- 您現在的位置：買賣IC網 > PDF目錄10403 > SSM2304CPZ-REEL (Analog Devices Inc)IC AMP AUDIO 2.4W STER D 16LFCSP PDF資料下載
參數資料
| 型號： | SSM2304CPZ-REEL |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 8/20頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC AMP AUDIO 2.4W STER D 16LFCSP |
| 標準包裝： | 5,000 |
| 類型： | D 類 |
| 輸出類型： | 2 通道（立體聲） |
| 在某負載時最大輸出功率 x 通道數量： | 2.4W x 2 @ 4 歐姆 |
| 電源電壓： | 2.5 V ~ 5 V |
| 特點： | 消除爆音，差分輸入，短路和熱保護，關閉 |
| 安裝類型： | 表面貼裝 |
| 供應商設備封裝： | 16-LFCSP-VQ |
| 封裝/外殼： | 16-VFQFN 裸露焊盤，CSP |
| 包裝： | 帶卷 (TR) |
| 配用： | SSM2304Z-EVAL-ND - EVAL BOARD FOR SSM2304Z |
SSM2304
Rev. 0 | Page 16 of 20
061
62
-0
73
When differential mode audio signals are used as the input
signal source, either use Headers 3HD1 and 3HD2 or the
soldering pads located on the left side of the board and turn
Switches S1E and S1F to the off position (lower position). The
top header is for the left channel signals and the lower is for the
right channel signals. There are two ground soldering pads on
the lower left corner.
The lower side of the board has a switch bank and its corres-
ponding channels are listed in Table 5
Table 5. Switch Channels
Switch Name
Corresponding Channel
S1A
Left positive
S1B
Left negative
S1C
Right negative
S1D
Right positive
Figure 44. Bottom Layers
When the switches listed in Table 5 are placed in the upper
positions, their corresponding coupling capacitors are shorted;
when the switches are placed in the lower positions, the coupling
capacitors are inserted in the signal paths.
061
62
-0
74
As previously described, Switches S1E and S1F are used to ac
short circuit the left and right channel negative input ports to
ground, respectively. This function is only needed when driving
the input ports in single-ended mode. After shortening the
negative input ports to ground, the noise picked up by the input
port connections will be conducted to the ground.
S1G is not connected for the SSM2304.
S1H controls the shutdown function. The upper position shuts
down the amplifier, and the lower position turns on the amplifier.
The upper right corner has a dc power jack connector. The
center pin is for the positive terminal. It is compatible with 3 V
to 5 V voltage, and the maximum peak current is approximately
1.2 A when driving a 4 Ω load (for SSM2304 only) and 0.6 A
when driving an 8 Ω load with an input voltage of 5 V.
Figure 45. Mirrored Bottom Layers
On the upper left corner of the schematic shown in Figure 46,
there is an audio stereo jack connector (3.5 mm), J1. This jack is
compatible with standard stereo audio signals. It uses a
conventional audio stereo signal connector/cable to obtain
audio signals from common appliances, such as DVD players,
personal computers, TVs, and so on. Because this connector
only provides single-ended audio signals, turn Switches S1E and
S1F to the upper positions when this input connector is utilized
to ac short circuit the negative input ports to ground (see the
schematic in Figure 46).
There are two solder pads in the upper center edge area for
connecting the power supply voltages by clipping or soldering.
All the output ports are located on the right side of the board
and marked with the corresponding names. Please see the legend
There are three ways to connect the output signals to the loads
(the loudspeakers): using the four 2-pin headers, the terminal
block, or the soldering pads.
相關PDF資料 |
PDF描述 |
|---|---|
| SSM2319CBZ-REEL | IC AMP AUDIO 3.7W MONO D 9WLCSP |
| LLA219R71C683MA01L | CAP CER 0.068UF 16V 20% X7R 0805 |
| MS27497T10F99SB | CONN RCPT 7POS WALL MNT W/SCKT |
| LLA219R71E333MA01L | CAP CER 0.033UF 25V 20% X7R 0805 |
| VI-2WN-IW-F1 | CONVERTER MOD DC/DC 18.5V 100W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SSM2304CPZ-REEL7 | 功能描述:IC AMP AUDIO 2.4W STER D 16LFCSP RoHS:是 類別:集成電路 (IC) >> 線性 - 音頻放大器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:DirectDrive® 類型:D 類 輸出類型:1-通道（單聲道），帶立體聲耳機 在某負載時最大輸出功率 x 通道數量:930mW x 1 @ 8 歐姆; 40mW x 2 @ 16 歐姆 電源電壓:2.7 V ~ 5.5 V 特點:消除爆音，差分輸入，I²C，靜音，關閉，音量控制 安裝類型:表面貼裝 供應商設備封裝:25-WLP（2.09x2.09） 封裝/外殼:25-WFBGA，WLCSP 包裝:帶卷 (TR) 其它名稱:MAX97000EWA+T-ND |
| SSM2304N | 制造商:SSC 制造商全稱:Silicon Standard Corp. 功能描述:N-CHANNEL ENHANCEMENT-MODE POWER MOSFET |
| SSM2304Z-EVAL | 功能描述:EVAL BOARD FOR SSM2304Z RoHS:否 類別:編程器，開發系統 >> 評估板 - 音頻放大器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- |
| SSM2305 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Filterless High Efficiency Mono 2.8 W Class-D Audio Amplifier |
| SSM2305AGN | 制造商:SSC 制造商全稱:Silicon Standard Corp. 功能描述:P-channel Enhancement-mode Power MOSFET |
發布緊急采購，3分鐘左右您將得到回復。