16C1550/51
2.97V TO 5.5V UART WITH 16-BYTE FIFO
á
REV. 4.2.0
12
2.7
The 155X supports the standard features of the ST16C550. In addition the 155X supports some enhanced
features not available for the ST16C550. These features are enabled by IER bit-5 and include a software
controllable (SOFT) reset, power down feature and FIFO monitoring bits.
2.7.1
Soft Reset
Soft resets are useful when the user desires the capability of resetting an externally connected device only.
MCR bit-2 can be used to initiate a SOFT reset at the RST output pin. This does not reset the 155X (only the
RESET input pin can reset the 155X). Soft resets from MCR bit-2 are “ORed” with the RESET input pin.
Therefore both reset types will be seen at the RST output pin.
2.7.2
Power Down Mode
The power down feature (controlled by MCR bit-7) provides the user with the capability to conserve power
when the package is not in actual use without destroying internal register configuration data. This allows quick
turnarounds from power down to normal operation.
2.7.3
TXRDY and RXRDY bits
When IER bit-5 is set to a logic 1, ISR bits 4 and 5 represent the compliment (inversion) of the TXRDY status
and RXRDY status, respectively. See
Table 1
.
2.8
Internal Loopback
The 155X UART provides an internal loopback capability for system diagnostic purposes. The internal
loopback mode
is enabled by setting MCR register bit-4 to logic 1. All regular UART functions operate normally.
Figure 7
shows how the modem port signals are re-configured. Transmit data from the transmit shift register
output is internally routed to the receive shift register input allowing the system to receive the same data that it
was sending. The TX pin is held at logic 1 or mark condition while RTS# and DTR# are de-asserted, and
CTS#, DSR# CD# and RI# inputs are ignored. Caution: the RX input must be held to a logic 1 during loopback
test else upon exiting the loopback test the UART may detect and report a false “break” signal.
Special (Enhanced Feature) Mode
F
IGURE
6. R
ECEIVER
O
PERATION
IN
NON
-FIFO M
ODE
Receive Data Shift
Register (RSR)
Receive
Data Byte
and Errors
RHR Interrupt (ISR bit-2)
Receive Data
Holding Register
(RHR)
RXFIFO1
16X Clock
Receive Data Characters
Data Bit
Validation
Error
Tags in
LSR bits
4:2
相關PDF資料 |
PDF描述 |
|---|---|
| ST16C1550CJ28 | 2.97V TO 5.5V UART WITH 16-BYTE FIFO |
| ST16C1550CP28 | 2.97V TO 5.5V UART WITH 16-BYTE FIFO |
| ST16C1550CQ48 | 2.97V TO 5.5V UART WITH 16-BYTE FIFO |
| ST16C1550IJ28 | 2.97V TO 5.5V UART WITH 16-BYTE FIFO |
| ST16C1550IP28 | 2.97V TO 5.5V UART WITH 16-BYTE FIFO |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ST16C1550_05 | 制造商:EXAR 制造商全稱:EXAR 功能描述:2.97V TO 5.5V UART WITH 16-BYTE FIFO |
| ST16C1550CJ28 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Exar Corporation 功能描述: |
| ST16C1550CJ28-F | 功能描述:UART 接口集成電路 UART W/16BYTE FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| ST16C1550CJ28-F | 制造商:Exar Corporation 功能描述:IC SGL UART 1.5MBPS 5.5V 28-PLCC |
| ST16C1550CJ28TR-F | 功能描述:UART 接口集成電路 UART W/16BYTE FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。