- 您現在的位置：買賣IC網 > PDF目錄9995 > SP503CM-L (Exar Corporation)IC TXRX MULTIPROTOCOL 80LQFP PDF資料下載
參數資料
| 型號： | SP503CM-L |
| 廠商： | Exar Corporation |
| 文件頁數： | 28/28頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC TXRX MULTIPROTOCOL 80LQFP |
| 標準包裝： | 84 |
| 類型： | 收發器 |
| 驅動器/接收器數： | 7/7 |
| 規程： | 多協議 |
| 電源電壓： | 5V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 80-LQFP |
| 供應商設備封裝： | 80-LQFP（14x14） |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁當前第28頁
9
SP503_101_101508
SP503 Multiprotocol Transceiver
Copyright 2008 Exar Corporation
Figure 3. Charge Pump Waveforms
+10V
GND
–10V
C
2
+
C
2
–
a)
b)
VCC = +5V
–10V
VSS Storage Capacitor
VDD Storage Capacitor
C1
C2
C3
C4
+
++
–
Figure 2. Charge Pump Phase 2.
and RS-423 drivers. For the RS-232 driver, the
current requirement will be 3.5mA per driver,
and for the RS-423 driver, the worst case current
drain will be 11mA per driver. The external
power supplies should provide a power supply
sequence of : +l0V, then +5V, followed by –l0V.
Drivers
The SP503 has seven (7) independent drivers,
two of which have separate active–low tri–state
controls. If a half-duplex channel is required,
this can be achieved with external connections.
Control for the mode selection is done via a
four–bit control word. The SP503 does not have
a latch; the control word must be externally
latched either high or low to write the appropri-
ate code into the SP503. The drivers are pre-
arranged such that for each mode of operation
the relative position and functionality of the
drivers are set up to accommodate the selected
interface mode. As the mode of the drivers is
changed, the electrical characteristics will change
to support the requirements of clock, data, and
control line signal levels. Table 1 shows a sum-
mary of the electrical characteristics of the driv-
ers in the different interface modes. Unused
driver inputs can be left floating; however, to
ensure a desired state with no input signal, pull–
up resistors to +5V or pull–down resistors to
ground are suggested. Since the driver inputs
are both TTL or CMOS compatible, any value
resistor less than 100k
will suffice.
simultaneously with this, the positive side of
capacitor C
1 is switched to +5V and the negative
side is connected to ground, and the cycle be-
gins again.
Since both V+ and V– are separately generated
from V
CC in a no–load condition, V+ and V
– will
be symmetrical. Older charge pump approaches
that generate V– from V+ will show a decrease
in the magnitude of V– compared to V+ due to
the inherent inefficiencies in the design.
The clock rate for the charge pump typically
operates at 15kHz. The external capacitors must
be 22F with a 16V breakdown rating.
External Power Supplies
For applications that do not require +5V only,
external supplies can be applied at the V+ and
V– pins. The value of the external supply volt-
ages must be no greater than ±l0V. The current
drain for the ±10V supplies is used for RS-232,
相關PDF資料 |
PDF描述 |
|---|---|
| ISL26310FBZ | IC ADC 12BIT SPI/SRL 125K 8SOIC |
| IDT72V243L6BCG | IC FIFO 2048X18 6NS 100BGA |
| MS27473E16A35SA | CONN PLUG 55POS STRAIGHT W/SCKT |
| MS27473T18F11P | CONN PLUG 11POS STRAIGHT W/PINS |
| XRT7300IVTR-F | IC LIU E3/DS3/STS-1 SGL 44TQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SP503EB | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:Application Note |
| SP503EF | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:Multiprotocol Transceiver |
| SP503EF-L | 制造商:Exar Corporation 功能描述:IC TRANSCEIVER MULTI MODE MQFP80 制造商:Exar Corporation 功能描述:IC, TRANSCEIVER, MULTI MODE, MQFP80 |
| SP503EM | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:Multiprotocol Transceiver |
| SP503EM-L | 功能描述:總線收發器 Full Duplex RS-485 s RoHS:否 制造商:Fairchild Semiconductor 邏輯類型:CMOS 邏輯系列:74VCX 每芯片的通道數量:16 輸入電平:CMOS 輸出電平:CMOS 輸出類型:3-State 高電平輸出電流:- 24 mA 低電平輸出電流:24 mA 傳播延遲時間:6.2 ns 電源電壓-最大:2.7 V, 3.6 V 電源電壓-最小:1.65 V, 2.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TSSOP-48 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。